The world is currently facing a huge severe challenge in handling the issue of climate change. One of the ways to lower the green house gas emissions, which is seen as one of the main contributor to the climate crisis, is to use renewable technologies such as for example photovoltaic (PV) systems. PV-systems are also suitable for so called micro production, small scale energy production facilities, since it can be placed on practically any rooftop with the right solar conditions. In Sweden the usage of PV-systems has not yet gotten any wider spreading, even though the solar radiation conditions are very similar to countries that produce a lot of solar energy, as for example Germany. The aim of this paper is to describe non-adopter perceptions of PV-systems. The study holds a qualitative approach using deep interviews for data collection.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

All products will eventually end up as waste, which in a sustainable society has to be handled in an efficient and environment friendly way. This report focuses on waste fractions meant for combustion, often difficult to characterize. However, more homogeneous fractions that are treated biologically are also discussed.The study concerns the region of Borås, Sweden, where the waste plant Sobacken has provided a good starting point. On this site, fuel to the Energy-from-Waste plant of Borås Energi is prepared and the biological waste is treated through anaerobic digestion.One important part of the study has been to collect experience-based knowledge from the technical staff at Sobacken and Borås Energi. This information was compiled into an overview of wanted and unwanted fractions to the preparation plant and the boilers respectively.

This thesis is made by Carl Persson and Alejandro Saavedra for Gryaab. Gryaab is Gothenburg?s water processing plant and produces about 60 GWh biogas annually with a flow around 1150 Nm3/h. Gryaab wants to research their possibilities to become independent with electrical energy and the possibilities to enrich, upgrade biogas. The use of methane rich gases like biogas and natural gas is today low in Sweden compared to major parts of the world.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

This paper aims to explore the phenomenon urban wind energy, its visual effect on built environment and the factors that affect the opinion towards new elements in the city. A place study of the city Gävle serves as a complement to the theoretical part of the paper. The theoretical discussion opens with an account for the technical and economical conditions of urban wind energy. It presents the technical basics, different types of turbines and a discussion occurring wind related techniques in built environment. Today, the knowledge of how the wind moves and acts in the rural landscape is quite good.

As a result of increased energy prices more and more energy-efficient homes are coveted. An energy-efficient alternative is passive houses, which is characterized by an extremely well insulated building envelope that recovers the heat without the use of radiators or under floor heating. But a passive house requires a higher investment cost than a conventional building project, since it will require more construction materials, training of construction workers, greater land area, and long construction period. But the lower operating cost expects to pay back the higher cost of investment. We therefore question how profitable a passive house is in relation to houses built according to modern conventional building techniques.The aim of our study is to investigate the viability of passive houses compared to convent­ional houses.

Organizations that want to maintain a good innovation capability can seek knowledge both within and outside its boundaries. Opening up innovation processes, through so-called open innovation, allows organizations to combine internal and external knowledge sources in order to include previously excluded perspectives to the innovation process. This study examines how knowledge is created and transferred when conducting open innovation through crowdsourcing. It is done based on Nonaka?s (1991; 1994) theory of how knowledge is created through conversion processes, where implicit knowledge can be converted into explicit knowledge and vice versa.

This essay examines the environmental ideological direction of the Swedish parliamentary parties through the private members motions directed to the committee of industry and trade and the committee of environment and agriculture during the governmental time from 2002 to 2006.The environmental ideologies explained is anthropocentrism, ecocentrism and biocentrism. Based on the ideas of these three ideologies main points the private members motions directed to the committee of industry and trade and the committee of environment and agriculture, also matching the search words environment and energy, was compared and analysed.What has emerged is that all parliamentary parties express a desire to create an energy production and producing guide lines which are stringent environmentally and matches the safety requirements. Although the approach to environmental and safety standards differ significantly between them. Basically all Swedish parliamentary parties are more or less anthropocentric in its arguments, which in short terms means that they estimate natures and animals value through their usability for humans or based on their contribution to human feelings of wellbeing.The Centre Party and the Green Party shows hints of weak ecocentrism because in many cases they put animal intrinsic value high, but the human value higher. Moderates are predominantly anthropocentric but they also express some hint of biocentrism in one statement concerning research in order to reduce and rebuild environmentally destroyed areas.

This report is about helping Q-Med AB in Uppsala to start its implementation of uncertainty of measurements analyses in their manufacturing department. Prior to this, the company relied solely on personal experience or did not take this uncertainty into consideration at all during different kind of measurements, which means that some of the processes that the company previously believed were within specified acceptance limits, will actually fail when considering these sources of uncertainties.Q-Med AB needed some sort of instruction to help the company, in a systematic way, to investigate different types of disorders that are affecting all kinds of measurements. This instruction includes a short summary about measurements and uncertainty of measurements in general and a detailed procedure about how these uncertainties are going to be handled in their daily work.The goal was to be able to use this instruction to systematically locate, eliminate (when possible) and analyze all kinds of disorders when measuring. Q-Med is using a lot of different types of instruments when measuring different types of quantities, including temperature, mass, pressure and density. This instruction will hereafter be used for every instrument, regardless of quantity and type of instrument.The instruction is tested through 4 different kinds of measurements, for mass, temperature and humidity.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

För att en kvalitativ och driftsäker kraftomvandling från vind till elkraft skall erhållas ställs krav på en mängd olika faktorer. Klimatologiska och tekniska faktorer kräver korrekt dimensionering och anpassning av omvandlingstekniken för att största möjliga energimängd skall kunna omvandlas på ett driftsäkert och energieffektivt vis som vindkraftsägare, nätägare kräver. Vinden är som bekant en oberäknelig kraftkälla. Variationerna i styrka och tid kan innebära en hel del driftoptimeringsproblematik med efterverkningar för vindkraftsverket, nätet och belastningen. Konsekvenserna kan bero på vilken typ av teknik som är installerad i de olika delarna av energisystemet och i områdets elnät.

The equine hoof is often manipulated in purpose to achieve a better stride or to reduce the weight on damaged tissue. The living tissue in the hoof can?t store energy as glycogen and is therefore depending on a continuous supply of glucose for its energy production. The purpose of the study was to determine if wedging (i.e. elevating) the heel could influence the hooves glucose and lactate consumption/production. Five standardbred horses were trained to trot on a treadmill without getting physical or mentally tired.

The aim of this study was to evaluate the stir drying method, for drying of grain during Swedish conditions. The evaluation was done during the harvest year 2004, on four farms with stir driers. The driers were evaluated for their energy consumption, design, stirring effectiveness and how much time the farmer has to spend on every tonne of grain. A comparison was also done with conventional Swedish high temperature driers. Totaly six batches of grain from stir driers were examined, mostly winter wheat, but also barley and wheat.

Pulp- and papermills expend vast amounts of water in order to produce pulp, paper and cardboard. Hence, they alsocreate vast amounts of waste water which has to be cleaned before it can be released into the receiving body of water. Insuch a wastewater treatment plant, tremendous amounts of energy are expended by the aeration in the biologicalcleaning process. This aeration is necessary to supply the microorganisms that shall decompose organic material withoxygen, which they need for their metabolism. The transfer of oxygen from the gas phase to the liquid phase isprimarily inhibited by surface-active substances in the waste water like resin acids or fatty acids.