SammanfattningSyftet med vår uppsats är att jämföra den traditionella personalavdelningens roll med den moderna Human Resource Management-funktionen. Vi söker en definition på begreppet HRM och hur utvecklingen gått från den traditionella funktionen Human Relations till Human Resource Management. Vi vill se på de likheter och olikheter som kan finnas mellan begreppen och hur de påverkat personalfrågor. Vi utgår från ett anglosaxiskt synsätt men tittar utifrån ett asiatiskt perspektiv, för att se hur kulturella infallsvinklar kan påverka HRM. För att få svar på våra frågor har vi använt oss av både empiriskt och vetenskapligt material för att få så korrekta svar som möjligt.

The purpose of this study was to investigate to what extent  young adults use media to create the image of themselves. The questions we wanted to answer was as follows: what does the media use of young adults look like compared to their attitudes towards media content; what awareness do they have of other young adults attitudes concerning media content; and finally, how do these attitudes affect their own media use?Media consumption is a great part of  the daily lives of young adults living in Sweden: the national  average media consumption is seven hours a day, for 15-24 year olds. This provides a new way for young adults to express their identity - by showing their use of different media content, they can change other's perception of themselves.The method we used in our study was a combination between a quantitative and a qualitative method. We first made a survey in three classes with senior year high school-students, in a Swedish school.

The purpose of this thesis is to examine how investments are justified in the Swedish data center industry, with a focus on cooling equipment. This is achieved through semi-structured interviews with 20 different interviewees. These interviewees represent different facets of the industry and facilitate an understanding of which factors, such as: investment costs, operating costs, reliability, environmental impact and the influence of external and internal actors, come into play and to which degree they impact the investment decision-making process. The results show that primarily low operating cost in the form of low energy consumption is the driving factor when it comes to the procurement of new equipment. A lower environmental impact is a positive side-effect of lower energy consumption.

This report is the final step in the Bachelor of Science program in Building Construction Engineering, Department of Engineering Sciences, Uppsala University.The purpose of this study is to highlight the difficulties and possibilities that could involve the introduction of new energy efficient technologies and changing work around this technology. This study focuses on energy use at a construction site or other temporary workplace where so-called portacabins are in place to address the need for temporary facilities.The method for obtaining knowledge on the subject was mainly interviews with site managers working in Svevia AB's various activities. In conjunction with the interviews I visited construction sites and portacabins if it was possible.My most important suggestion to Svevia AB concerns a better organization in order to make poratacabins more efficient on energy and costs. The company should also evaluate and monitor the energy efficient portacabins that are in operation.Expected energy savings of new technology may not materialize if there are gaps in information, education, technical services and technical maintenance. It is very important to utilize the experiences of new technology.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

Future emission legislation puts great emphasis on increasing the efficiency of the engine, thereby reducing fuel consumption. The tribological contact between cylinder liner and piston ring is where an great amount of energy is lost due to friction, and by reducing these losses an reduction in fuel consumption can be achieved.The aim of this thesis was to evaluate the tested piston ring coatings against a plasma sprayed cylinder liner and rank these combinations of materials for friction and wear resistance. The coatings that were tested was Cr + Al2O3, (Al,Cr)N, two types of CrN and WC / C.The experimental tests were performed with a so-called pin-plate, where used oil with addition of an acidic mixture of sulfuric and nitric acid to mimic the acidic condensate formed when exhausts recirculate, were added with a continuous flow. The results were then analyzed by weighing, studies by optical microscopy and scanning electron microscopy (SEM) and profile measurements.The results from each material combination were that the plasma coated cylinder liner wears too aggressively in order to yield a ranking of the piston ring coatings based on the parameters of friction and wear resistance. It is therefore proposed that an alternative coating on the cylinder liner should be developed, lacking the large abrasive wear on piston rings and that can withstand the corrosive environment resulting in engines equipped with EGR.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

Due to higher standards of living around the world, greater industries and larger infrastructures causes an increase of the global energy consumption. This harvest of energy puts a great stress on the global environment. With this development, it becomes increasingly important to utilize energy resources in the best possible way.Fans are components that are often used in the industry and in households. A common problem is that the fan is oversized. An oversized fan causes an excessive flow, which has to be adjusted in order to achieve the correct flow.

Stockholms vattenskärning AB in Kungsängen has through the acquisition of a company begun to design and produce aircraft heaters whose origin is early 1970s which follows a high inefficiency in terms of energy consumption and size.The aircraft heater, which is sold worldwide, serves its purpose for customer satisfaction and has done so ever since it was developed in the 70s.Stockholms vattenskärning AB is now investigating the possibility in making the aircraft heaters more efficient, both in terms of energy consumption but also on a more efficient design with the belief that it would lead them to an edge in the market. The aircraft heater consists of several main components whose function altogether is to keep passenger aircrafts warm while they are on the ground.This project has been limited to the further development of the heat exchanger package which accounts for the conversion of the hot medium to the fresh air being carried in to the aircraft cabin. Work has been divided into different phases in order to create a better understanding of the project range and to make it easier to divide the various elements in the time available, 10 weeks. These phases are literature review, situation analysis, concept generation, CAD, concept comparison and writing reports.After the initial literature review was made, a fundamental theory was written which is essential in understanding the remaining parts of the project.With the theoretical part as support, measurements and calculations were made on the current heat exchange package in a situation analysis to ensure its operation and efficiency.In the concept generation phase, the collected facts from the literature review was used as the basis for creating a matrix. The purpose of the matrix was to indicate the two most suitable types of heat exchangers to develop four new concepts out of.In the CAD phase the four concepts was drawn up and then described with text and images.The last phase is the concept comparison where a concept selection matrix is used to function as a decision basis for further production at Stockholms vattenskärning AB. The four concepts have been developed based on the current heat exchanger and is gradually changed into a design of a cross-flow heat exchanger constructed out of stainless sections. The purpose of this is to have gradual upgrading of the heat exchanger as an option, in order not to saturate the market..

AbstractThe Municipality Council decided in 2010 to develop a comprehensive energy efficiency strategy with financial and methodological support from Energimyndigheten (The Swedish Energy Agency). The strategy should include 3 major parts: an inventory of the 2009 energy use defining the current situation, the 2014 and 2020 goals for energy use, and an action plan for goal achievements. According to Energimyndigheten, the strategy must include all municipal administration premises, vehicles, and all majority-owned companies (as Laholmshem, the municipal housing company).The report describes the inventory work in order to obtain the 2009 energy use and the sources of information used. The inventory values are used as the base year values for the 2014 and 2020 goals. The inventory showed that information about the vehicles is dispersed in the municipal administration and no clear structure exists with respect to mileage and fuels used.

Uppsalahem AB is a municipally owned real estate concern that owns and administrates housing for nearly 30 000 people. The company puts a lot of effort into reducing the energy use of their housing stock. This project is a master?s thesis in the energy systems programme at Uppsala University, carried out in collaboration with Uppsalahem. The aim of this thesis is to provide energy saving measures for fourteen student housing buildings in Uppsala, Sweden.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

Lower energy use in buildings is a result of increasingly stringent energy requirements across Europe. When conventional district heating technology is used in areas with low energy consumption heatlosses do not fall even though the amount of energy delivered is reduced. This reduces income for thedistrict heating company. To maintain their economic viability the district heating companies? majorchallenge is to implement new solutions that minimize heat loss.