På uppdrag av Sweco Systems i Umeå har detta examensarbete utförts under våren 2013. Syftet var att undersöka huruvida något av de energiberäknings-program som används på företaget kan anses vara lämpligt vid energikartläggningar av befintliga fastigheter.Inledningsvis utfördes en energikartläggning av fastigheten Odin 12 i Umeå, som i huvudsak utgörs av gallerian MVG. Med resultaten från denna energikartläggning som grund beräknades därefter fastighetens energianvändning i två olika program ? VIP-Energy och IDA Indoor Climate and Energy.Resultaten från den inledande kartläggningen visar att fastigheten har ett lågt behov av fjärrvärme, vilket förklaras av fastighetens höga elförbrukning. Den stora användningen av el genererar stora mängder internvärme som, förutom att sänka fjärrvärmebehovet, även medför att fastigheten under hela året har ett kylbehov.Utvärderingen av de två beräkningsprogrammen visar att VIP-Energy är ett lämpligt program att använda vid energikartläggningar.

An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

This study concerns the energy future of the county of Stockholm up until 2050 and describes how the energy consumption can be compared to today with the use of scenario methodology. Within energy future studies the backcasting approach is well known and has been put to use in this study. Due to the characteristics of backcasting the study is self-fulfilling, i.e. the future energy scenarios presented in this study satisfy the targets set up in this study. In the light of what may be the largest challenge of our time ? the climate change - the aim of this study is to describe how the energy consumption in a fossil fuel free Stockholm county in the year of 2050 may be.

AbstractThis is a study of present day dogs with the purpose to establish a method to investigate archaeological dogs and determine their use in the past. The study has focused on measurements of five bone elements, scapula, humerus, radius, ulna and femur. A principal component analysis has been applied in order to decide which measurements to be further used in the analysis. Different proportions have been calculated on these measurements.A test to try the method has also been done on bones of a wolf and a dog without known background. The results from the different elements are positive, and they narrow the field down to two dog types of which one is more likely to be true than the other.The final results show that, although over lapses between the four different dog groups; hunting dogs, guard/work dogs, sled dogs and shepherd's dogs exists, it is possible to distinguish different dog usage from the proportions of the bones..

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

During the work at Gateway Security AB in Motala I began examining available antenna models to get a wider perspective, this have given knowledge of their structure, and an understanding of their function. All my necessary fact is based on my observations and notes of these measurings. New antenna models, and available models were examined where measurements at different heights and different distances on the antenna were performed with the help of an oscilloscope and a measure probe, peak ? to - peak was brought on the signal. The measurements are presented in a line diagram.

As the Swedish governments long term goals include a reduction of fossil fuel dependency, increasing pressure is placed upon energy companies to create and develop new solutions for renewable energy. The following case study was done in collaboration with the company Sydved Energileveranser AB and one of their contractors, Enarssons Skogsentreprenad AB. The objective of the study is to examine the bioenergy situation in region of Skåne and evaluate the potential solutions in the region for a forest-fuel assortment, based on a bioenergy-cutting-system. As a part of this study I have compared ordinary manual cuttings done with a chain saw and cuttings made using the new ?bio- energy cutting system?. The cuttings made under both systems were tested in areas near agricultural fields or pasture land in order to maintain an open landscape.

Overall aim of this master?s thesis is to describe and identify perceived barriers in Swedish businesses within solar energy field and analyze, based on four theoretical viewpoints, how these barriers can be handled. In other words how can the barriers be overcome or eliminated to better succeed in the commercialization process? The method applied is qualitative in which data has been collected through phone interviews originated from seven Cleantech businesses which operate within solar energy. Furthermore this thesis has a descriptive- and an explorative purpose.

The industrial sector accounts for a large share of greenhouse gas emissions. To reduce its negative impact on the environment is crucial in the quest for a sustainable future. In discussions of the industrial sector's impact on the environment guidelines have been highlighted as a tool to assist the industries in their efforts to change the relationship between the consumption of energy and production. This by improving energy efficiency and a shift to the best available technology. During the past 30 years the steel industry has reduced its energy consumption per ton of steel produced by 50 percent.

Norconsult AB has developed a solarhousing concept, a house designed for the warm climate in the Middle East andwith large quantities of solar panels installed. The cooling system for the house was designed in an earlier report, the purpose of this thesis is to investigate the possibility of short and long term storage of thermal energy via an underground energy storage volume.Two different designs of the storage and three different filling materials have been integrated into a model to simulate different cases. The first design consisted of pipes installed in the ground, without insulation. The second design consisted of an insulated concrete box installed to prevent thermal energy from the surrounding soil to flow towards the lower temperature regions within the storage. The three different filling materials were dry saudi sand, water saturated saudi sand and the filling material used by the client for energy storage in Sweden.The results from the simulations show that neither of the designs, regardless of the filling material, managed to extract enough thermal energy from the house to the ground to uphold the demands of indoor climate.

Food is widely consumed and in 2011 an average American devoured approximately one ton of food. The production of these goods requires large amounts of energy and contributes to 22-31 % of all greenhouse gas emissions occurring in Europe. More than one third of the produced food is discarded instead of consumed, and food waste make up about 30 % of the waste generated by households. 60 % of this food waste could be avoided if the eatables were handled in a better way.Avoidable food waste arises partly because residues from food are not taken care of, and because the food is not stored in a way that optimise its durability. Residues arises part- ly because of the contradictory and complex demands of everyday life and are, because of our busy lifestyle, difficult to avoid.

An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

This thesis consider alternatives for heating and cooling planned office buildings at Arlanda airport. The thesis is divided into three parts where the third part is a shorter synthesis of the two first. In the first part the energy demands of the buildings are modelled in a computer program. Two different building models are created, one more conventional and one with good energy properties. The results shows that with proper construction and ventilation systems etc.

Considering that the price and demand for energy gradually has risen over the past decade and a wider discussion about the human impact on the environment has become increasingly more important and given a clearer role in modern society. This has contributed to increased incentives to reduce the use of fossil fuels and increase the use of renewable energy.The agriculture currently accounts for 20 % of Sweden's total greenhouse gas emissions. A way for an agricultural company like Wapnö AB to reduce their emissions could be to utilize existing renewable energy sources within their own premises.The report's aim is to create an energy audit of Wapnö?s existing energy system and how it changes with a future biogas plant in operation. The energy audit is used to illustrate how the company?s climate footprint could change.

X-ray fluorescence (XRF) detection of heavy metals is a cost- and time-effective method for investigation of polluted areas. Compared to laboratory analysis, XRF analysis is limited by high detection limits and uncertainties in some situations. Preparation of samples is known to affect the results of measurements.The purpose of this thesis is to bring a deeper understanding of how different factors affect the results of XRF-analysis. A large number of measurements have been made with the instruments Niton XLt 700 and Niton Xli 700. Results from measurements of lead, zinc and copper have been analysed.This study has shown that a greater moisture content will give a lower measured concentration for the same sample.