I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

This paper examines how companies in a transparent industry work to satisfy the customer in an extended way, to offer value added products that in the end enables the customer to be loyal to the company. We have studied the insurance industry in Sweden and have focused on five different insurance companies. Four of them, Folksam, Länsförsäkringar, Trygg-Hansa and Dina Försäkringar, where we have focused on Ölands Försäkringar which is part of the Dina Försäkringar group, are some of the largest insurance companies in Sweden. The fourth company is Swedbank which is a bank that has started to offer insurances.Our results demonstrate that it is important for the company to see the customer not only in a profitability aspect; the company has to find out what the customer gets in return. In that case the possibility for the customer to change company decreases and the chance that the customer becomes loyal increases.

Title Greenlighted employees ? The internal value of Schenker?s environmental work.Author David Fridner.Course Master thesis in Science of Media and Communication.Department of Journalism and Mass Communication, University of Gothenburg.Semester Spring semester 2009.Tutor Professor Monika Djerf-Pierre.Number of pages 55 (appendix 23).Aim The aim is to study the internal value of Schenker?s environmental work.Method Qualitative and quantitative method.Material 20 interviews from four workgroups: managers (4), sales (5), customer-services (4) and truck drivers (7). 148 websurveys from two workgroups: sales (106) and customer-services (42).Main result Schenker is perceived as an environmentally friendly enterprise. Much due to the fact that the company?s impact on nature only has little to do with how the staff evaluate its ?greenness?.

This thesis aims on adding another piece to the puzzle that is the supplier relationship research. Taking its base in a series of articles regarding the transformations of global supply chains into more long-term profitable ones. Two research questions are presented, one regarding long-term supplier relationships and one regarding the main criteria?s while evaluating new suppliers. With an emphasis on the long-term relationship and profitability are five medium sized Swedish manu-facturers examined through semi-structured interviews.

In this report the importance of irrigation scheduling in dry climate is shown, how it can save water and energy; how this method can improve crop yield by supplying the right amount of water at the right time. It is shown how irrigation scheduling and irri-gation technology together increase the irrigation efficiency..

The world is currently facing a huge severe challenge in handling the issue of climate change. One of the ways to lower the green house gas emissions, which is seen as one of the main contributor to the climate crisis, is to use renewable technologies such as for example photovoltaic (PV) systems. PV-systems are also suitable for so called micro production, small scale energy production facilities, since it can be placed on practically any rooftop with the right solar conditions. In Sweden the usage of PV-systems has not yet gotten any wider spreading, even though the solar radiation conditions are very similar to countries that produce a lot of solar energy, as for example Germany. The aim of this paper is to describe non-adopter perceptions of PV-systems. The study holds a qualitative approach using deep interviews for data collection.

The purpose of this thesis is to examine how investments are justified in the Swedish data center industry, with a focus on cooling equipment. This is achieved through semi-structured interviews with 20 different interviewees. These interviewees represent different facets of the industry and facilitate an understanding of which factors, such as: investment costs, operating costs, reliability, environmental impact and the influence of external and internal actors, come into play and to which degree they impact the investment decision-making process. The results show that primarily low operating cost in the form of low energy consumption is the driving factor when it comes to the procurement of new equipment. A lower environmental impact is a positive side-effect of lower energy consumption.

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

All products will eventually end up as waste, which in a sustainable society has to be handled in an efficient and environment friendly way. This report focuses on waste fractions meant for combustion, often difficult to characterize. However, more homogeneous fractions that are treated biologically are also discussed.The study concerns the region of Borås, Sweden, where the waste plant Sobacken has provided a good starting point. On this site, fuel to the Energy-from-Waste plant of Borås Energi is prepared and the biological waste is treated through anaerobic digestion.One important part of the study has been to collect experience-based knowledge from the technical staff at Sobacken and Borås Energi. This information was compiled into an overview of wanted and unwanted fractions to the preparation plant and the boilers respectively.

This thesis is made by Carl Persson and Alejandro Saavedra for Gryaab. Gryaab is Gothenburg?s water processing plant and produces about 60 GWh biogas annually with a flow around 1150 Nm3/h. Gryaab wants to research their possibilities to become independent with electrical energy and the possibilities to enrich, upgrade biogas. The use of methane rich gases like biogas and natural gas is today low in Sweden compared to major parts of the world.

The notion of door policy has received little academic investigation. In the media this phenomenon has however received much attention and has been connected to allegations of discrimination. The authors of this thesis take another view in trying to identify the mechanisms behind door policy from an economic perspective.Based on case studies in nightclubs in Stockholm the authors conclude that there are two types of door policy: including and excluding. While including door policy aims to comply with regulations and commonly is part of a cost-leadership or focus strategy, excluding door policy is primarily a tool for attracting and selecting a certain audience in line with a product differentiation strategy. It thrives on the principles of exclusivity and reciprocity.Forming the identity of a club, audience is of great importance and excluding door policy is found to be an important tool in creating the correct composition of audience, which ultimately aims to increase profitability..

I dagens samhälle blir det allt mer intressant att spara energi, dels med tanke på miljön och dels föratt minska på utgifterna. Denna energi ska sparas på ett sådant sätt att effekten för användarna blirså liten som möjligt.I denna rapport beskrivs hur ett reglersystem kan byggas för att minska energiförbrukningen hosväxthus genom att reglera belysningen på ett effektivt sätt. Systemet är helt automatiskt vilket göratt användarna inte behöver tänka på styrningen av lamporna alls när väl systemet är uppsatt ochkonfigurerat.För att styra lamporna på ett bra sätt mäts det inkommande ljuset med en PAR-sensor. Lampornatänds och släcks därefter beroende på ljusmängden och även på hur varmt, eller kallt, det är iväxthusen.Styrningen av belysningen sker med en mikrokontroller från Microchip, en PIC18F4620 som ärprogrammerad i C18. Kringkomponenter som portexpasioner, klocka och reläer användes också föratt bygga ett bra reglersystem.Resultatet är att det är möjligt att bygga ett reglersystem med begränsad budget som styr lampornapå ett effektivt sätt.

This paper aims to explore the phenomenon urban wind energy, its visual effect on built environment and the factors that affect the opinion towards new elements in the city. A place study of the city Gävle serves as a complement to the theoretical part of the paper. The theoretical discussion opens with an account for the technical and economical conditions of urban wind energy. It presents the technical basics, different types of turbines and a discussion occurring wind related techniques in built environment. Today, the knowledge of how the wind moves and acts in the rural landscape is quite good.

This essay examines the environmental ideological direction of the Swedish parliamentary parties through the private members motions directed to the committee of industry and trade and the committee of environment and agriculture during the governmental time from 2002 to 2006.The environmental ideologies explained is anthropocentrism, ecocentrism and biocentrism. Based on the ideas of these three ideologies main points the private members motions directed to the committee of industry and trade and the committee of environment and agriculture, also matching the search words environment and energy, was compared and analysed.What has emerged is that all parliamentary parties express a desire to create an energy production and producing guide lines which are stringent environmentally and matches the safety requirements. Although the approach to environmental and safety standards differ significantly between them. Basically all Swedish parliamentary parties are more or less anthropocentric in its arguments, which in short terms means that they estimate natures and animals value through their usability for humans or based on their contribution to human feelings of wellbeing.The Centre Party and the Green Party shows hints of weak ecocentrism because in many cases they put animal intrinsic value high, but the human value higher. Moderates are predominantly anthropocentric but they also express some hint of biocentrism in one statement concerning research in order to reduce and rebuild environmentally destroyed areas.

Wind power is becoming an increasingly important source of energy. There are several national and international goals set to increase to amount of renewable energy, and in order to meet these goals, the wind power production plays an important part and the establishment of new wind power farms are required. The Swedish national project Riksintresse Vindbruk has appointed areas in Sweden suitable for wind power, mainly when looking at the physical wind conditions of the area. In this study, I aim to define suitable areas for wind power establishment in Norrbottens län. In order to reach this goal, a critical regional method was developed and completed using GIS.