The aim of this study about wind power planning in forest was to examine the factors and restrictions, which represent technical limitations, biodiversity, tourism and amount of energy for wind farms in Kronoberg County. Suitable areas for wind power were identified from the collected information about planning principles and potential conflicts. From the suitable areas the potential energy gain is calculated. Methods used were mainly a literature review, interviews with experts and practitioners, GIS analysis and a rough calculation of the energy gain. The section of information and facts describes in general wind power planning and possible conflicts.

Biogas is increasingly used for fuel in for example vehicles and it´s produced in a biogas processconsisting of the steps of pretreatment, digestion and gas cleaning. The pretreatment is a method usedto increase the gas production and / or destroy pathogens. The digestion is the stage when anaerobicmicroorganisms convert bio-mass of a substrate to a raw gas containing about 65% of methane. Thegas cleaning is used to increase the methane content to about 97% so the gas can be used for motors invehicles. The biogas part of the Ekeby sewage plant in Eskilstuna is using multiple substrates.

Within all industries, there is a change in working time required; this also includes the construction sector. However, the way construction sectors are differentiated is by not having been given the opportunity to be practiced or tested.  The aim of this thesis that we have done in collaboration with the Concrete Industry was to investigate the possibility of developing an automated method for quality assurance of SKB at the site. The idea is to make the O-funnel to be more utilized and therefore ensuring that the appropriate concrete quality is provided which eventually would lead to a better development in the production process.The project has involved theoretical work and laboratory experiments. The theoretical work gave us a good foundation at the beginning of the project. After gathering the information and material, the laboratory experiments began by SCC in their laboratory in Hammarby. The collected data from the various laboratory tests formed the foundation for trying to relate measurements for consistency of SCC with each other and therefore find out how measurements from O-funnel varies with different concrete mixtures.

The Swedish energy companies have several different systems for data collection of the energy consumption of their clients. Often computerized remote meter readers are put in practice in order to register the energy consumption of large companies. The majority of household clients, however, are read off by the assistance of manual methods. Household power consumption is read off once a year. As a result, these clients are not debited for their actual consumption; their invoices during the year are the result of estimations. At times when the electricity supply system is highly loaded, electricity is more expensive.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

The objective of this study was to get a better understanding of how the cultivation methods influence the vitality in Prunus avium. The purpose was also to examine if there was any differences in shoot growth and trunk expansion depending on the method of cultivation. To find the answer to this question a literature study and a case study has been done. The literature study concerns the concepts vitality and stress. Different definitions of these concepts are shown and their connection whit establishment is explained. In the background the species Prunus avium, and the four method of cultivation that are included in this case study are described. Measurements of the shoot growth and trunk expansion were made in this study, and as a complement to these methods, a visual estimate of the vitality was made.

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

The use of energy is an important question in today´s society, and a substantial part of the energy that is used today is used in our homes. To lower this usage is vital, and there are regulations in place both on the national and the local level, that say that new apartment blocks must be built to consume less energy, which in the end will lower the impact on the climate.One way to make the housing sector more environmentally sustainable, is to produce energy issions that are bad for the environment, for example to build wind turbines close to or even on the buildings, so called urban wind power. The scope for this report is to see if urban wind power could be a sustainable alternative for the residential area that Svenska Bostäder plans to build in Albano in Stockholm.There are extensive scientific theories regarding wind and wind power, and a literature study is made to investigate past knowledge in the area. Efforts have been made to find earlier trials with urban wind power and, both scientific research and trials where urban wind power actually has been installed. The theory chapter deals both with the wind itself and how electricity can be generated from wind.

In recent years it has become more and more evident that man has contributed to much of the climate changes that have taken place during the last century. A major challenge today is to reduce emissions and energy usage at the same time as the global population is growing. To contribute to a better environment, Stockholms Stad has set at target of becoming fossil fuel free by the year of 2050. The construction of new districts is done with this goal in mind; energy efficiency and renewable energy sources are examples of methods to achieve this.Solar energy is considered to be a sustainable energy source and the most common techniques to harvest solar energy in Sweden are solar cells and solar collectors which produce electricity and heat respectively. This report aims to investigate whether an investment in any of these systems would prove to be economically beneficial at Kvarnholmen, a district under construction in eastern Nacka, Stockholm.Since the finished blueprints only cover a small portion of Kvarnholmen, the report examines the possibilities for a house where construction has already begun, Nya Kvarnen.

Mechanical ventilation is the most common type ofventilation in newly constructed office buildings. Therehas been an interest to utilize natural ventilationinstead of mechanical ventilation among architects andHVAC consultants in recent years. This is due to thesize of mechanical ventilation systems, which arespace consuming. The mechanical ventilation system isalso complex and requires maintenance. Furthermore,the fan uses a considerable amount of energy.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

Compressed air is a low efficiency media, and is thus very expensive to produce. This thesis work began by mind mapping how to create savings on the compressed air system at Billerud Skärblacka AB. Certain issues have been chosen for further studies.In order to identify the consumption of compressed air at PM 8 and 9, several measurements were made. At PM 8 there were not found any pressure drop, only large pressure variations for short periods of time. The causes of these pressure variations were not established.

The purpose of this study is to investigate how much of the estimated annual electric energy production from Swedish wind power that actually was produced, as well as the history of this agreement over time. The aim is to also examine if there are properties that have caused some group of wind power plants to produce more or less, compared to their estimated production. Operational data on wind turbines collected by the Swedish Energy Agency was analyzed. A survey was made among owners of wind power plants with a nominal power of at least 2 MW. Two different methods for normal year correction of production data were used and compared.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.