The residential and service sector in Sweden accounts for approximately 38% of the total energy usage and Sweden has an aim to reduce the total energy use by 20% by 2020 compared to 2008, which means residential sector will have to improve Energy Efficiency. As part of that a law was instituted by the Swedish parliament that all properties must have an Energy Performance Certificate (EPC) to thereby give the property owners a greater insight into energy use in their buildings and propose recommendations for energy-efficiency measures. On the EPC, a value on the building's energy performance in terms of energy use in kWh / m2 per year is declared, of which electricity is a share of it. Instructions on what to include in the amount facility electricity for running the facilities is regulated by the authority for building, Boverket while SVEBY has made an interpretation of the regulations in their report "Brukarindata bostäder" where they have a table on what should be included in the amount and what not to include.This report is a study of two similar apartment buildings, where one of the buildings recently underwent renovation, to see if the declared amount of energy for electricity, in the EPC, is consistent with the measured value, and whether there has been any reduction in facility electricity in the renovated building after the renovation.The result shows that the measured value of the building electricity was 2.6 kWh / m2 per year, 28,8 %, lower than the declared value in the building that have not undergone a renovation. Calculation of values from previous years (2011) by the same percentage of facility electricity as in the results of the measurements, 56.7%, it becomes clear that the declared value for facility electricity in the EPC of the renovated building do not correspond with reality and that there has been an increase in use of facility electricity after the renovation..

With new energy directives in place, the Swedish Social Service (SSS) stands beforethe challenge how to reduce the energy demand in its locales. It is a complex matter,as the locales are rented from various property owners and it becomes a question ofhow to reduce the operational electricity and influence the property owners to workmore with Energy Efficiency. This thesis takes a balanced research approach in threeparts. Firstly a qualitative part in form of interviews with personnel at the SSS and itsproperty owners, secondly a quantitative part of descriptive nature in form of energystatistics and thirdly a literature review of Energy Management (EM) Supply ChainManagement(SCM), Green Supply Chain Management(GSCM) and EnviromentalPerformance Indicators (EPI). This in order to be able to give normativerecommendations of how the SSS should act to reduce its energy consumption in itslocales and provide new insights on how EM, SCM, GSCM and EPI can be applied ineffect.

Energy Director is a control and measuring system for energy consumption and is part of the product portfolio of E.ON AG for more efficient use of energy, offered to business customers. As of today, the system has only one parameter of control, namely power, and the objective of this essay has been to investigate whether other ones could be added. The emphasis is on the environmental perspective, which is why carbon dioxide has served as an example for this parameter in question.Parallel with the study of Energy Director electricity on the margin, calculations of carbon dioxide equivalents and also the Swedish trade of electricity have all been highlighted. Results indicate that when reductions in energy are made it is endorsed to omit from electricity on the margin rather than some mean distributed electricity, under certain conditions, and in addition the calculations of the reductions should be modified regarding the efficiency of the power stations fuelled by lignite and bituminous coal. Sweden practices trade with the Nordic countries as well as Poland and Germany.

Self-driving cars are soon to become a reality to the commercial market. A self-driving car does not have a human operator, which enables some interesting characteristics. The main benefits are considered to be:The number of accidents and traffic jams should be reduced.Enhanced comfort.Energy usage could be decreased while capacity could be increased.This study concerns the causes for improved Energy Efficiency. The reason for improved Energy Efficiency is mainly because of the variation in terms of acceleration, braking and distance holding are reduced. The vehicles are more intelligent and can work together as a unity.

This thesis concerns to investigate renovations of existing buildings aiming at enabling Energy Efficiency, from a conservation and restoration perspective. This includes performing case studies of three projects in the Gothenburg area where renovations has been done and an analysis of directives raised by the EU and later implemented by the Swedish National Board of Housing, Building and Planning, Boverket. In addition to these, regulations enforced by the Swedish law, related to the topic, have been considered.The investigated projects in this case were the housing cooperative Välten in Brämaregården, the Solar Buildings in Järnbrott and Gårdsten as well as Katjas Gata 119 at Backa Röd. In order to measure and compare the results of these projects a comparison between the pre- and post-restoration energy consumption have been performed. To capture additional perspectives the grading system Operation Kungsörn has been applied.Regarding the comparison of energy consumption the renovation of Katjas Gata 119 was found preferable but showed in my view lacking attention to the cultural heritage of the area.

Self-driving cars are soon to become a reality to the commercial market. A self-driving car does not have a human operator, which enables some interesting characteristics. The main benefits are considered to be:The number of accidents and traffic jams should be reduced.Enhanced comfort.Energy usage could be decreased while capacity could be increased.This study concerns the causes for improved Energy Efficiency. The reason for improved Energy Efficiency is mainly because of the variation in terms of acceleration, braking and distance holding are reduced. The vehicles are more intelligent and can work together as a unity.

Tången 2 is a building situated in Stockholm, Sweden. It´s built in the 1930s and contains both residences and businesses. The property owner, Diligentia AB, wants to lower the energy use in Tången 2. This report consists of an energy audit which clarifies the specific circumstances linked to Tången 2. Collected knowledge is then used, together with the results from the literature study, to decide energy measures to proceed with.

The amount of electricity is limited in Namibia and the large distance between towns andvillages complicates the energy supply in the country. Therefore an alternative way to provideaccess to appropriate energy technologies is needed. The Government of the Republic ofNamibia (GRN) has adopted an approach of helping off-grid households by establishing EnergyShops in each region in Namibia and these shops are going to sell basic renewable energy andenergy efficient products. The Renewable Energy Efficiency Institute in Namibia (REEEI), theinitiator of this thesis, is coordinating the establishment of these Energy Shops.The main purpose of this thesis was to examine the needs of energy products for the Namibianpopulation and develop an assessment method for the Energy Shop in how to select appropriateenergy products already on the world market. The purpose was also to develop a method forchoosing an Energy Shop.

Tumble dryers and drying cabinets have to a large extent replaced the traditional way of drying clothes outdoors. They are faster, more convenient, require less space and can be operated regardless of weather conditions. This replacement has significantly increased residential energy consumption, due to the fact that tumbles dryers consume large amounts of electrical energy. In the USA 9 % of the households electric energy is consumed when drying clothes. Over 4 million tumble dryers are sold in Europe each year and 20 % of the residential electricity consumption in Sweden is used drying and washing clothes.

Between 1965 and 1974, the Swedish Parliament decided to build one million dwellings, called Million Program. The million program buildings were erected with new, untried design solutions, in a short range of time, and at low cost. The residential buildings from that time are now greatly in need of renovation. The municipal housing company, Gavlega?rdarna, renovates and improves the Energy Efficiency at some of it?s apartment buildings in the district Sa?tra, Ga?vle.

Energy and environmental demands regarding buildings have become an increasinglydiscussed topic, both in Sweden and in Europe as a whole. The general trend indicatesthat greater efforts are being put into the Energy Efficiency of the built environment.There are already numerous examples of houses with a low energy demand, and thenumber of low energy buildings is constantly growing.At the time being, the maximum level for energy demands for housing in Stockholm is110 kWh/m2year, but as soon as next year the limit will be changed to 90. The Swedishagency Energimyndigheten is currently conducting a project to interpret the EU Directiveon the so-called Nearly zero energy buildings, and the preliminary results indicate thatthe level of requirements for purchased energy will end up with about 55 kWh / m2year,which is in line withtoday?s recommendationsfound in FEBY's Kravspecifikation förPassivhus.Starting with a low-energy house in Henriksdalshamnen in Stockholm, we have analyzedvarious energy-efficiency measures and their influence on power and energy needs. Thefinancial aspects associated with the measures have been studied using a model of lifecycle costs.The measures were initially studied individually to give an idea of how much impact theyeach had.

The Energy Performance Certification in Sweden was developed as a tool to achieve the Government's target to reduce Sweden's energy consumption by 20 percent by 2020. The Energy Performance Certificate has previously received some criticism for not fulfilling its purpose. Questions that formed the basis for this report is how the energy performance certification provides support to buyers of single-family houses and if the energy performance improved in terms of reliability. The report begins with a background description that describes how the energy declaration works and some of the findings of previous evaluations and surveys. A survey to investigate the broker's position to energy performance have been conducted as well as interviews with buyers and sellers of houses. An investigation whether the energy performance can vary between different calculation programs, depending on various assumptions made by the energy declarant, has been made.Brokers and sellers have proved negative attitudes towards energy performance, particularly brokers.

This report was performed in order to evaluate a new technological measure and focuses generally on a heat pump system to a HWC-washing machine. The client is Asko Appliances AB, a company well known for its environmentally friendly products. The goal of this study was to improve the Energy Efficiency of a washing machine by combining a heat pump device to the heater of the wash water, in order to reduce the energy consumed for heating the water. Besides reducing the energy consumption in heating the water, the washing machine was required to meet low noise and short operating time specifications. For that purpose, nine trials in three test series have been carried out.

The constant need of energy is something that affects us all no matter our current situation. Whether we are driving our car to work, taking the elevator or using the oven to cook dinner we end up relying on energy. Our whole society is continuously striving to achieve a higher grade of efficiency and the process of supplying ourselves with energy is no exception. The importance of appliances in our everyday life cannot be exaggerated and thus the importance of their high efficiency.Efficiency is already a keyword in the appliance industry with labels, stars and numbers helping us choosing the most suitable option for the task ahead. No matter how efficient appliances often use pure electricity as their energy source.

The energy consumption in the sectors of residential and public buildings is 40 % of the total energy consumption in Sweden. The main part, 85 %, of the energy use in these sectors is for operation of the buildings. The rest is used in the building process. When energy-efficiency measures are taken the energy use during the operation time decreases and the fraction of energy consumption during the building time increases. This project is carried out in cooperation with JM AB and concerns the energy use during the building time of production of blocks of flats at the building site.The main part of the electricity that is used during the production of apartment buildings goes into the heating of portacabins and illumination of the building during the construction phase.