An energy calculation model for Swedish houses   that is fast, flexible and user-friendly has been developed within the   framework of this thesis.  The model   also provides a set of actions which may be investigated in the model based   on savings and payback period. Energy use in a house depends on the technical   conditions, such as building envelope and heating systems, which outdoor   climate the house is exposed to and who lives in the house. Energy use for a   house can be divided into heating, hot water and household electricity. There   are several methods to calculate the energy use of a house. This report   summarizes the methods that may be suitable for a fast and user-friendly   calculation model.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

Pre-workout (PWO) is one, fast-growing, supplement on the market that promise fat burning, bigger muscels and energy and by buying these expensive supplements, you can get your dreambody faster than others. This study is mainly about researching why people use PWO and what experiences they have about using these supplements. By using a qualitative method I have found out that the participants mainly uses PWO to get energy and focus. This study also shows that my participants thinks that there is a difference in energy between using and not using PWO..

The society strives for sustainable development, in the construction industry it is expressed through sustainable building. Energy and LCC analyzes increases the ability to make conscious decisions in the process. A problem in the construction industry is that energy and LCC analysis is not used to the desired extent, as they are perceived as complicated and time consuming. The report aims to achieve a more sustainable building through increased use of energy and LCC analyzes.The goal is to show how BIM can be used to improve the efficiency of the energy and LCC analyzes.The study was conducted with a literature review and a case study to answer which information that is required in a BIM model to perform energy and LCC analyzes. The study also shows which software can be used in BIM based energy and LCC analyzes and how the analyzes can be carried out efficiently.The result shows that effective analyzes may be performed if the BIM-model contains the relevant information for making analyzes.

En jämförelsestudie har genomförts mellan två värmesystem. Analysen har genomförts med ett flerbostadshus som referensfasighet. Fastigheten är lokaliserad i Södertälje kommun. Analysen går ut på att bestämma vilket värmesystem som är fördelaktigt vid renovering av äldre flerbostadshus med avseende på energi och kostnad. De systemen som har behandlats är ett centralt värmesystem med motströmsvärmeväxlare och ett centralt värmesystem med frånluftsvärmepump.Det centrala värmesystemet (Eq aggregat) är ett centralt från- och tilluftssystem med återvinning (FTX system).

In this thesis work a Geographical Information System (GIS) based methodology to identify locations suitable for the installation of wave energy converters has been developed. Parameters of importance have been identified and a GIS-database has been set up, containing data about the marine environment. In a case study of the Swedish west coast the methodology has been applied, resulting in a number of maps showing possible areas. The results show that large areas are suitable for installation of wave energy converters, from a technical and economical point of view. When consideration is taken to other interests in the area, such as navigation, fishing and environmental protection, the size of the suitable area diminishes considerably.

According to the European Union waste hierarchy, waste should first of all be minimized. Reuse and material and energy recycling come next. Lastly the waste should be thrown at the refuse tip. In the inner city of Stockholm waste handling can be done in various types of ways. The solutions vary as a result of the type of architecture of the building and its condition.

Aeroseum is an aviation museum located in an old military underground hangar. The ventilation system in the hangar is designed for the military purpose of the hangar. This design includes a solution with air flowing through the space between the construction of the hangar and the rock surface. The solution is intended to avoid a buildup of inflammable gases. This design leads too high humidity levels in the hangar.

Construction accounts for about 35 percent of the total Swedish energy consumption and most of the energy is used by the large housing stock from the so-called ?Million program?. In the national action plan the government has put forward in energy efficiency. It is mentioned that existing buildings account for more than 90 percent of what is expected to be the housing stock within the coming 50 years. In order to meet environmental objectives its required that the existing stock be reviewed for energy efficiency. The goverment is now initiating a national framework with a budget of SEK 300 million Swedish crowns per year for five years, starting in 2010 to achieve the goal on energy efficient buildings. Energy efficiency of buildings in both new construction and above all within the existing stock are addressed.

The residential and service sector in Sweden accounts for approximately 38% of the total energy usage and Sweden has an aim to reduce the total energy use by 20% by 2020 compared to 2008, which means residential sector will have to improve energy efficiency. As part of that a law was instituted by the Swedish parliament that all properties must have an Energy Performance Certificate (EPC) to thereby give the property owners a greater insight into energy use in their buildings and propose recommendations for energy-efficiency measures. On the EPC, a value on the building's energy performance in terms of energy use in kWh / m2 per year is declared, of which electricity is a share of it. Instructions on what to include in the amount facility electricity for running the facilities is regulated by the authority for building, Boverket while SVEBY has made an interpretation of the regulations in their report "Brukarindata bostäder" where they have a table on what should be included in the amount and what not to include.This report is a study of two similar apartment buildings, where one of the buildings recently underwent renovation, to see if the declared amount of energy for electricity, in the EPC, is consistent with the measured value, and whether there has been any reduction in facility electricity in the renovated building after the renovation.The result shows that the measured value of the building electricity was 2.6 kWh / m2 per year, 28,8 %, lower than the declared value in the building that have not undergone a renovation. Calculation of values from previous years (2011) by the same percentage of facility electricity as in the results of the measurements, 56.7%, it becomes clear that the declared value for facility electricity in the EPC of the renovated building do not correspond with reality and that there has been an increase in use of facility electricity after the renovation..

The purpose with this study is to investigate funds that are environmentally friendly. Environment issues has become a large subject that affects all aspects in today?s society.  It is a global issue which has affected the awareness of environmentally friendly products and its benefits for the environment.How has this awareness affected the financial market?  In this study the authors have looked at six environmentally sound funds and six energy funds to answer the question if it´s better to have your money in traditional energy or in renewable energy.This study is made in an quantitative way, the data has been gathered from the internet database Morningstar. The energy funds have had its biggest assets in companies dealing with oil, and the environmentally sound funds have had its biggest assets in renewable energy. Bye looking at the different funds rate of return and relating that to risk managing theories of Sharpe and Treynor, the authors compared the two types of funds.During the period that was looked at during this study ( third quarter of 2007 until third quarter 2010) the energy funds outperformed the environmentally sound funds in every aspect. .

The prevailing food and energy crisis of the world, due to the declining reserves of fossil energy and a never ending rise of consumption, forces us to look into new fields to supply our energy demand. The boom of bio energy is criticized, as food crops are used to provide biodiesel and ethanol and the volumes are ridiculously small to supply world demand. Algae are one of the world?s oldest life forms and exist in many different phyla, providing a great variety to choose from, for different purposes. Cultivating microalgae offer a way to produce energy at great volumes without competing with food production and at the same time the algae offer a way to use our expensive nutrients in a more efficient way, besides this the algae are carbon dioxide neutral since their carbon source can be supplied by the atmosphere and the additional energy required can be supplied by algal oil or other renewable sources.

Former studies have shown that a considerable part of industries? energy usage can stem from idle times in the production. This thesis, carried out at Siemens Industry sector, evaluates the potential for using the control system to automatically put machines into energy saving mode during idle times. The main part of the thesis consists of a case study performed on machine tools at a Scania production site in Södertälje. Through load measurements the potential for energy savings was determined.The results show that there is a great potential for energy savings during idle times at the site.

In this work an assessment of the compressed air system in the facilities of Vattenfall Heat Uppsala has been conducted. The facilities constitutes, among others, a combined heat and power plant, and two waste incineration plants. The compressed air is supplied primarily by seven rotary screw compressors and yearly electric energy consumption in these has been determined. Furthermore, the usage of compressed air has been mapped in order to find processes with energy savings potential. Several suggestions how to reduce the usage of compressed air have been presented, resulting in decreased need of electric energy and reduced CO2-emissions.The results show that total need of electric energy in the compressors, during a standard production year, amounts to 5.83 GWh.