The division of Electricity at Uppsala University is developing a wave energy converter(WEC) consisting of a linear generator connected to a bouy at the water surfacethrough a wire cable called the connection line.During extreme conditions, the wave power plant will experience forces up to 500kN, which lead to unnecessary wear and will ultimately cause the failure of theconverter. To prevent this there is a need for a damper.The wave energy converter works at a maximum efficiency when the translator?sare centered with respect to the stator. Due to tidal movements the position of thetranslator can deviate. There for a mechanical divice that will compensate for this isneeded.This report describes the further development of an earlier project where a tidalwave compensator for a wave energy converter of Seabased AB was developed.

This report aims to examine the design of a passive house. The design addresses the selection ofmaterial, sizing and selection of both building services systems and building technical features suchas load-bearing framework and moisture control. Interior layout is designed for a family of twoadults and one child.A big part of the report is devoted to an in-depth comparison of three different wall constructions ofpassive house standard. The structures that have been compared are a lightweight timber structure, aheavier concrete structure and a sandwich wall of the brand Weber Leca. The report covers variousaspects such as air flow, wall thickness, the risks associated with the construction, U-value, thermalbridges, power consumption, price, and assembly costs.

A passive house in Norra Djurgårdsstaden drawn by Tengbom Arkitekter is going to be built. A shaft for airing is needed for a few apartments in the house.The airing shaft is designed for a few two room apartments in the house, which are not able to achieve satisfactory airing, as their outer walls are facing a single direction. The other apartments on the same floor are corner apartments. These apartments do not have the same difficulty with airing since they have their outer walls in different directions, with different pressures at the facades. The airflow in the airing shaft is supposed to be driven only by natural forces, by the sun. The purpose of natural driven forces is to achieve low energy consumption for the house.In this thesis, a design of the shaft for airing has been developed.Initially an open shaft for all apartments was analyzed.

Abstract                ?Due diligence - A resource demanding process?Date:                     June 8th 2012Level:                    Master thesis in business economics, 15 ECTSInstitution:           School of Sustainable development of society and technology, Mälardalen UniversityAuthors:                Erdinc Kirik                                  Pär Matsson                               11th January 1987                      31th May 1985Title:                      Due diligence - A resource demanding processTutor:                     Staffan BoströmKeywords:             Due diligence, the acquisition process, acquisitions, business valuationResearchquestions:              What are the main factors that Bank X, Nordea and Almi is focused on an examination of a due diligence for an acquisition, focusing on private limited companies?Does the approach between the various banks and Almi differ?Purpose:                The purpose of this paper is to create a checklist for private limited companies to use in the context of application for fundingMethod:                 The study was based on a qualitative study, based on primary data in terms of interviews in the subject of due diligence. Secondary data used in the study consisted of relevant literature and scientific articles.Conclusion:            The study showed that the respondents in general focuses on the same areas within Due diligence. The most important point which the respondents agreed on was profitability and repayment capacity. In overall, all elements in a Due diligence process that has an impact on profitability is important to examine.

This report aims to examine the design of a passive house. The design addresses the selection ofmaterial, sizing and selection of both building services systems and building technical features suchas load-bearing framework and moisture control. Interior layout is designed for a family of twoadults and one child.A big part of the report is devoted to an in-depth comparison of three different wall constructions ofpassive house standard. The structures that have been compared are a lightweight timber structure, aheavier concrete structure and a sandwich wall of the brand Weber Leca. The report covers variousaspects such as air flow, wall thickness, the risks associated with the construction, U-value, thermalbridges, power consumption, price, and assembly costs.

This essay describes my work as a director in a specialized orientation within psychodrama, surrealistic psychodrama. Using the language and performance techniques of theater and under the guidance of a director, psychodrama creates an improvised narrative or story. The essay describes several dramas I have directed, reflecting on my actions and choices as a director and group leader. I examine whether my working method has allowed me to be spontaneous and creative, which I believe the example of "The dangerous bear" demonstrates. The process enabled me to establish trust and receptivity so that a newly constituted group dared to investigate conflicts in symbolic ways associated with illness and death.

This report aims to examine the design of a passive house. The design addresses the selection ofmaterial, sizing and selection of both building services systems and building technical features suchas load-bearing framework and moisture control. Interior layout is designed for a family of twoadults and one child.A big part of the report is devoted to an in-depth comparison of three different wall constructions ofpassive house standard. The structures that have been compared are a lightweight timber structure, aheavier concrete structure and a sandwich wall of the brand Weber Leca. The report covers variousaspects such as air flow, wall thickness, the risks associated with the construction, U-value, thermalbridges, power consumption, price, and assembly costs.

This study focuses on small scale hydropower in Sweden. This means plants with a capacity of up to 10 MW. The study has a special focus on plants with a capacity up to 2 MW. The study has three aims. It strives to describe the small-scale hydroelectric industry in Sweden.

The technological legacy from the early electrification of the Swedish railroads has resulted in a power grid with a lower grid frequency than the national power grid from which it is fed. Energy transfer between these power grids with different frequencies requires substations, adapting the grid frequency for the rail road power grid. For this purpose, a feeding power grid has been built, stretching across the country from Boden in the north to Tälle/Häggvik in the south.Power transfer in the Swedish power grid results in voltage angle differences which increase with increasing loads and transfer distance. These voltage angle differences are transferred from the power feeding substations to the rail road power grid, will in some extent cause loss of energy due to unwanted power flows from north to south.To minimize the losses due to this phenomenon, a power management system called EFS 132 kV has been developed and implemented. The system minimizes the unwanted power flows and controls the desired power flow for a good distribution of loads between the power feeding substations.This thesis investigates the extent of the transmission losses avoided due to the EFS 132 kV that coordinates the idling angles to a common reference point.The results indicate that EFS 132 kV affects the power flow, especially between the northern substations through an improved load distribution.

The aim of the literature review was to illuminate the importance of nutritional management to patients who have sustained a traumatic brain injury (TBI) and describe nurses responsibility and meaningful function in the nutritional support. TBI patients tend to be associated with hypermetabolism and hypercatabolism, resulting in negative nitrogen balances. The results reveal increased energy expenditure and assessments of needs energy requirements at the TBI patients. This study determining the route of feeding: enteral versus parenteral nutrition. Furthermore describes complications associated with enteral feeding.

This thesis examines the environmental benefits resulting from the choice of environmental certification scheme, with focus on energy. This was carried out by studying the measures that were implemented as a result of the certification of Sweco's three largest office buildings in Stockholm, Gothenburg and Malmö. The office property in Stockholm has been certified with the Swedish Environmental Building, Gothenburg with the British BREEAM and Malmö with the U.S system LEED.The results from the study indicate that an environmental certification can reduce the energy consumption by up to 59 percent and the water consumption by 20 to 66 percent. However; the interviews, literature study and simulations in MATLAB indicate that the size and scope of these environmental benefits depend on several identified factors: the type of building and its conditions, system selection, grade level, the choice of indicators, the ambition of those involved and when in time the certification process begins. The comparison between Environmental Building, LEED and BREEAM showed that Environmental Building for the office property in Stockholm gave the largest environmental benefit in terms of reduced energy consumption thanks to several large measures.

This thesis aims to increase understanding and knowledge of issues affecting the redevelopment of older office buildings to housing. The rising demand for housing in recent years has resulted in a need and an increase in cost housing projects. The need has led property owners wanting to build old office buildings to apartments. The case study is carried out in Lycksele town and in close contact with consultancy TM (Technician Mercantile) ? consulting, which has operations in the area.

The purpose of this study are to investigate and describe if companies? sustainability reports differ in substance and quantity between public and Large Cap companies? and if there are any differences between industries. This study will also analyze if companies? size, stakeholder group or profitability have some impact on the companies? sustainability report. The study includes all Swedish public companies and the Large Cap companies.To investigate in line of the purpose this study will measure both the substance and quantity.

This report is the result of a thesis work carried out on the Risifrutti production at the company Procordia Food AB. The thesis is at a master level and is the final work for the author to receive a Master of Science in Innovative production at Mälardalen University. The thesis comprises 30 credits and has lasted for 18 weeks. The thesis is mainly a research on whether it is possible to perform an Environmental Value Stream Map (E-VSM) in a food processing industry and an evaluation if the tools E-VSM and Green Performance Map (GPM) are useful in this type of industry. An extra part to this research is to use the results from the E-VSM and give Procordia Food AB information on improvement potentials in the Risifrutti production. The author has found it difficult to collect some of the quantitative data to the E-VSM, mainly regarding energy, but by using the Value Stream Mapping (VSM) tool and other Lean tools the author was able to identify and quantify several wastes in the Risifrutti production. Recommendations for improvements based on these wastes have been given to the company. In the research part of this report the utility of the Value Stream Map, Environmental Value Stream Map and Green Performance Map in a food processing industry have been analyzed. The author has found that the Value Stream Map has been a useful tool since waste and unevenness in the tact of the production has been identified. The Environmental Value Stream Map and the Green Performance Map are also great tools when a company wants to analyze their environmental impact and then invest in environmental improvements. However, no profound energy analyzes has been done in the Risifrutti production because of the lack of energy meters for steam, electricity and compressed air in the production lines..

The purpose of this thesis was to examine how locally produced bioenergy may contribute to meet the climate target year 2050 in the municipality of Uppsala. The goal of reduced GHG-emissions from current 6,8 ton CO2-equivalents to 0,5 ton CO2-equivalents per capita and year, year 2050 is based on avoiding harmful penalties of an increased level of GHG in the atmosphere. By estimating available biomass in the county together with examining future technologies and emission factors for the substrates used, four possible future scenarios has been developed focusing either on electricity generation or production of biofuels. GHG-emissions of year 2050 have been calculated using the software LEAP. The conclusion is that bioenergy, depending on how it is integrated in the energy system, may reduce greenhouse gas emissions between 0.6 ton CO2-equivalents and 1.4 ton CO2-equivalents per capita or 12% to 25% compared to 5.5 ton CO2-equivalents in the reference scenario 2050. The greatest reduction is obtained if biofuels are produced in combination with energy efficient heat requirements in buildings..