The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

All around the world more and more people move from rural areas to live in the cities. Because of this, the urban areas have become an important part in the debate about the effects on the environment and sustainability. In many countries word wide initiatives have been taken to build sustainable cities and eco cities, the Stockholm Royal Seaport is one example. The vision for the district is to become a world class sustainable city based on the three dimensions of sustainable development: social, economic and ecologic. The municipality of Stockholm has set requirements for the buildings? energy usage, emissions and amount of waste generated during the building process.

The development within the textile industry is always ongoing with development of new andbetter textiles, which often mean the use of non-natural materials like polyester. This doesn?t lineup with the work shared around the world against an improved environment, so the idea came touse a form of linen fibers instead of polyester as the reinforcing material together with cotton.The idea was to use flax, linen of low quality, which is seen as a waste product and garbage inthe production of high quality linen and flax seed oil. This flax of low quality needs to beseparated before it can be used in cotton spinning machines. Fireball 2 is just that, a process toseparate flax fibers through the treatment of a technique called electrohydraulic discharge.The thesis works goal is to evaluate the Fireball 2 process ability to separate flax fiber.

With a larger awareness of the climate changes and increasing electricity prices, energy efficiency measures in the industry have become more common. By rationalize the activity and by the same time decrease the emission of greenhouse gases the company can both save money and reduce negative environmental impact. For the Swedish industries the electricity price have traditional been relative low, which has resulted in a considerable larger usage than other European countries. By a deregulation of the European electricity market the electricity price will level off between the countries, which will cause a higher electricity price in Sweden than we are use to. To prevent that the Swedish industry don?t lose competitiveness against the other European countries, it will require energy efficiency activities in all different forms.ABB Sweden has decided to decrease their total energy usage with five percent in two years.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.

In today's society there is a significant focus on energy efficiency. Despite this, people leave lamps, televisions and computer screens etc. powered on unnecessarily. The goal of this project is to build a simple prototype for home automation where a user, via an application on a mobile phone, can switch on and off the power of an electrical products in the home and as well as being able to check whether such products are switched on or off. The prototype will also collect data on power consumption for these electrical products.

The demand for environmental assessments on buildings and energy consumption is increasing as well as the energy performance requirements for buildings. At the same time it is increasingly common with self-producers of heat and electricity generation.The main purpose with this master thesis is to investigate how time resolution affects the environmental assessment of energy consumption in office buildings connected to district heating (DH). Environmental assessments were done with both attributional LCA and consequential LCA with system expansion.Fortum´s DH system in Stockholm was analyzed and district heating production was simulated in a Matlab-model. Greenhouse gas (GHG) emissions for the production were calculated. The heat demand of the office Gångaren 16 in Stockholm was simulated in IDA ICE.

Background and problem discussion: Sustainability reporting has recently risen in importance and a rising number of companies choose to issue voluntary stand-alone sustainability reports. Their non-regulated nature increases the opportunity for management to angle the information in these disclosures to their own advantage. Lately the focus has shifted from examining what kind of information is provided in environmental disclosures, to analyzing how the information is presented.Purpose: The purpose is to examine if managers in the energy sector use optimistic tone when issuing sustainability reports. The aim is to find out if the tone applied in environmental disclosures is in congruence with either the environmental or economic performance or if an excessively positive tone is being used to mislead readers.Limitations: This study is limited to information found in environmental disclosures from private companies in the energy sector, issued in 2012 or 2013. Environmental performance is defined as the amount of CO2e emissions and economic performance refers to annual company revenues.Methodology: The quantification of optimistic tone is conducted using a content analysis, relying on a pre-specified wordlist and a pilot study.

This paper briefly summarizes Bergslagen as a bedrock province in order to give background to the genesis and presence of REE-bearing minerals (short for Rare Earth Elements) in the region. These mineralizations mainly occur along the REE-line, a line aproximately a hundred kilometers in length between Norberg in the north and Nora in the south with a width of a few kilometers. Situated in the southwest of Bergslagen it is currently one of only a few places in Sweden where REE-bearing iron oxide mineralizations are potentially economically viable for mining. Ore microscopy has been conducted in order to characterize an ore sample from Myrbacksfältet, one of few sulphide rich iron oxide mineralizations within the REE-line. Additionally, an electron microscope analysis of a sample from Stålklockan, a suspected REE-bearing mineralization also within the REE-line was confirmed by EDS (short for Energy Dispersive Spectrum) analysis.

Cost allocation ? a study of how Swedish energy companies allocate costs between electricity and district heating in a combined heat and power plant District heating is today the most utilized alternative for heating in Sweden. In a combined heat and power plant (CHP) electricity and heat are cogenerated. The environmental and economic advantages with this kind of production are high. A problem in a CHP-plant is to allocate costs between electricity and heat since both products are generated in the same process.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

In the production of pulp, paper and cardboard, a large amount of water is used daily. The water has to be purified in the internal purifying plant before it reaches the receiving body of water. In the biological purifying stage at the Stora Enso Skoghall mill, an aerated basin is used where the microorganisms, using oxygen, oxidize the organic material to carbon dioxide. The air is pumped from the bottom of the basin and the oxygen can then be transported from the air bubbles to the water through diffusion. The problem with aeration of waste water from the forest industry is that wood residues, such as fatty acids, are making the transport of oxygen in water more difficult.

The prevailing food and energy crisis of the world, due to the declining reserves of fossil energy and a never ending rise of consumption, forces us to look into new fields to supply our energy demand. The boom of bio energy is criticized, as food crops are used to provide biodiesel and ethanol and the volumes are ridiculously small to supply world demand. Algae are one of the world?s oldest life forms and exist in many different phyla, providing a great variety to choose from, for different purposes. Cultivating microalgae offer a way to produce energy at great volumes without competing with food production and at the same time the algae offer a way to use our expensive nutrients in a more efficient way, besides this the algae are carbon dioxide neutral since their carbon source can be supplied by the atmosphere and the additional energy required can be supplied by algal oil or other renewable sources.

The power consumption has grown rapidlyin the last decade. Fossil fuels and theneed for alternative energy sources aregreat. Ocean waves are a renewable andsustainable source of energy that hasbeen relatively untapped. At UppsalaUniversity research and development havebeen done for several years. Severaltypes of wave energy converters (WEC)have been created.