The purpose of this report is to investigate the possibilities with drain water heat recovery (DWHR) in residential buildings. Information and relevant theory has been collected and summarized in this report. Calculations have been done for given scenarios to evaluate profits. DWHR heat exchangers use simple technology and have long life-time. The heat exchanger is connected to outgoing drainage pipe and incoming cold-water supply so countercurrent flow is accomplished.

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

In the middle of Australia there is a city called Alice Springs. The city has one of the highest amounts of daily sunshine hours and sun irradiation in the world. The Australian Government runs a project called Solar Cities, and Alice Springs is one of the participators. The main part of the goal with the Solar Cities project is to increase the amount of electricity generated by solar power and by doing that lower the impact on the environment. This thesis examines the possibilities for construction of a large scale solar power plant in Alice Springs. This is done to determine the potential of creating a more sustainable energy system in the city.

According to a decision of the European Commission, measures are to be taken to reduce the use of energy in the EU. The goal is to reduce it by 20 % compared to the current use. This shall be done to the year 2020 (European Commission, 2011). One industry that use large amounts of energy is the construction of buildings which account for almost a third of the energy use (Brogren, 2012). The major part of the energy that is used in the construction industry is not used when the buildings are built, but rather during the rest of their subsequent lifetime.

In the middle of Australia there is a city called Alice Springs. The city has one of the highest amounts of daily sunshine hours and sun irradiation in the world. The Australian Government runs a project called Solar Cities, and Alice Springs is one of the participators. The main part of the goal with the Solar Cities project is to increase the amount of electricity generated by solar power and by doing that lower the impact on the environment. This thesis examines the possibilities for construction of a large scale solar power plant in Alice Springs. This is done to determine the potential of creating a more sustainable energy system in the city.

Energy issues are constantly increasing attention in today's society. People's impact on Earth isentered in more contexts. Many discussions are about how the entire social structure needs to bestreamlined in order to achieve sustainability. The residential and service sector accounts for 39 % oftoday's total energy consumption in Sweden and the increasing electricity prices have made buyersmore interested in energy issues.There are many buildings in need of refurbishment today, including all the apartments that werebuilt in the 1970s to reduce the housing shortage at the time. 650 000 apartments of one millionapartments were built during the so-called the one million program and is currently in need ofrefurbishment.

This thesis investigated the possibilities to resume cultivation of an old manor house built of timber and what this would mean from an energy and moisture perspective. The building in this case study is named Sofiedals mansion and was built in 1858 in Valbo 11 kilometers west of Gävle.The structure of the house was documented and used as a starting-point for carrying out calculations focused on energy and moisture aspects. With the help of a number of computer programs and a conducted air tightness test, the buildings energy consumption were calculated and compared with the current building regulations.In addition, the building was analyzed considering energy retrofitting and what it meant for moisture problems. The energy retrofitting consisted of additional insulation, decreasing the buildings permeability through air sealing; window and door replacements. When a building is equipped with natural ventilation it is difficult to know its precise performance and how an energy retrofitting affects it.

In today?s society there is an increasing demand for renewable energy sources such as sun and wind power. These sources are intermittent, and energy storage is therefore needed to ensure a constant power supply. This report compares pumped hydro energy storage (PHES), compressed air energy storage (CAES), flywheels, batteries, super magnetic energy storage (SMES) and hydrogen energy storage.The opportunities for further development are limited for PHES and CAES in comparison with the other technologies. Lithium-ion batteries and hydrogen energy storage are considered to have the most potential in the future.

The building sector accounted for around a fourth of the total energy usage in Sweden in year 2010 (Energimyndigheten, 2012). Therefore it has become very interesting to achieve a lower energy usage in residential buildings. One way to achieve that is to build so called passive houses. By being very well insulated and have low leakage through the walls, they can reduce the energy usage for heating with a substantial amount. The first passive house was built during the 90?s in Germany; and in Sweden the first passive house was built in Gothenburg 2001.

Energy awareness is growing among the Swedish population and a one­?to­?two-family dwelling can save energy. The purpose of this paper is to design a tool that helps these home owners reduce their energy costs.The paper develops a model that gives them an indication of how much energy they can save. For the majority of homeowners, the next step in the quest to reduce theirs is most likely an energy audit. Therefore, information to help home owners to get a good energy audit performed is included in the model.A prototype running the operating system iOS is created and validated against existing models, as well as an energy audit. .

This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.

The purpose of this thesis is to assist the Swedish energy company NIBE Energy Systems in their studies of adaptive regulation applicable to electrical water heaters. Due to coming energy classifications of these appliances in the European Union, NIBE Energy Systems needs to use adaptive regulation, called Smart Control, to keep their products in the best possible energy class and remain competitive to the market. By using this Smart Control regulation a 2-3 % improve-ment of efficiency can be credited the system. This is a small number, but heavily needed, since the energy classes are based on the idea that the European Union is provided with electricity from coal condensate power resulting in a 40 % maximum efficiency. Furthermore, doing noth-ing will result in some water heaters not being approved to use on the market from 2015 due to low efficiency.

This thesis is the result of the investigation and solution of a mechanicalproblem regarding flywheel malfunctions. A flywheel is, in short, a devicethat relies on a rotating object?s moment of inertia to store energy overshort time spans. This project is part of the development of a fourthflywheel prototype at the division for electricity at Uppsala university,which uses magnetic levitation to keep a hollow cylinder rotating at veryhigh speeds inside a vacuum chamber. Should the magnets fail however, orsome other error occur that leads to an uncontrolled state of rotation, thecylinder needs to be stabilized mechanically by a device usually referredto as ?back-up bearing?.

 AbstractThe background for this study is that there were a great amount of buildings constructed in Sweden in the years 1965-1975 in a program designed to create one million apartments in a time-period of ten years. These buildings are now, somewhat forty years later in most cases in very poor condition and the need for renovation is great and urgent. This has become a growing problem and more and more voices are being heard pointing towards the vast and extremely expensive task of renovating these buildings. Lately, it has also been more and more important for buildings to be energy-efficient and sustainable environment friendly.In recent years there has been an atempt to solve these problems by renovating such buildings but at the same time making them very energy-efficient. This is in some cases being done by isolating the shell of the building and changing the ventilation-system and so forth.