This thesis examines the effects of electricity visualization in an office building. The subject was investigated through the creation of a web based visualization tool that was made accessible to the about 1500 employees in a large office building. The visualization was available for three weeks. During this period interviews, user studies and observations took place in order to evaluate what, if any, effects the visualization had on the attitudes and behaviors in the office. Electricity use data was collected and analyzed to see if the project had a statistically significant effect on the electricity consumption in the office.The results from the interviews and the data analysis indicate that no reduction in electricity consumption took place, and a number of factors that could increase the chances of success were identified.

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.

In order to accomplish that a construction is correctly built, it is critical to obtain a well functioning control mechanism throughout the project. The way to enable this is not by having an independent inspector constantly at your side. Today it is praxis to use check lists and have people responsible of quality to make sure that these are followed. This is where discretionary inspections play their part. These among others are documents needed to com-plete the check list.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

Stronger demand has been put on forestry to show environmental considerations during harvesting. This is especially for crossings of brooks with sensitive elements and great care should be observed when they are to be crossed during harvesting by logging machines. For that reason Hultdins has constructed a portable bridge that can be used for those occasions. The bridge has been developed in accordance with wishes from SCA forest, since they have a great deal of brooks in their forests and in private forests from where they buy part of their wood supply. The aim for this report is to investigate if this portable bridge can be of interest for the forestry market. The research has been made at SCA skog in Medelpad and Norrskog in Medelpad.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

Denna uppsats avhandlar möjligheter och begränsningar vid användande avhögenergilaser för nedskjutning av luftmål. Uppsatsen har inte ambitionen attvara heltäckande över området utan presenterar några av de fördelar ochnackdelar som finns..

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.

The district heating load is seasonally dependent, with a low load during periods of high ambient temperature. Thermal energy storage (TES) has the potential to shift heating loads from winter to summer, thus reducing cost and environmental impact of District Heat production. In this study, a concept of high temperature borehole thermal energy storage (HT-BTES) together with a pellet heating plant for temperature boost, is presented and evaluated by its technical limitations, its ability to supply heat, its function within the district heating system, as well as its environmental impact and economic viability in Gothenburg, Sweden, a city with access to high quantities of waste heat.The concept has proven potentially environmentally friendly and potentially profitable if its design is balanced to achieve a good enough supply temperature from the HT-BTES. The size of the heat storage, the distance between boreholes and low borehole thermal resistance are key parameters to achieve high temperature. Profitability increases if a location with lower temperature demand, as well as risk of future shortage of supply, can be met.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

To create multifunctional buffer strips along a watercourse in an economically sustainable way requires consideration of many different factors. In this plan we have selected pollutant reduction as the main purpose of the buffer strip. We have also strived to achieve minimal income loss due to reduced production, increased biological diversity, good game preservation that leads to higher income from hunting, aesthetical satisfaction and possibility to profit from available subsidies. This is done mainly to make landowners/farmers more interested in creating buffer strips along water courses.As sand is the dominant type of soil in the area, the water course is less affected by surface runoff compared to if the soil would be clay or some other finer texture. Game preservation and subsidies have therefore been the main factors when establishing the width of the strip, because these require wider buffer strips in some cases.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

A clean and affordable energy source for cooking is deficient in developing countries. People rely on fuels that contribute to environmental, social and health problems.Biogas is an alternative energy source and an increased investment in small-scale biogas production can in several developing countries be found. Several projects have started to use the technology in developing countries because of the benefits with biogas. Some cases in the establishment of biogas plants have succeeded and some have not. The study is a literature review supplemented by two field studies.

For the actors in the Swedish forest industry, it is important to have the ability to forecast the state in the privateforests. The information that comes out of the forecasts will be the base for the activities strategic direction.The aim in this exam is to survey what information that is present today as basis for forecast calculation, andeven to examine what other possibilities it might have in the future.From a limited geography and out of different time perspective forecast the felling potential in the privateforestry.With the word felling potential means regeneration felling and thinning. The exam will answer the questions:What information is needed to build a relevant forecast model?Is this information available today?Is there information to buy that would improve the forecast model?The result of this exam will be presented in form of a ”case study” showing the opportunities in the market tocreate a forecast calculation of felling potential in the private forestry within the Forest Owners’ AssociationMellanskogs wood-area Dalarna..