The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

In a sustainable society the use of renewable energy and recycling of materials is of high importance. Wastewater treatment plants use large amounts of energy in the processing of wastewater. This study seeks to evaluate wastewater as an energy resource and to examine treatment plants potential to become sustainable energy producers. The study is based upon the internal processes of Himmerfja?rdsverket.

Today, about 15 to 20 percent of Sweden?s total emission of carbon dioxide can be traced to the household sector. By examining apartment blocks in a life cycle perspective, the origin of the carbon dioxide emission has been charted and analyzed. This information has been used to create a computational model that calculates the total emission of carbon dioxide from a specific apartment block. The results from the analyzed apartment blocks indicate that both the use of energy and the emission of carbon dioxide have been reduced since the 1960s. Through the examination of building materials, it is possible to lower the emission of carbon dioxide that origins from the construction phase of an apartment block.

Efficient energy use in the housing sector is crucial for achieving a sustainable society. The expansion of this sector only represents a fraction of the existing houses, hence it?s within the existing houses the potential for energy savings lie. This potential has been analyzed in order to determine if it?s possible to cut the current energy demand in half.

The company Sol & Energiteknik wanted to examine the possibility to make a standardhouse totally energy independent. Based upon this I have, during the spring of 2007,examined the possibilities available at the market today through litterature studies, contactwith several companies and reading reports at the internet.The first thing to examine has been to determine the energy consumption for a standardhouse, and find out if there are better technologies to be used for energy conservation.My conclusion in this matter is that there are possibilities today for building a house moreenergy efficient.When I had reached the point at which my design for the house was decided, I also hadto choose the different products to use to produce energy as well as to store that energy.To produce heat and electricity to the house I decided to use a wind turbine and a solarwater heater.The most difficult part of designing a house that is energy independent is that theproduced energy must be stored somehow. Storing the heat is relatively easy beacuse theheat can be stored in a large water tank. The electricity is a bigger problem beacuse itmust be stored in batteries, which today are too expensive to be used in a standard house.In the future producing and storing hydrogen might be used to produce electricity, buttoday that technology is both expensive and not tested enough.My final conclusion is that a standard house can not be built to be totally energyindependent today, unless it is very expensive to connect the house to the electricitynetwork. As an alternative solution I came up with a proposal for a house which isconnected to the electricity network and have some amount of own produced energy.This house prooved to be a good investment if you choose to build it today, and it couldbe a very good investment in the long run beacuse energy prices increase every year..

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

This report is an inventory of the street lighting in half of the residential estates owned by Karlstad Bostads AB, a public housing company. The inventory was made to reduce the environmental impact of the street lighting. From the inventory an estimation of the total installed power and the energy consumption was made. The total estimated power of the street lighting was 125 kW and the energy consumption was 500 000 kWh/year with an estimated running time of 4 000 h/year. The dominating source of light was 125 W discharge mercury lamps.

This paper goes through solar energy and what uses it has. It is also a guide in the choice of solar collectors forthe real estate that I have drawn for the thesis work.Solar energy is a renewable source of energy from the Sun's light. Energy can be used to produce both heat andelectricity through solar collectors and solar cells. Some of the benefits of solar energy is that it is completely freeto extract, environmentally friendly and virtually maintenance-free. Disadvantages are that the technology isexpensive, does not cover the entire energy needs and takes a long time until it pays.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.

Everyone has to take a greater responsibility in energy issues, both individuals and companies. There have been some major developments in the construction industry but there is still a lot to be done. This diploma work thesis presents different methods of making existing construction shed establishments to use less energy. What is possible to do and how much energy is there to be saved? A shed establishment consisting of 8 shed units were studied in this project and the building simulation tool VIP-Energy was used to simulate different types of material in the sheds. An infrared camera was used to locate thermal bridges. There are several factors that can be improved to make a construction shed establishment to use less energy.

The number of data centers and their capacity is increasing throughout the world. Theenergy used in these data centers and the emissions from the use are increasing at thesame rate. The total use of energy will double from 2008 to 2011 based on the trends indata centers use. Research in this area says that the emissions from data centers willhave surpassed the level of airline traffic in 2020. The index used today to compare howefficient a data center is, called PUE, is lacking some information.

High-performance equine athletes have an energy requirement that often reaches twice the maintenance requirement. Horses are grazers and adapted to a grass diet, and diets high in grains and concentrates are associated with digestive upsets and behavioural disorders. It could therefore be of interest if the energy requirement of a high-performing horse could be met by forage. It is important that the forage have a high concentration of energy so that the horse is able to consume the whole amount of energy needed from the forage without exceeding the maximum voluntary intake. The purpose of this literature study was to investigate if the energy demand of a high-performance horse can be covered by forage produced under Northern Swedish climate conditions.

An energy calculation model for Swedish houses   that is fast, flexible and user-friendly has been developed within the   framework of this thesis.  The model   also provides a set of actions which may be investigated in the model based   on savings and payback period. Energy use in a house depends on the technical   conditions, such as building envelope and heating systems, which outdoor   climate the house is exposed to and who lives in the house. Energy use for a   house can be divided into heating, hot water and household electricity. There   are several methods to calculate the energy use of a house. This report   summarizes the methods that may be suitable for a fast and user-friendly   calculation model.

The goal of this paper is to find out how solar cells can improve energy efficiency on-board M/S Sydfart. The paper is based on a number of energy measurements on board the M/S Sydfart. The solar surface is calculated by measuring the available space for installing solar panels. Global radiation data is taken from STRÅNG's database, the data is then used to calculate the theoretical power produced by the solar cells. Energy efficiency is analysed in two ways.

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.