ABSTRACTThe discussions about energy use have increased year by year everywhere in the society, and so also in the healthcare sector. But what is actually energy use in a hospital facility, and what affects it?The typical way today to express the energy use is in kWh/m2. The problem with a key performance indicator that is expressed as energy use in relation to a specific area is that it does not take into account the activity in the building. Even though the activity to a very high extent affects the energy use.

Abstrakt -  As energy prices rise, energy-saving in buildings is becoming increasingly important. By applying different construction and installation technologies, to new buildings the energy consumption can be reduced effectively, compared to similar existing buildings. These technical measures are often an investment in the long term and will reduce energy costs significantly. The purpose of this report is to show how to reduce energy consumption in a small house. It is presented in this report that both building's technical saving arrangements (the sealing of a building) and an installation technical arrangement (changing from the F-system to the FTX-system) would reduce energy consumption in newly built detached houses, if compared with a similar existing house but without these technical measures. The report presents also detailed calculations showing how much energy an existing 2-storey house, built in the year 2007 in Eskilstuna, consumes and how much energy would be saved if these corrective measures were applied to a new building. It is also reported how much money would be saved each year over a 10 year period if the measures were applied. The results show that both solutions are a good investment in the reduction of energy consumption and hence the cost involved. Keywords: energy, heat energy, infiltration, FTX-system, free temperature effectively. .

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

The Baltic Sea, due to its special conditions, is a unique and vulnerable marine environment. There are many pressures that have an impact on the sea and one of the major problems is the extensive flow of nutrients from land. The most visible effect of the supply of nutrients is the annual algal blooms. One of the main sources of nitrogen and phosphorus supply is agriculture. Nutrient losses from arable land have been increasing as agricultural production has intensified. At the end of the twentieth century an increased awareness of these problems led to the formation of organizations such as HELCOM and Baltic 21.

Grubbe Ventilation AB is a sheet metal and ventilation company who provides design, installation, service, and repair of ventilation. The company is expanding their business by building a new facility in Umeå, Västerbotten. The property is designed to be used for both office and industrial work.Grubbe Ventelation AB has not yet decided upon wish system which is to be established to provide the building with heating and cooling. The consulting firm Umeå Projekt Team has therefore been asked to investigate the possibilities to invest in geothermal- heating and cooling.If the investigation of a geothermal heating- and cooling system would provide favorable results it would be a very appropriate alternative that provides energy at low costs and are an environmentally friendly option as the energy comes from stored solar energy in the ground is provided by stored solar energy in the ground.The facility ´s heating and cooling consumptions are calculated in the program BV2 and the result indicate a heating demand of 185 000 kWh per year due to thermal transmittance, transmission losses, heating of warm water and a cooling requirement of 5500 kWh.Three different systems of geothermal heating and cooling were tested in the computer program Energy Earth Design. The results show no difference in the dimensioning of the drill hole if merely heating were to be used or both heating and cooling were to be established.

Today?s electrical grid companies understand that better knowledge of and information about their grid can help realize a smart grid network. One way to gain better knowledge and information about the low voltage network is to install measuring equipment on the substation transformer´s secondary low voltage side that measures the low voltage network losses for that specific substation. By doing so, grid companies can, due to the calculation of the low voltage network losses, identify and address issues such as illegal power dissipation, unmeasured power outtakes, and unsatisfied technical documentation for the substations low voltage network.During 2012, Mälarenergi Elnät AB had a total electrical network loss (both medium and low voltage network losses included) of three to four percent of their total distributed electrical volume. Converting this energy volume into a monetary figure this accounts for a loss of around 30 million Swedish crowns.

Pre-workout (PWO) is one, fast-growing, supplement on the market that promise fat burning, bigger muscels and energy and by buying these expensive supplements, you can get your dreambody faster than others. This study is mainly about researching why people use PWO and what experiences they have about using these supplements. By using a qualitative method I have found out that the participants mainly uses PWO to get energy and focus. This study also shows that my participants thinks that there is a difference in energy between using and not using PWO..

This thesis investigates how energy is used in three public baths today and suggests measures that could reduce the energy demand. The results show that there is a great poteltial for energy savings i public baths, and that it would be interesting to examine some of the proposed measures further..

In 2011 the International Accounting Standards Board issued amendments to IAS 19 Employee Benefits. The new standard is effective from January 1st 2013 and one of the largest changes in the standard is the elimination of the corridor method. Through the corridor method companies had the possibility to defer actuarial gains and losses resulting from their defined benefit obligations (pension obligations) and leave them unrecognized off the balance sheet. According to the new standard companies reporting under International Financial Reporting Standards will have to recognize all actuarial gains and losses immediately in other comprehensive income. The aim of this thesis is to examine how the financial key ratios of Swedish listed companies will be affected by the elimination of the corridor method.

Environmental impact and management of energy is a highly topical issue in today's society. Climate impact must be reduced. The Government has set a target to reduce energy consumption in buildings by 20 % by 2020 and 50 % by 2050 compared to the energy use in 1995.With this in mind, we chose to examine how property owners can work on improving energy efficiency in existing apartment buildings. We also wanted to investigate profitability of different increasing energy efficiency measures and the calculation methods and the risk assessment performed by such investments. To tie in with government objectives, we also saw the possibilities of achieving these goals.20 companies were interviewed, of which 14 were property owners and 6 were consulting firms that works with energy efficiency.

Vattenfall Heat Uppsala runs the waste incineration plant in Uppsala, which produces district heating, process steam, district cooling and electricity. Vattenfall Heat Uppsala has decided to introduce an energy management system with the aim to increase the energy efficiency of the plant. The basis in such a system is to make an energy mapping.In this thesis an energy mapping has been performed at the waste incineration plant with the aim to identify and determine the size of energy flows. The investigated energy flows are used fuel, produced and used steam, produced district heating and cooling. Also the use of electricity to run the processes has been investigated.

Mål - Att spara 1 GWh underhållsenergi på Karlshamsverket.Metod - Att lokalisera de största energisänkorna på kraftverket, göra mätningar eller uppskattningar på hur mycket energi dessa förbrukar, för att där efter ge förslag på tekniska åtgärder, med tillhörande ekonomiska beräkningar som ska reducera energiförbrukningen..

Volvo Trucks is the second largest manufacturer of heavy trucks, with factories in several countries and with around 21 000 employees. At the plant in Tuve, trucks have been built since 1982 and the activity mainly consists of producing side members and to assemble and packing kits of trucks. In 2005, the factory in Tuve launched the ambition to be the first carbon dioxide neutral vehicle factory in the world. This will be implemented by streamlining and investing in renewable energy. The aim of this degree thesis is to map the usage of energy within production, and also to prepare a method to measure key figures (use of energy per produced unit).

Every year new premises are built in Sweden, and even if they are made as energy efficient as possible, this will not reduce the energy demands, but the rate of the increase of the energy use will be reduced. One type of facility in Sweden that is a major energy user is public baths, and this makes public baths an interesting facility to study more closely. There are around 500 public baths in Sweden and about 75 % of those can be seen as older baths with large need of renovation, and they all require a high level of energy efficiency measures. To show how the energy demand increase or decrease depending on the changes chosen to be made, the simulation application IDA Indoor Climate and Energy was used. Simulations were made and compared for several cases, with two extreme cases as starting points.