As the Swedish governments long term goals include a reduction of fossil fuel dependency, increasing pressure is placed upon energy companies to create and develop new solutions for renewable energy. The following case study was done in collaboration with the company Sydved Energileveranser AB and one of their contractors, Enarssons Skogsentreprenad AB. The objective of the study is to examine the bioenergy situation in region of Skåne and evaluate the potential solutions in the region for a forest-fuel assortment, based on a bioenergy-cutting-system. As a part of this study I have compared ordinary manual cuttings done with a chain saw and cuttings made using the new ?bio- energy cutting system?. The cuttings made under both systems were tested in areas near agricultural fields or pasture land in order to maintain an open landscape.

Overall aim of this master?s thesis is to describe and identify perceived barriers in Swedish businesses within solar energy field and analyze, based on four theoretical viewpoints, how these barriers can be handled. In other words how can the barriers be overcome or eliminated to better succeed in the commercialization process? The method applied is qualitative in which data has been collected through phone interviews originated from seven Cleantech businesses which operate within solar energy. Furthermore this thesis has a descriptive- and an explorative purpose.

This Masters thesis work describes a comparison between two different methods for estimation of the down channel (base station to mobile subscriber) in Wide-band Code Division Multiple Access (WCDMA). The first estimation method, Optimal Feed-forward Channel Estimation (OFCE), is a conventional method that bases the estimates on data that is known to both sender and receiver, so called pilots. The second method, Decision Directed Channel Estimation (DDCE), is an elaboration of OFCE. It also uses user data for estimation. Simulations show that DDCE, in comparison to OFCE, does not attain an improvement in signal-to-noise-ratio (SNR) for high bit error rates (BER).

In this report a study has been done regarding different heating systems on which are the mostcomprehensive with solar heating systems. The report has also been focusing if solar power can beused as a primary heating source for supplying more than 50 % of the buildings total heatingproduction. The University of Dalarna constructed a demo-house for this purpose and according tocalculations the total solar usage is more than 50 %. This house has been made for referenceregarding the design of the heating system of property 5:37.Further studies have been made to compare different heating systems that are compatible with asolar system, where the compared systems purpose is to be independent of direct using electricity. Asystem of this design is regarded as sustainable according to environmental as economic issues.

In modern society in terms of economics and environmental impact, it is important to ensure that a company is as energy efficient as possible to reduce the amount of energy used. About 10 TWh of electricity used annually to pump drives in Swedish industry. Therefore, pumping system has great potential for energy savings.The objective of this report was to determine how much energy and money that can be saved with the insertion of variable speed drive to six pumps on Bleach plant 4 in Skutskär Mill. The work was performed with electrical measurements during one week, analysis of pump curves and the compilation of production data over a year.The results show that four of these six pumps were profitable and yielded an annual saving of 1172 MWh of electricity and 560 000 SEK. With an economic lifetime of 10 years and a discount rate of 6.8% the final result for the entire life-cycle savings became 3 355 000 SEK.

Norconsult AB has developed a solarhousing concept, a house designed for the warm climate in the Middle East andwith large quantities of solar panels installed. The cooling system for the house was designed in an earlier report, the purpose of this thesis is to investigate the possibility of short and long term storage of thermal energy via an underground energy storage volume.Two different designs of the storage and three different filling materials have been integrated into a model to simulate different cases. The first design consisted of pipes installed in the ground, without insulation. The second design consisted of an insulated concrete box installed to prevent thermal energy from the surrounding soil to flow towards the lower temperature regions within the storage. The three different filling materials were dry saudi sand, water saturated saudi sand and the filling material used by the client for energy storage in Sweden.The results from the simulations show that neither of the designs, regardless of the filling material, managed to extract enough thermal energy from the house to the ground to uphold the demands of indoor climate.

The development of productivity in the construction industry has long been at a steady state compared to the manufacturing industry. Studies have shown that, amongst other things, waste on construction sites can reach up to one third of the total production cost. This has been observed from different aspects, and change is forthcoming.This thesis aims to provide a foundation for an increased productivity at production sites of building bridges. It is primarily based on a field study at Skanska, at a bridge construction site near Grängesberg. Via continuous interviews with the whole production crew, construction workers and management, information on interference and possibilities of improvement at the work site has been documented.

This paper is an event study on Initial Public Offering?s return behavior after the dot com bubble. Cumulative Abnormal Returns are used to measure the performance against a market index. The results suggest that the market correctly prices IPOs in the long run thus upholding the Market Efficiency hypothesis. Moreover, value weighted CARs show that large IPOs are more likely to outperform smaller IPOs, however in the long run there is an unpredictable pattern.

Food is widely consumed and in 2011 an average American devoured approximately one ton of food. The production of these goods requires large amounts of energy and contributes to 22-31 % of all greenhouse gas emissions occurring in Europe. More than one third of the produced food is discarded instead of consumed, and food waste make up about 30 % of the waste generated by households. 60 % of this food waste could be avoided if the eatables were handled in a better way.Avoidable food waste arises partly because residues from food are not taken care of, and because the food is not stored in a way that optimise its durability. Residues arises part- ly because of the contradictory and complex demands of everyday life and are, because of our busy lifestyle, difficult to avoid.

This thesis consider alternatives for heating and cooling planned office buildings at Arlanda airport. The thesis is divided into three parts where the third part is a shorter synthesis of the two first. In the first part the energy demands of the buildings are modelled in a computer program. Two different building models are created, one more conventional and one with good energy properties. The results shows that with proper construction and ventilation systems etc.

The aim of this Master?s thesis is to examine the function of the budget as a means of control within an organisation in the public sector. To accomplish this, a case study has been conducted on a certain business unit within Luftfartsverket responsible for providing Air Traffic Control services. The thesis is built on a framework of contemporary theories of budgeting and includes a brief discussion of the weaknesses usually associated with the traditional budget. The conclusion of the study is that the use of budget as a means of financial control within Luftfartsverket is not efficient enough at the moment.

Considering that the price and demand for energy gradually has risen over the past decade and a wider discussion about the human impact on the environment has become increasingly more important and given a clearer role in modern society. This has contributed to increased incentives to reduce the use of fossil fuels and increase the use of renewable energy.The agriculture currently accounts for 20 % of Sweden's total greenhouse gas emissions. A way for an agricultural company like Wapnö AB to reduce their emissions could be to utilize existing renewable energy sources within their own premises.The report's aim is to create an energy audit of Wapnö?s existing energy system and how it changes with a future biogas plant in operation. The energy audit is used to illustrate how the company?s climate footprint could change.

The purpose of this study is to understand the factors that are affecting students at the Technology and Electricity- and energy programs in their choice of studies and vocation. The study is a comparative case study and quantitative method has been used in the form of questionnaires. The result shows that students do not like to be affected by another person but believes that they themselves have made their choice. Interest turns out to be the biggest influence factor of choice for both students at the Technology and Electricity- and energy program. For Electricity- and energy students have also access to work had some impact.The parents' education level was higher for Technician students and their parents worked with occupations requiring university degrees.

The report is about efficiency of a current production group where there is no clear production flow and there are some buffers between the operations. The efficiency is done with the help of a tool that is calledWork process of flow production which is used by Atlas Copco CTO. The most obviously results are that the lead time drops from 25 hours to 425 minutes and that the balancing loss decreases from 85 % to 8 %. The report focus on decreasing transports, decreasing buffers, more reliability in lead time and quality. And a more stimulating labour content for the workers is another result..

This essay will explain the effects of decentralisation, and what impact it has on the efficiency to create a better integration for immigrants on the Swedish labour market. Examples of literature that has been examined are Marcus Gossas and Jon Pierre. From these authors, I have been trying to explain the relationship between decentralisation, cooperation and efficiency.Since the end of the Second World War until the middle of 1980, Sweden mostly received labour immigrant. Since then, the immigrant pattern has changed to consist of mostly refugees. Changed immigration patterns together with increasing debts for the Swedish government has lead to decentralisation and cooperation between public authorities has therefore become a target to reach better efficiency.