The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

AbstractThe real estate sector is today responsible for 40 per cent of the total amount of energy consumption within the members of the EU. All over the world there are collaborations within research and projects to find ways of reducing the amount of energy consumed by the real estate sector. In Sweden, a directive from the European Union has posed demands on authorities as well as on the private sector to reduce the amount of energy consumed by new building constructions. Together with the directive from the EU there are also new requirements and demands from Boverket for the real estate sector.  These requirements mostly concern the energy consumption of kilowatt-hour per square metre and that the consumed energy also should be renewable.  The aim of this study is to explain what kind of value municipalities experience in using certifications and environmental investments for new and existing buildings. Within the chapter theory, essential areas are described such as; environmental certification systems, economical viability, proceeds connected to building green, difficulties with building green, the performance of green buildings when affected by the behaviour of tenants and customer value.  The following chapter describes the methodology with which we have conducted this study.

Aim: The aim of this essay is to study the work of an alcohol company?s (Pernod Ricard) corporate social responsibility and how this work is being communicated to the company?s stakeholders. Furthermore I aim to describe the profile of the specific company, in other words how they wish their stakeholders to experience the company. I will then compare this profile with the image of how the interviewed stakeholders actually perceive the corporate social responsibility activities. Are there any differences?Material/Method: Together with literature and document studies, a qualitative method has been used and four focus group interviews with a total of 16 stakeholders have been conducted.Main results: The main results from the focus group interviews showed that the stakeholders appreciated corporate social responsibility work that focuses on the protection of young people.

Lots of choices are to be made by a company who enters a new market with a new businessidea. Common questions that show up when a company is making it´s businessplan are how to target the market and how to use marketing as a tool to reach a specific customer or segment. It is difficult to know wether to target the market in different ways and what processes that can be used in the choice how to select the most potential and profitable customer. Another important question is how a company can positioning themself in a way so the customer will get a positive understanding of the company and what different positive abilities to mention in a possible businessproposal. This study is made on a small company in Sweden called AYEN Technology.

All around the world more and more people move from rural areas to live in the cities. Because of this, the urban areas have become an important part in the debate about the effects on the environment and sustainability. In many countries word wide initiatives have been taken to build sustainable cities and eco cities, the Stockholm Royal Seaport is one example. The vision for the district is to become a world class sustainable city based on the three dimensions of sustainable development: social, economic and ecologic. The municipality of Stockholm has set requirements for the buildings? energy usage, emissions and amount of waste generated during the building process.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

As an assurance company has an overconsolidation which must be settled the question that needs to be solved is how to do it. Which are the legal rules that the assurance company has to look after? What is a settling of overconsolidation in a legal meaning? Does an assurancepolicy have to be decided? Why did not the Swedish competition authority (Konkurrensverket) accept the policy from SPP and what can be the consequenses of that decision? Are there any tax rules that needs to be solved?.

This cross-sectional study investigated the use of health benefits in relation to the self-rated health of employees at two medium-sized industrial enterprises in Hälsingland. The method used to investigate this was through a self-designed questionnaire consisting 19 questions about health, lifestyle and health benefits at the workplace. A total of 100 questionnaires were distributed in the two companies, hence 50 surveys at each workplace. The response rate was measured to 88 % and 74 %, which means a loss of 6 persons and 13 persons. The results showed that Company nr 1 offers its employees a health benefits consisting of free access to gym in the company premises after working hours and financial contributions to training-cards.

Abstract: Private equity used to be synonymous with tremendous yields and rates of return. However, the private equity market trembled in 2008, due to the financial meltdown caused by the worldwide credit crisis. Considering the current low number of exits within the private equity industry, the purpose of this thesis is to examine if there has been any change in how private equity firms control their portfolio companies since the inception of the crisis. One private equity company and two portfolio companies have been studied. The case study is prepared from interviews with senior directors in the portfolio company and investment managers in the private equity firm.

The textile business is one of the oldest industries of our time, and it employs nearly 1.4 million workers within the European Union alone. It is not unusual that this is the foundation of a country?s industrialisation. Even though the industry brings many positive factors, there are also negative factors that will influence the industry?s growth in the future.

Problem: How should a company act to sustain a strong identity and thereby a strong brand image when operating in a changeable world?Purpose: The purpose of this thesis is to analyze whether the corporate identity of Academic Work is strong or fragmented. Further more this thesis aims to give recommendations on how the company could continue working to maintain a strong brand image. Methodology: The thesis is a case study of Academic Work. The study is based on data collected from interviews, a poll as well as data from the company website.

In this study we aim to investigate what employees at a callcenter see as prospects, opportunities and barriers of learning within a company. To answer the purpose of this essay, two questions were formulated; "What opportunities for learning does employees experience in the company?" and "How can learning in the workplace improve for the sellers?". First, we present what previous research has highlighted regarding workplace learning and learning within the callcenter industry. Afterwards we present ten semi-structured interviews with leaders and sellers within a telecom company in Stockholm.

This study includes a life cycle assessment, LCA, on an ecological produced cotton shirt for the company Reflective Circle, which designs ethical and ecological clothes.Initially were cotton farming and textile production studied to gather basic knowledge about the processes. Since this shirt is being ecological produced in the whole production chain, we studied what an ecological production means, but also how a conventional production works. When this was done we could start to discuss the differences and similarities between the production of the shirt and general conventional production.When the LCA was first initiated, the main focus was on the green house gas emissions from the manure at the cultivation. Thereafter the process steps such as picking, ginning, carding, spinning, weaving and sewing were being studied. The picking is done by hand, but the rest of the processes are handed by machines which consumes energy.

The strategy when you change the visual part of the brand identity is often referred to as Corporate rebranding and is seen as a good way to show that a company has undergone a change. Despite high risks and high costs, this strategy has become more common and there are companies today who make the choice to change an already well-known graphic profile. This phenomenon is what underlies this essay?s problem statement: Why does a company with an already well-known graphic profile choose to change it and how does the process behind the change occur? In what way have the company?s customers recognized the change and how has the company?s image changed in this context? The purpose of this essay is therefore to explore the process that occurs when a company in the sport and fashion industry changes its visual identity and to explore how the company?s customers have perceived the change.To fulfil the purpose of the essay a case study was carried out on a company?s Corporate rebranding process. The company that was chosen was the Swedish sports retail chain Stadium Sweden AB who decided to change its graphic profile even though their logo was one of the two most recognized in their field.