The purpose of this project was to evaluate how energy efficiently some of JM?s residential buildings can become in standard production. What kind of measures are needed to achieve the level of energy demand that is included in BBR12 (Boverkets Byggregler)? What measures are needed for achieving a lower demand so that the buildings could be classified as passive houses? The investigation has included a single family house and two different types of apartment blocks.The simulation programs Enorm and VIP+ have been used to calculate the energy demand of the buildings. The results from the programs have been compared with the measured energy demand for the three buildings.

This bachelor thesis aims at investigate how a specified house can optimize its Energy consumption.Today the house often stands for the major part of the Energy consumption in a consumers? life,whereas an energy optimization creates economic as well as environmental advantages. It is importantto make old houses more energy efficient, but putting high energy demands on new houses could beargued to be more important. The installations functions as both the heart and brain in a house, thusmaking it important to energy optimize these. Since the background describes the importance ofenergy efficiency and optimization in a house, the focus area of this report will be an investigation ofdifferent types of heating systems in order to be able to choose the one most suited for the house.Aspects considered when choosing the heating system was how economic the system is both inservice- and investment costs and how environmental and operational friendly the system is.Through literature reviews there were sufficient information gathered that served as a foundation whencomparing and choosing between the four systems - district heating, pellet-fired boiler, geothermalheating and solar heating.

The building industry consumes approximately 40 % of the total Energy consumption in Sweden, where the using stage is dominating with 80 %. There is a lot of work in progress to reduce energy use in the building industry, and the demands from authorities regarding energy use increases. As a part of this work Building and planning department of Sweden has established a requirement that has been applied since 2006, and restricts a maximum energy use for buildings.The requirement includes that an energy simulation must be done in advance to demonstrate that it is possible to meet the demands.Reality is however more complex than an energy simulation program, that frequently underestimates the energy use of buildings. The purpose of this thesisis to study and analyse deviations between estimated and actual energy use in modern apartment buildings. The study includes four apartment buildings in Stockholm, Gothenburg and Jönköping that were built in 2007-2009.

This diploma work addresses the question of how much energy is spent whenmanufacturing the components of a building as well as of how much energy is used inthe production of a building. The object of the studies is BioCentrum at the SwedishUniversity of Agricultural Sciences in Ultuna just outside the city of Uppsala. The aimof the work was to investigate how much energy was consumed when manufacturingand production in relation to the management, how many years the production wasrepresented. It was also a study in how mature the construction industry is to answerhow much energy was consumed in manufacturing.In order to get these answers a question form was developed and sent to thesuppliers to BioCentrum. In this form they were to respond to the quantity suppliedto BioCentrum and the amount of energy was spent when manufacturing thecomponents.

The company Sol & Energiteknik wanted to examine the possibility to make a standardhouse totally energy independent. Based upon this I have, during the spring of 2007,examined the possibilities available at the market today through litterature studies, contactwith several companies and reading reports at the internet.The first thing to examine has been to determine the Energy consumption for a standardhouse, and find out if there are better technologies to be used for energy conservation.My conclusion in this matter is that there are possibilities today for building a house moreenergy efficient.When I had reached the point at which my design for the house was decided, I also hadto choose the different products to use to produce energy as well as to store that energy.To produce heat and electricity to the house I decided to use a wind turbine and a solarwater heater.The most difficult part of designing a house that is energy independent is that theproduced energy must be stored somehow. Storing the heat is relatively easy beacuse theheat can be stored in a large water tank. The electricity is a bigger problem beacuse itmust be stored in batteries, which today are too expensive to be used in a standard house.In the future producing and storing hydrogen might be used to produce electricity, buttoday that technology is both expensive and not tested enough.My final conclusion is that a standard house can not be built to be totally energyindependent today, unless it is very expensive to connect the house to the electricitynetwork. As an alternative solution I came up with a proposal for a house which isconnected to the electricity network and have some amount of own produced energy.This house prooved to be a good investment if you choose to build it today, and it couldbe a very good investment in the long run beacuse energy prices increase every year..

As energy prices skyrocket and the environmental issues become more frequently debated, interest in energy-efficient buildings has increased sharply in the past decade. Because of this, the interest to achieve high air tightness in building envelopes have once again awakened, due to a good air tightness contributes to lower Energy consumption in several ways and to a healthier indoor environment.As the regulations for Energy consumption and controls of achieved air tightness has tightened considerably in recent years, the work regarding sheets for air tightness changed significantly for construction contractors. This thesis includes a study that aims to detect what kind of manuals, recommendations or instructions contractors working according, and how a number of randomly selected construction companies in Halland, Sweden, are dealing with the matter of high air tightness of the building envelopes. The study also includes a knowledge inventory of supervisors, site managers and skilled workers, and what their opinions and attitudes are like towards work regarding the sheets of air tightness. The results have been compared with a similar survey dated to 2004, conducted by the SP Technical Research Institute of Sweden in collaboration with Chalmers University of Technology.

Since the demands from authorities regarding lower Energy consumption havebecome increasingly strict, this puts new pressure on designers and builders, who notonly have to ensure an esthetically pleasing building, but also make sure it issufficiently efficient to pass under new laws and regulations.This thesis takes into consideration a wide range of various parameters and theireffect on a building?s Energy consumption. For this evaluation a computer softwarecomparison between the two programs Autodesk Ecotect Analysis and AutodeskProject Vasari was performed.Autodesk Ecotect Analysis is better suited for studies made on individual factors whileAutodesk Project Vasari is better used in experiments regarding the geometricalshape of the stucture itself.The results from the two different software tools used, give us both differences andsimilarities. For instance, both software programs produced the same resultsregarding the importance of the windows of the buildings to ensure a highly energyefficient building, both when it comes to the windows size and their U-value..

Food is widely consumed and in 2011 an average American devoured approximately one ton of food. The production of these goods requires large amounts of energy and contributes to 22-31 % of all greenhouse gas emissions occurring in Europe. More than one third of the produced food is discarded instead of consumed, and food waste make up about 30 % of the waste generated by households. 60 % of this food waste could be avoided if the eatables were handled in a better way.Avoidable food waste arises partly because residues from food are not taken care of, and because the food is not stored in a way that optimise its durability. Residues arises part- ly because of the contradictory and complex demands of everyday life and are, because of our busy lifestyle, difficult to avoid.

When implementing syncronous filters with global clock nets, a substantial amount of energy is consumed in the clock net. Hence, it is interesting to reduce the size of the clock net, which in turn will reduce the total Energy consumption. One way to acheive this, is to create a SIC (Structured Interfacing of Computational elements) since such a structure can be created without a global clock net. Our results show that a fifth order wavedigital filter with a sample rate of at least 10M samples/sec may be achieved.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.

According to a decision of the European Commission, measures are to be taken to reduce the use of energy in the EU. The goal is to reduce it by 20 % compared to the current use. This shall be done to the year 2020 (European Commission, 2011). One industry that use large amounts of energy is the construction of buildings which account for almost a third of the energy use (Brogren, 2012). The major part of the energy that is used in the construction industry is not used when the buildings are built, but rather during the rest of their subsequent lifetime.

Energy issues are constantly increasing attention in today's society. People's impact on Earth isentered in more contexts. Many discussions are about how the entire social structure needs to bestreamlined in order to achieve sustainability. The residential and service sector accounts for 39 % oftoday's total Energy consumption in Sweden and the increasing electricity prices have made buyersmore interested in energy issues.There are many buildings in need of refurbishment today, including all the apartments that werebuilt in the 1970s to reduce the housing shortage at the time. 650 000 apartments of one millionapartments were built during the so-called the one million program and is currently in need ofrefurbishment.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.

The starting point for this master thesis was the product of the company "Humlegården", which allows its tenants in office buildings to follow their electricity consumption in real time, through their Smartphone's. The idea that resulted from that application is to investigate if it is possible to direct the tenants in office buildings to reduce their Energy consumptions, but also to be satisfied with the indoor environment. This work addresses the factors which are the main energy consumers in office buildings. It addresses legal requirements and standards which are important to follow in order to achieve good thermal comfort in buildings. Some of them are physical climate factors like thermal environment, air quality and lightning.

Energy Director is a control and measuring system for Energy consumption and is part of the product portfolio of E.ON AG for more efficient use of energy, offered to business customers. As of today, the system has only one parameter of control, namely power, and the objective of this essay has been to investigate whether other ones could be added. The emphasis is on the environmental perspective, which is why carbon dioxide has served as an example for this parameter in question.Parallel with the study of Energy Director electricity on the margin, calculations of carbon dioxide equivalents and also the Swedish trade of electricity have all been highlighted. Results indicate that when reductions in energy are made it is endorsed to omit from electricity on the margin rather than some mean distributed electricity, under certain conditions, and in addition the calculations of the reductions should be modified regarding the efficiency of the power stations fuelled by lignite and bituminous coal. Sweden practices trade with the Nordic countries as well as Poland and Germany.