An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

The purpose of this project is to analyze earthing systems for houses. By practical measurements and theoretical analyzes consequences of possible faults, that can occur within the facility and in the low-voltage distribution network, is illustrated.  The reason for this project is that nowadays one has to arrange with a main equipotential bonding system for buildings. Apart from that, if necessary, bathrooms must be provided with a supplementary equipotential bonding system.The practical measurements verify that potential differences in facilities may be due to voltage drops in the PEN conductor between the origin of the electrical installation and the power transformer.Based on the theoretical analyzes of possible faults, it is considered that the requirement for  supplementary equipotential bonding systems for bathrooms in most cases can be questioned, when basic insulation, fault protection, residual current devise and main equipotential bonding system already provides an adequate level of protection.A PEN conductor loss may result in a situation where metallic parts attached to the equipotential bonding system starts working as earth electrodes. Equipotential bonding system may also increase the incidence of stray currents. If TN-C-S systems is provided with a local connection to earth a redundant system against PEN conductor loss is obtained.

The aim of the present study was to investigate the effect on growth of foals on two different diets, either a forage-based diet or a diet containing approx. 40 % concentrate. The report also includes a review of the pertinent literature on the effects of diet on mares? milk and growth of horses. The hypothesis of the study was that a forage based diet will result in a similar growth pattern as a diet including more concentrates if the diets contain the same amount of energy, crude protein, lysine, calcium and phosphorous.

In this Thesis the possibilities of designing a larger building that is very energy efficient in the sense that it would not need a conventional heating system are discussed. Solar radiation transmitted through the windows, internal heat from occupants, lamps and electric appliances inside the building and heat recovered from the ventilation system then have to be sufficient for the heating of the building. This study is of general interest since the property company, Akademiska Hus, plans to use this study as a first step in determining if this technique could be used in the future and thus be worth further investments. A building without a conventional heating system of the size investigated in this project has not yet been built.The energy needed for the heating of the building was simulated using VIP+.The conclusions from the study are that it is possible to build large buildings without any conventional heating system. This could be achieved in many different ways, for example by lowering the inside temperature or by using better windows and heat recovery system with higher efficiency.

The purpose of this study is to facilitate sustainable building by the use of BIM. The goal is to determine which aspects of sustainable building, which can be analyzed mainly with BIM tools, but also other aids.The study is based on literature studies and interviews. The literature review examines aspects important for sustainable building by studying environmental certification systems applicable in Sweden, as well as the BIM tools available on the market to analyze these aspects. The literature also includes the concepts of BIM and sustainability in order to provide a clearer view of its meaning. The interviews have brought the study's overall understanding of the industry and guidance on the subject.The results are presented in a table, where the aspects relevant to sustainable building are listed.

In the world we live in today the environmental issues has become increasingly important, and we have begun to realize that we can not continue to use fossil fuels at the rate we do. When it comes to generating electricity we are constantly trying to come up with cleaner and more efficient solutions. The fuel celltechnology is one such alternative and has been around for over 100 years. Yet, it is not until now that the world has started to notice this great technology. The fuel cell has been developed in several areas and can today be used for handheld electronics, vehicles and small settlements.

The division of Electricity at Uppsala University is developing a wave energy converter(WEC) consisting of a linear generator connected to a bouy at the water surfacethrough a wire cable called the connection line.During extreme conditions, the wave power plant will experience forces up to 500kN, which lead to unnecessary wear and will ultimately cause the failure of theconverter. To prevent this there is a need for a damper.The wave energy converter works at a maximum efficiency when the translator?sare centered with respect to the stator. Due to tidal movements the position of thetranslator can deviate. There for a mechanical divice that will compensate for this isneeded.This report describes the further development of an earlier project where a tidalwave compensator for a wave energy converter of Seabased AB was developed.

In the pilot plant at Hammarby Sjöstad, Sjöstadsverket, several new methods are tested in order to achieve a good use of resources. When a new technique is considered it is often the performance of the technique itself, under given conditions, that is evaluated. However, in order to evaluate the overall function the whole picture is needed. With a system analysis it becomes possible to make a comparison where all the positive aspects are put up against the negative ones, for the technique itself as well as its requirements. In this way the influence that minor components have on an entire system can be considered.This report presents a system analysis of an anaerobic membrane reactor (MBR) with a VSEP-membrane (Vibratory Shear Enhanced Process).

A passive house in Norra Djurgårdsstaden drawn by Tengbom Arkitekter is going to be built. A shaft for airing is needed for a few apartments in the house.The airing shaft is designed for a few two room apartments in the house, which are not able to achieve satisfactory airing, as their outer walls are facing a single direction. The other apartments on the same floor are corner apartments. These apartments do not have the same difficulty with airing since they have their outer walls in different directions, with different pressures at the facades. The airflow in the airing shaft is supposed to be driven only by natural forces, by the sun. The purpose of natural driven forces is to achieve low energy consumption for the house.In this thesis, a design of the shaft for airing has been developed.Initially an open shaft for all apartments was analyzed.

This essay describes my work as a director in a specialized orientation within psychodrama, surrealistic psychodrama. Using the language and performance techniques of theater and under the guidance of a director, psychodrama creates an improvised narrative or story. The essay describes several dramas I have directed, reflecting on my actions and choices as a director and group leader. I examine whether my working method has allowed me to be spontaneous and creative, which I believe the example of "The dangerous bear" demonstrates. The process enabled me to establish trust and receptivity so that a newly constituted group dared to investigate conflicts in symbolic ways associated with illness and death.

With the advance in computer and network technologies, multimedia systems and Internet applications are becoming more popular. As broadband network is prevailing, more clients are able to watch streaming videos or to play multimedia data over the Internet in real-time. Consequently, there is an increasing demand in the Internet for streaming video systems. As the run-time environment of such applications tends to be dynamic, it is imperative to handle transient overloads effectively. The goal of this work is to develop an algorithm that would provide a robust and controlled behavior of the video system so that important data is delivered on time to the video clients.

In this project we have used the theory of analytical mechanics to derive equations of motion for complex mechanical systems in order to study their behaviour over time. Even if the theory provides powerful tools to tackle tough problems which would be very hard to solve by methods of Newtonian mechanics, you are still relatively limited without running any computer simulations. One realises that in a faster rate it will be an incredibly difficult task to find an analytical solution when the degrees of freedom increases. Even if one would succeed to derive the equations, one still has to solve them to get the information of the systems behavior. Of experience one knows that the equations in general are nonlinear and hence must be integrated numericaly.

Handling materials and packaging, which is the focus of this study, requires efficient logistics, both internally and between companies. To achieve an efficient material flow, good information systems, whose role is to collect, store, process and distribute information, are required. The assumption that packagings are handled in an efficient manner is currently not a matter of course, when many companies do not prioritize the internal management of the package.The purpose of this report was to investigate how medium-sized businesses working with distribution and handling of spare parts packaging can improve their internal management of packaging. In order to answer the purpose, we have used an abductive process and a qualitative data collection. The study had Logistic Center Ljungby (LCL) at Electrolux Laundry Systems (ELS) as a case company and two other respondents, Nibe in Markaryd and Enertech in Ljungby.

This study focuses on small scale hydropower in Sweden. This means plants with a capacity of up to 10 MW. The study has a special focus on plants with a capacity up to 2 MW. The study has three aims. It strives to describe the small-scale hydroelectric industry in Sweden.

Blekinge Hospital suffers from a budget shortage of 100 million SEK, while the government now requires that hospitals will no longer be running a deficit. Blekinge Hospital will then use their limited resources to survive in the future and the activity must be enhanced in order to keep costs low without having to lay off personnel. The idea is that the organisation should be more efficient with a more efficient resource usage. Performance measurement systems are important tools for achieving the policies set out within an organization, measuring and evaluating performance is a way to see where improvements in efficiency may be necessary in the business. Balanced Scorecard (BSC) is one of several measuring systems, where the focus is on measuring non-financial performances.