The Swedish building and property management sector are responsible for about 30 % of the total energy use. In order to take environmental consideration, different environmental assessment tools and standards are used. Miljo?byggnad, Svanen, FEBY12 and PHI are some of these. There has been increased interest to certify buildings and therefore it is of interest to evaluate the assessment of the energy field to see if relevant energy aspects are assessed.

Background: Energy drinks have been found in everyday-stores since 1997 and their popularity have increased over time. Consumtion of energy drinks takes place because of their ability to increase concentration and to decrease fatigue but also because of the popularity the drinks have got. Target groups for these stimulating beverages are adolescents and young adults. Energy drinks contain caffeine, taurine, glucuronolacton, carbohydrates and B-vitamins and voices have been raised about the eligibility for young people to ingest large quantities of these kinds of substances. Because of the properties of these substances it has become popular to mix energy drinks and alcoholic beverages to make up for the negative effects of alcohol and to be able to drink larger quantaties.Aim: The aim of this literature work was to investigate cognitive effects of the combination of caffeine in terms of energy drinks and alcohol and to determine if these effects could be harmful.Method: This literature work is based on five scientific articles retrieved from PubMed.

Abstract The extraction and usage of energy give rise to immense environmental problems which helps to accelerate climate change. Energy is an important resource for the community and there are a variety of different types of energy sources available, that are either classified as renewable or non-renewable energy sources. The usage of renewable energy sources cause less environmental impact than the usage of non-renewable energy, which in turn means that the energy?s strain on the environment is strongly affected by the type of energy source used.The aim of the study is to describe to what extent attitudes towards renewable energy are affected by whether the individual is male or female, by examining the hypothesis regarding how women have a closer connection to nature and to a larger extent shows on an pro-environmentally friendly behavior than men, and if it also can be detected on issues related to renewable energy and thus imply that women have a friendlier approach towards renewable energy than men. A number of ecofeminist believe that women have a stronger bond with the nature through her embodiment as a woman and by her maternal role, which according to previous research also leads to the fact that women shows on a more extensive environmental behavior.Through a qualitative research method in the form of semi-structured interviews has three female and three male respondents been asked questions with regards to the environment, individual responsibility and energy.

The society strives for sustainable development, in the construction industry it is expressed through sustainable building. Energy and LCC analyzes increases the ability to make conscious decisions in the process. A problem in the construction industry is that energy and LCC analysis is not used to the desired extent, as they are perceived as complicated and time consuming. The report aims to achieve a more sustainable building through increased use of energy and LCC analyzes.The goal is to show how BIM can be used to improve the efficiency of the energy and LCC analyzes.The study was conducted with a literature review and a case study to answer which information that is required in a BIM model to perform energy and LCC analyzes. The study also shows which software can be used in BIM based energy and LCC analyzes and how the analyzes can be carried out efficiently.The result shows that effective analyzes may be performed if the BIM-model contains the relevant information for making analyzes.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production.The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with thenmeasured time of usage.

The purpose of this thesis was to make an energy survey and quantify energy flows of individual unit operations associated with the biogas production in Uppsala Vatten och Avfall AB:s biogas plant, located at Kungsängens gård. Moreover, large consumers of energy would be identified and analyzed. The objective of this energy survey was to obtain a detailed understanding of the energy use in the biogas production. The energy survey was divided into two parts: electricity and heat. Each part was treated separately and with somewhat different approach. To estimate the electricity usage during the projcet the rated power of each selected unit operation was noted and multplied with the measured time of usage.

There is always a need for more effective ways to store energy in order to reduce the human impact on the environment. One step on the way can be the use of flywheels as kinetic Energy storage devices. Low frictional losses are essential for a flywheel to be effective. To minimize these losses active magnetic bearings (AMB) can be used to keep the shaft centered instead of the more conventional ball-bearings. AMBs use actuators and a fast control system that needs correct and noise-free measurement data of the shaft position and the current in the actuators to work properly.This thesis explains the process of constructing power electronics and a current measurement system for active magnetic bearings (AMB).

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

Today 70 percent of the people residing in nursing homes are undernourished. One way to avoid that an individual is affected by malnutrition it is a necessity that the meals is customized after special needs current among other things as energy and protein. Food record is a method that can be used to examine and evaluate if an individual is getting sufficient nutrition and energy to cover the daily needs. For those suffering from malnutrition it is recommended to eat energy and protein enriched diet.AimsThe aim is to compare the intake of energy and macronutrients in a group of elderly people living in a nursing home in southern Sweden before and after the introduction of an energy and protein enriched diet based on newly developed recipes.MethodsFood record was made during four days. Food record means that everything that is consumed by an individual is noted precisely.

This diploma work addresses the question of how much energy is spent whenmanufacturing the components of a building as well as of how much energy is used inthe production of a building. The object of the studies is BioCentrum at the SwedishUniversity of Agricultural Sciences in Ultuna just outside the city of Uppsala. The aimof the work was to investigate how much energy was consumed when manufacturingand production in relation to the management, how many years the production wasrepresented. It was also a study in how mature the construction industry is to answerhow much energy was consumed in manufacturing.In order to get these answers a question form was developed and sent to thesuppliers to BioCentrum. In this form they were to respond to the quantity suppliedto BioCentrum and the amount of energy was spent when manufacturing thecomponents.

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

The aim of the study was to compare productivity in first thinning of birch stands, when either energy- or pulpwood was harvested. The systems total profitability was also compared by including forwarding and chipping costs. A Gremo 950 HPVR harvester was used and the same driver was used under the entire study. During the pulpwood harvest a Logmax 4000b harvester head was used and a feller buncher head made by Silvatec was used during the energy wood harvest. Six study unit pairs were located in a birch dominated stand outside Ängelholm in Skåne.

The use of bio energy in Sweden has increased during the last few years and with every passing year, bio energy produces 3-4 TWh´s more energy than the previous year. The increase in the use of bio energy makes it an interesting prospect for forest companies to produce bio energy from the forest. Sveaskog has a fairly extensive bio energy programme, mainly in southern and middle Sweden. Their activity regarding bio energy in northern Sweden has been very restrictive or even non-existent. Because of this, during the winter of 2003-2004, Sveaskog initiated a number of degree projects with the purpose of looking at the use of bio energy in northern Sweden.

With new energy directives in place, the Swedish Social Service (SSS) stands beforethe challenge how to reduce the energy demand in its locales. It is a complex matter,as the locales are rented from various property owners and it becomes a question ofhow to reduce the operational electricity and influence the property owners to workmore with energy efficiency. This thesis takes a balanced research approach in threeparts. Firstly a qualitative part in form of interviews with personnel at the SSS and itsproperty owners, secondly a quantitative part of descriptive nature in form of energystatistics and thirdly a literature review of Energy Management (EM) Supply ChainManagement(SCM), Green Supply Chain Management(GSCM) and EnviromentalPerformance Indicators (EPI). This in order to be able to give normativerecommendations of how the SSS should act to reduce its energy consumption in itslocales and provide new insights on how EM, SCM, GSCM and EPI can be applied ineffect.

The Swedish Government has set a target to reduce energy consumption through energy efficiency within the construction and real estate sector. The purpose of the study is to examine how energy efficiency within this sector could affect the district heating volume in the future, on basis of Vattenfalls district heating system in Uppsala.An Excel model has been created to study how energy effficiency measures affects district heating demand in buildings by 2045, based on technical and economicalconditions. Furthermore, an interview study has been conducted to examine incentives for district heating customers to invest in energy efficiency measures.Result of the Excel model shows that the district heating volume of Vattenfall in 2045 is expected to 931 GWh, which corresponds to a volume decrease of 10,6 %. Based on the study?s theoretical framework only 15 %, 1 024 GWh, of the technical-economical potential is assumed to be implemented.