Modern technology and fast development of heat pumps, the hunt for savings in energy consumption and the strive for environmentally friendly energy sources, convenience, and financial profit, have made heat pumps a reasonable alternative for the heating of houses.When the heat pump starts it will consume a considerable amount of current, which may result in a short-lived voltage-drop if the power grid is weak compared to the start-up current.The company Fortum Distribution which owns and administrates electrical network is interested in an investigation that deals with heat pumps affect on the quality of electricity.The purpose of this investigation is to study fast electrical fluctuations (flicker) as a result of start-up currents for single as well as multiple heat pumps on the same electrical station and from this evaluate whether there will be any problems installing heat pumps..

Today all buildings contain some form of home automation. It might be heating controlled by athermostat or motion detectors controlling outdoor lighting.This paper,The Intelligent House, deals with the planning of a house in Kiruna, in the north ofSweden and further immerses itself in home automation or intelligent control in single-familyhomes. The house has been entirely planned, from layout to structural design and plumbing.The purpose of the paper has been to investigate the possibilities in home automation in singlefamilyhomes and to choose a suitable home automation system for the house being planned.The system has been designed and the costs and energy savings have been calculated.The system chosen for the house is called KNX and is the largest system for home automation inSweden. It is used to control heating, ventilation, lighting and alarm systems in the house. Is hasbeen found that KNX is very expensive and that the amount of energy, possible to save in thehouse, using the system, is relatively small.

Genom att studera olika kommunikationsprotokoll kunna svara på vad det är som gör att ett visst protokoll är bäst anpassat för att användas mellan mobila enheter och IoT-enheter.I arbetet användes en kvalitativ litteraturstudie för att ge en grundlig teoretisk bakgrund samt en experimentell studie där ett par teorier undersökts ifall de stämmer med resultaten ifrån verkligheten. De fem faktorerna kompatibilitet, batteritid, frekvens, räckvidd och tillförlitlighet undersöktes hos kommunikationsprotokollen Bluetooth Low Energy (BLE), Närfältskommunikation (NFC) och Wi-Fi. Dessa tre valdes eftersom de stöds av nyare mobila plattformar idag. Kommunikations-protokollen analyserades sedan gentemot olika användningsområden inom IoT, eftersom påståendet vad som är bäst anpassat beror på vad situationen kräver för egenskaper.En systemutvecklare som ska välja kommunikationsprotokoll till en IoT-tillämpning och läser denna rapport bör själv jämföra de olika protokollen mot varandra inom de fem faktorerna för att kunna avgöra vilket protokoll som passar bäst inom dennes situation. I arbetet utfördes endast experimentella studier på BLE på grund av begränsningar inom utrustningen.

Constantly growing demands from the costumers in the Automotive industry forces the subcontractors to seek alternative ways to compete. One parameter of quality is the components tolerance against NVH(Noise, Vibraion & Harshness) aspects. Kongsbergs Automotive has developed a new gear shifter platform (Shift-by-Wire) that is sold to Alfa Romeo and used in of their car models. However, the company is not pleased with the components sound quality, therefore the main purpose of this thesis is to develope a number of concepts that is supposed to enhance these NVH-aspects.To get an understanding of the problem an analysis of the causes of the emitted sound has been done parallell to a product decomposition, function decomposition and a Ishikawa-diagram. Together with these methods has a litterature study been performed to get familiar with the physics of an impact and especially the emittment of noise.

Cooling down the indoor air can be done in several ways. One way is desiccantcooling which will be used at the Stockholm Arena. This method is used in airhandling units that use temperature changes and moisture fluctuations in the air. Oneof the steps is to add heat during the cooling process in order to reduce the relativehumidity of the exhaust air. The air passes thru an adsorptions rotor which thenabsorbs moisture from the supply air.

Increased resource efficiency in an energy system could result in large economic and environmental benefits. Tekniska verken i Linköping AB (Tekniska verken) is responsible for the district heating network in Linköping. Their vision is to create the world?s most resource efficient region. An important step towards this vision is more efficient usage of produced heat, something which could be achieved through integration of a seasonal heat storage in the energy system.

In this thesis, the Train Power System Simulator (TPSS) has been compared and verified with the commercial simulator TracFeed® Simulation (TracFeed). The basis for the comparison was a given part of the Swedish railway system, with steel transportation trains. Primarily, emphasis was placed on running time and energy consumption in simulation results. Two transformer systems were analyzed, booster and auto transformers. The high voltage transmission line, parallel to the railroad track, was disconnected in some simulations.

The exhaust arrangement on a Scania V8 consists of one manifold at each bank connected to a twin entry turbine (8-2-2). A study in GT-Power has shown improved performance and reduced cylinder to cylinder variations using two manifolds at each bank in combination with a single entry turbine (8-4-1). This thesis work analyses the difference in performance shown in simulation and verify it by engine test.The initial work was focused on simulation in GT-Power. Investigating how exhaust manifold volume and pulses effects the turbine efficiency and the mean effective pressure during the gas exchange. To verify GT-Power simulations four engine tests with different exhaust arrangement have been made.The results from GT-Power simulation indicate that a larger exhaust volume improve the turbine efficiency.

The guest harbor on Utö, Utö Gästhamn, is currently using electricity for heating all of the water used in the showers and taps. Because of the large amount of visitors, especially during the summer months, the hot water usage gets very high and that is also the case for the electrical bills. During the year of 2011 the cost of electricity for Utö Gästhamn reached a total of 257 500 kr. Out of these 257 500 kr approximately 142 000 kr, 55 % of the total cost, were because of the water heating.The report is the result of a cooperation with Skärgårdsstiftelsen, the Green Islands-project and Utö Gästhamn where the mutual goal is to dimension a solar energy system, to promote the sustainable development.Initially the different techniques for the solar energy system are researched. The techniques are plane solar collectors, evacuated tube collectors, pool collectors and photovoltaic cells.

This paper describes a method for wireless energy transfer via near-field electromagnetic inductionthat is inexpensive, simple and can be applied to almost any type of system, regardless of size andenergy demands.The method uses a primary unit consisting of an oscillator, amplifier and inductive coil thattransfers energy to a secondary unit consisting of a coil, rectifier and voltage regulator. Two typesof oscillators and several amplifier designs were realized and evaluated together with a multitudeof flat coils of both monofilar and bifilar type.The results show that it is important to use an oscillator whose frequency is dependent on theinductance of the connected transmission coil, such as the Colpitts oscillator. This is preferable toan oscillator with a preset frequency, such as a Schmitt-trigger oscillator..

Development in spin dynamic occurs in the whole world because of therising demands on fast electronic storage for example hard drivesand RAM (Random Access Memory). Measuring the spin resonance of amaterial gives you the insight of the theoretical speed for amagnetic memory. This means the maximum storage speed is below thefirst resonance. All magnetic materials have different propertiesthat will inflict the resonance frequency which brings that theconstructors of memories need to know which magnetic material theywill use to obtain best results. In the market for normal users themaximum storage speed in a RAM memory is 1.6 GHz.

Suggestion for a new operahouse in stockholm, förslag på nytt operahus i stockholm. Stockholmsoperan..

This study consists of a literature study and a survey in Tamil Nadu, India. The aim of the study was to get an understanding of horse feeding in tropical climates and what kind of feeding related problems that could occur because of the fodder. Information and data were collected from eight different stables and from Tamil Nadu University of Agriculture in the region of Tamil Nadu in March-April 2009. The horses in Tamil Nadu were given rice straw, unknown grass, Cynodon dactylon, lucerne, maize, Pennisetum glaucum x Pennisetum purpureum hybrid and Chloris gayana as roughage. As concentrates, the horses were given wheat bran, oats, barley, soybean meal, maize, carrots, coconut cake, peanut cake, horse gram and chick pea.

The development of solar photovoltaic (PV) is increasing,with declining module prices and with a strongenvironmental profile. Policies are developed around theworld to achieve the targets set for renewable energy.In Helsingborg, the local power company Öresundskraft isworking with solar PV to achieve the goals of the city.With their vision: - Energy for a Better World and Powerfor the Region, their work with developing the local solarPV market is continuing and the next step is to create asolar PV policy. Today their offer is 1 SEK/kWh for theexcess electricity delivered to the grid.It turns out that compensating the customer is a vitalpolicy and it has to be dynamic to follow the decisions ofpolitics. The same survey shows indeed, thatenvironmental and technical part is of interest. Solar PVwill be supported locally to act on environmentalsustainability and locally produced electricity and withthis Öresundskrafts vision will be achieved..

Every year begomovirus infections cause severe constraints to the tomato production in Nicaragua. Extensive yield losses are followed by large economical losses, both for the country and the single farmer. During recent years the use of begomovirus resistant or tolerant tomato cultivars has increased in Nicaragua as an effort to improve yields. Still, begomovirus infection is a large threat to the tomato production. Therefore, ongoing work in Nicaragua is focusing on finding new, better, begomovirus tolerant or resistant tomato cultivars.