Sök:

Sökresultat:

11657 Uppsatser om Emission data - Sida 6 av 778

Visualisering av Flight Recorder-data i Saab 2000 avionikrigg

The main purpose of a Flight Data Recorder (FDR) is to facilitate the investigation of incidents. In order to interpret the data that has been recorded in the FDR the data has to be visualized in some way. This can be done with software on a computer or with hardware that is specific for the model of aircraft that the data originates from.The aim of this project is to visualize data for six parameters from the FDR of Saab 2000 in an avionics rig. The avionics rig resembles the cockpit of Saab 2000 and the displays in it are identical to the ones found in the plane. All six parameters are shown on the same display.Due to safety regulation vital systems in aircraft are doubled, with one system on the left side and one on the right.

Mean value modelling of a poppet valve EGR-system

Because of new emission and on board diagnostics legislations, heavy truck manufacturers are facing new challenges when it comes to improving the engines and the control software. Accurate and real time executable engine models are essential in this work. One successful way of lowering the NOx emissions is to use Exhaust Gas Recirculation (EGR). The objective of this thesis is to create a mean value model for Scania's next generation EGR system consisting of a poppet valve and a two stage cooler. The model will be used to extend an existing mean value engine model.

Restriktioner av växthusgasemissioner : hur påverkas lantbruksföretagens ekonomi och produktionsinriktning?

The agricultural sector accounts for about 13 percent of the total load of greenhouse gas emissions from Sweden (Swedish Environmental Protection Agency, 2007). The Swedish objective to reduce the greenhouse gas emissions with 40 percentage units to the year of 2020, based upon the year of 1990, might imply stricter regulations for Swedish farmers. A regulation or other forms of economic incentives is probably necessary to reduce the emissions originating from the agricultural sector. This study aims to investigate the economic and managerial impact on two agricultural firms with differing production system given that a constraint on green house gas emissions is introduced. Gases included in this study are carbon dioxide, methane and nitrous oxide.

Utveckling av webbaserad databas för inmatning och bearbetning av medlemsdata

Denna examensrapport visar hur utvecklingen av en dynamisk webbapplikation har genomförts. Examensarbetet har utförts på Data Ductus AB i Skellefteå åt en extern kund. Kunden ville ha en lösning för att samla in data och med detta data sammanställa statistik.

Har intressenterna förtroende för revisorerna?

The purpose of our essay is to investigate the trust in accountants. The method we used to investigate the trust was a survey and a questionnaire was used to collect the data. The data was gathered from three different groups, shareholders, lenders and tax authority. When we analysed the data we found out that the groups trust in accountants were neither strong nor weak. The results can be generalized on all the three groups because the observations were scattered around the means and we used random selection to collect the data.

Datakvalitet : En fallstudie om kvaliteten i SJ:s underhållssystem

SJ is a government-owned passenger train operator in Sweden. SJ currently uses asystem called Ford for control and monitoring of maintenance. Technical andorganizational factors have given Ford the character of a monolithic system withoutflexibility and conditions to meet SJ's increased requirements.The main purpose of this master's thesis is to investigate how data quality can bedefined at SJ and to examine the data quality in Ford. This will give SJ an indication ofwhat their quality efforts should focus on in the future.The technical data quality parameters found are: accuracy, timeliness, completenessand consistency. The user centred data quality parameters are: accessibility,understandability and reliability.

Energieffektivitet i datahallar

The number of data centers and their capacity is increasing throughout the world. Theenergy used in these data centers and the emissions from the use are increasing at thesame rate. The total use of energy will double from 2008 to 2011 based on the trends indata centers use. Research in this area says that the emissions from data centers willhave surpassed the level of airline traffic in 2020. The index used today to compare howefficient a data center is, called PUE, is lacking some information.

Adaptiv katalysatormodell för reglering

This master?s thesis describes the development of a model of the catalystsystem aiming at control by an MPC. A well functioning model, which is suitable in control purpose, is important while emission legislation become more and more hard to fulfill for the car manufacturers. Much research has been done in the field of physical modeling of the system, but in this work a linear adaptive time discrete ARX-model is developed and validated.The systems tendency to change its dynamic during usage implies that the model must be adaptive. The developed model proved to be well functioning and shows promising conditions for the MPC design.

Hantering av viktiga framgångsfaktorer vid utveckling av ett Data Warehouse

Business Intelligence may help organizations in making the right decisions byproviding data for analysis which can be presented to decision makers. DataWarehouse which is a central part of Business Intelligence can be built in severalways but the methods presented by Ralph Kimball and Bill Inmons are considered thetwo main methods. The solution provided by Inmon focuses on integrating the entirebusiness into one large database using relational database development. Kimballhowever proposes dimensional database modeling by creating one or more data martsand integrating these using a data bus. Previous research has shown that the quality ofa Data Warehouse can be measured through critical factors such as data quality andsystem quality.

Utvärdering av riktlinjer för inkorporering av syndikat data i datalager : Praktikfältets syn på tillämpbarhet och nyttoeffekt av Strands riktlinjer för inkorporering av syndikat data i datalager.

Inkorporering av extern data i datalager är problematiskt och problematiken bekräftas av aktuella undersökningar inom området. Detta har medfört att det utvecklats olika former av stöd för att bemöta och analysera problemen som organisationer ställs inför.För organisationer är det i högsta grad viktigt att dess beslutsfattare är välinformerade och klarar av att selektera information från stora mängder data. Det är i dessa sammanhang som en datalagerlösning är en viktig hörnsten för att stödja analys och presentation av data som ursprungligen är lagrad i olika datakällor (både interna och externa). Genom att inkorporera extern data i datalagret uppnår datalagret en betydligt högre potential och således kan även organisationer och framförallt dess beslutsfattare utvinna stora fördelar.Strand (2005) har tagit fram riktlinjer för att stödja inkorporeringsprocessen av extern data i datalager. Dock saknas en utvärdering av riktlinjerna.

Platt Hierarki : Metoder för omvandling av relationsdata till hierarkisk data

The relational database model was defined in the 1970?s and is the dominating database type today.  The main difference between data from a relational database and a hierarchical data structure is that the relational database stores records in tables. The records have no particular order, but can include links in terms of relationships with other records. A hierarchical structure organizes data in the form of a tree structure  and  can for an example be found in organizational structures in which different levels involves different responsibilities. If the data stored in a relational database is to be presented in a hierarchically, a conversion of the data structure is required. The intention of this paper is to describe how such a conversion can be performed.  To investigate the conversion methods, case studies has been conducted on the basis of a specific organization?s hierarchical structure.

Statistisk kartläggning av dimma längs E4:an mellan Helsingborg och Jönköping

Fog is a small-scale weather phenomenon that are fascinating to people. However, the presence of fog in road traffic reduces the visibility and increases the risk of road accidents. By the Swedish Road Weather Information System (VViS), the safety on roads could ameliorate and road accidents caused by fog and other weather hazards could be prevented. Fog is however a complex and usually local phenomenon, why fog formation generally is not easy to predict. For that reason, a statistical mapping of fog, especially along a motorway with high traffic volumes, could be useful in planning to prevent road accidents.

Förbättrar en kvalitetssäkring skördarens dimensionsmätning?

In this study it was investigated if the adoption of a new routine for quality control could improve the precision of the dimension measurement obtained by harvesters. Data was collected from three different harvesters. First, a reference data set was collected before the new procedures had been incorporated, and then when the new methodology was implemented another data set was collected by the harvester operators, allowing the two data set to be compered. The results indicated that following the implementation of the new procedures, the reliability and the precision of the measurements has increased. All harvesters included in the study had improved regarding most of the controlled factors such as standard deviation, systematic difference and hit rate within ± 2 cm for length and ± 4 mm for diameter..

Gradering av vindkraftslägen i Lerums kommun med hänsyn till infrastruktur och läge

The aim of this master thesis was to find and grade suitable sites for wind turbines in the rural district of Lerum at the reguest of Göteborg Energi. The rural district of Lerum consists of very complicated terrain which was the reason why we picked Lerum.The assignment was achieved by using the software program ArcGIS and its attendant tools. In step 1 an overall analysis was made in order to sort out the least suitable sites. Step 2 consisted of a 3D analysis in ArcScene together with a more precise analysis in ArcMap. As result we found two interesting sites, which met our demands and specific constraints.

MÄTNING AV LJUDIMMISSION FRÅN VINDKRAFT. VIDAREUTVECKLING AV METOD FÖR MÄTNING

The Swedish government have a goal that wind turbines shall produce 30 TWh by the year 2020, compared to about 3,5 TWh produced in Sweden during 2010. To minimize the disturbance that wind turbines create the Swedish Environmental Protection Agency has stated a guideline value that noise from wind turbines at nearby residents shouldn?t exceed 40 dBA, at 8 m/s wind speed. With advanced calculation models, like Nord 2000, the emitted sound from future wind turbines can be calculated at an early stage to optimize the power production without exceeding the 40 dBA. When the turbines have been built there is a need to verify that they really are within the guideline.

<- Föregående sida 6 Nästa sida ->