In recent years, moisture damages have been noticed in rendered, undrained stud walls. The design is built on the principle one-stage tightening which means that there is no air gap in the construction. The damages have occurred when water has permeated through the rendering in leaking connections and fittings for windows, doors, canopies, balconies, terraces and awnings. Behind the plaster carrier, which consists of either polystyrene or rigid mineral wool, plasterboard has often been used as a wind protection barrier. In many cases the wind protection barrier and the underlying wooden studs have been exposed to mould and in some cases even rot.

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

The use of energy is an important question in today´s society, and a substantial part of the energy that is used today is used in our homes. To lower this usage is vital, and there are regulations in place both on the national and the local level, that say that new apartment blocks must be built to consume less energy, which in the end will lower the impact on the climate.One way to make the housing sector more environmentally sustainable, is to produce energy issions that are bad for the environment, for example to build wind turbines close to or even on the buildings, so called urban wind power. The scope for this report is to see if urban wind power could be a sustainable alternative for the residential area that Svenska Bostäder plans to build in Albano in Stockholm.There are extensive scientific theories regarding wind and wind power, and a literature study is made to investigate past knowledge in the area. Efforts have been made to find earlier trials with urban wind power and, both scientific research and trials where urban wind power actually has been installed. The theory chapter deals both with the wind itself and how electricity can be generated from wind.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

Today´s roofing of dwelling houses is a very time consuming procedure, which includes a lot of different steps on the construction site. Not only does it cost a lot of money, but often do problems with rot and mold occur in the attics of houses today. The use of prefabricated modules has seen a great breakthrough in the field of construction of dwelling houses; at least when it comes to foundations and walls, where this type of approach makes the construction process way more efficient. What no one previous has succeeded to develop is a corresponding system for roofs that meets the demands of a dwelling house. Accordingly the goal of PlusTak has been to come up with a proper module system for roofing of dwelling houses, where the roofing is completed to meet the demands of the Scandinavian market. During the project a lot of effort has been put into customer contacts and the usability of the product, as well in the manufacturing process as on the construction site. This development has gone hand in hand with several practical tests and tryouts.

The aim of this Master?s thesis is to examine the function of the budget as a means of control within an organisation in the public sector. To accomplish this, a case study has been conducted on a certain business unit within Luftfartsverket responsible for providing Air Traffic Control services. The thesis is built on a framework of contemporary theories of budgeting and includes a brief discussion of the weaknesses usually associated with the traditional budget. The conclusion of the study is that the use of budget as a means of financial control within Luftfartsverket is not efficient enough at the moment.

In recent years it has become more and more evident that man has contributed to much of the climate changes that have taken place during the last century. A major challenge today is to reduce emissions and energy usage at the same time as the global population is growing. To contribute to a better environment, Stockholms Stad has set at target of becoming fossil fuel free by the year of 2050. The construction of new districts is done with this goal in mind; energy efficiency and renewable energy sources are examples of methods to achieve this.Solar energy is considered to be a sustainable energy source and the most common techniques to harvest solar energy in Sweden are solar cells and solar collectors which produce electricity and heat respectively. This report aims to investigate whether an investment in any of these systems would prove to be economically beneficial at Kvarnholmen, a district under construction in eastern Nacka, Stockholm.Since the finished blueprints only cover a small portion of Kvarnholmen, the report examines the possibilities for a house where construction has already begun, Nya Kvarnen.

This study investigates how performance management in primary schools can facilitate learning, relating to theories of efficient schools. This is done through a qualitative study of the performance management systems in two public primary schools in Sweden. The schools selected were similar in all major aspects, except pupil grades, where there was a clear difference between the schools. The analysis revealed differences in how the schools handled the process of management by objectives, the professional development of teachers as well as routines, rules, and policies. We conclude that having a rooted process for management by objectives, professional development of teachers, and clearly formalized values, gives a school a good foundation to support a pupil's learning and development..

Mechanical ventilation is the most common type ofventilation in newly constructed office buildings. Therehas been an interest to utilize natural ventilationinstead of mechanical ventilation among architects andHVAC consultants in recent years. This is due to thesize of mechanical ventilation systems, which arespace consuming. The mechanical ventilation system isalso complex and requires maintenance. Furthermore,the fan uses a considerable amount of energy.

The purpose of this study is to investigate how much of the estimated annual electric energy production from Swedish wind power that actually was produced, as well as the history of this agreement over time. The aim is to also examine if there are properties that have caused some group of wind power plants to produce more or less, compared to their estimated production. Operational data on wind turbines collected by the Swedish Energy Agency was analyzed. A survey was made among owners of wind power plants with a nominal power of at least 2 MW. Two different methods for normal year correction of production data were used and compared.

The use of fossil fuels such as coal and gas are a contributor to the global warming. The climate change is a worldwide problem with far reaching consequences that is believed to be very expensive. The United Nations has been introducing a framework convention on climate change. One component of the convention is the Kyoto protocol. The protocol is obligating the developed countries to decrease their emissions of greenhouse gases by 5.2 percent during the time period 2008-2012.

Grubbe Ventilation AB is a sheet metal and ventilation company who provides design, installation, service, and repair of ventilation. The company is expanding their business by building a new facility in Umeå, Västerbotten. The property is designed to be used for both office and industrial work.Grubbe Ventelation AB has not yet decided upon wish system which is to be established to provide the building with heating and cooling. The consulting firm Umeå Projekt Team has therefore been asked to investigate the possibilities to invest in geothermal- heating and cooling.If the investigation of a geothermal heating- and cooling system would provide favorable results it would be a very appropriate alternative that provides energy at low costs and are an environmentally friendly option as the energy comes from stored solar energy in the ground is provided by stored solar energy in the ground.The facility ´s heating and cooling consumptions are calculated in the program BV2 and the result indicate a heating demand of 185 000 kWh per year due to thermal transmittance, transmission losses, heating of warm water and a cooling requirement of 5500 kWh.Three different systems of geothermal heating and cooling were tested in the computer program Energy Earth Design. The results show no difference in the dimensioning of the drill hole if merely heating were to be used or both heating and cooling were to be established.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.

The thermal response of a borehole field is often described by non?dimensional response factors called gfunctions.The g?function was firstly generated as a numerical solution based on SBM (Superposition BoreholeModel). An analytical approach, the FLS (Finite Line Source), is also accepted for generating the g?function. In thiswork the potential to numerically produce g?functions is studied for circular borehole fields using the commercialsoftware COMSOL.

The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.