A detailed dam safety evaluation (in Sweden called FDU) was performed in 2009 by WSP where stability control was performed for Långströmmen power plant with associated spillways. This evaluation concluded that stability could not be ensured, and risk of sliding occurred. The evaluation is based entirely on the recommendations outlined in RIDAS, the power companies guidelines for dam safety, and it is clear that extensive renovations are necessary to stabilize the dam.In this work, the stability will also be checked with guidance through new proposals on guidelines for concrete dams sliding stability, ELFORSK?s report 08:59. This report considered the guidelines in RIDAS as oversimplified, both from an international perspective, but also with regard to the current state of knowledge regarding dam safety.

This master thesis was a continuation of a previous study in the diesel exhaust characterization, which is part of the academical work embedded in the EMIR-1 project. The main objective of this thesis work was to finish the installation and make the proper modifications of the particulate mass measuring system located in one of the engine test cells at KTH, in order to be able to measure the mass of the particles from the exhaust of diesel engines.This experiment requires a diluted flow sample from the exhaust that should be sent to the device that makes possible the measurement of particle mass, called TEOM. In the first stage of this project, the objective was to study and make the proper modifications in the existing KTH diluter because there were several problems to obtain a constant dilution ratio from it during tests.This modifications were made and it resulted in a great improvement in the maximum inlet and outlet flow that this diluter can handle. Therefore another modification is proposed for controlling the inlet exhaust flow so it will be possible to regulate the dilution ratio and make it constant along a wide range of engine loads and speeds.The second and most important stage was to make particulate mass measurements possible by analyzing the frequency signal from the TEOM device. The idea was to obtain the frequency of oscillation from the tapered element in the TEOM, and therefore with the proper correlations, be able to predict the particulate mass concentration in the exhaust flow from the engine.An electrical problem in the TEOM circuit was detected and corrected, so the signal that carries the frequency from the TEOM can be analyzed properly.

The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.

Allt eftersom utvecklingen går framåt inom applikationer och system så förändras också sättet på vilket vi interagerar med systemet på. Hittills har navigering och användning av applikationer och system mestadels skett med händerna och då genom mus och tangentbord. På senare tid så har navigering via touch-skärmar och rösten blivit allt mer vanligt. Då man ska styra en applikation med hjälp av rösten är det viktigt att vem som helst kan styra applikationen, oavsett vilken dialekt man har. För att kunna se hur korrekt ett röstigenkännings-API (Application Programming Interface) uppfattar svenska dialekter så initierades denna studie med dokumentstudier om dialekters kännetecken och ljudkombinationer.

In this study a case study was conducted at the Transport Agency. The government agency is seeking better alternatives to its current ways of keeping track of important dates stated in legal documents. The agency wants to explore the possibility for an IT-solution for keeping track on those dates. In the case study change analysis was conducted on the vehicle type approval process. Qualitative interviews were conducted with a section manager, vehicle type and component approvers, and with a system administrator and a system manager at the Transport Agency in Borlänge.

 The purpose of this study was to study social work models to explain addiction in the assessment of response to people with addictions. This study investigated how social workers' explanations are shaped by their experiences, theoretical points influenced by research in a discretion is affected by organizational conditions, manuals, evidence-based practice and national guidelines in an investigative process. The material in this study has emerged through interviews with four social workers in the social services department for addiction and dependence. The essay is a qualitative study with personal interviews as the basis for the result. The study begins with a description of addiction and dependence, current laws on the matter, and officer's work.

In this thesis, input data for energy performance calculations on commercialpremises have been studied. In energy performance calculations, where internal heat gain parameters are unknown, template values that, in a reasonable way represent the activity in the room, are necessary. These values can be used as input data for whole-year calculations, or for calculations on shorter periods of time.The purpose of the Sveby project is to create standardized work practice in energy issues for the construction industry. The work in this thesis is conducted to correlate with the purpose of the Sveby project, with aims of contributing with information and guidelines for the continuing work with commercial premises.In this report, suggestions for template values for internal gains parameters, based on research and calculations in the field are presented. Suggestions on how these can be implemented in a user-friendly way for two energy performance calculation software are also given, VIP Energy and IDA ICE.

Mine waste from Ljusnarsbergsfältet in Kopparberg, Sweden, is considered to constitute a great risk for human health and the surrounding environment. Some of the waste rock consists of sulphide minerals. When sulphide minerals come into contact with dissolved oxygen and precipitation, oxidation may occur resulting in acid mine drainage (AMD) and the release of heavy metals. The purpose of this study has been to characterise the waste material and try to chemically stabilize the waste rock with a mixture of sewage sludge and calcium carbonate. The drawback of using organic matter is the risk that dissolved organic matter can act as a complexing agent for heavy metals and in this way increase their mobility.

The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.

We have made a litterature study about pain in animals. In this studie we have brought up areas like sign of pains in animals, pain relief and the care perspective. Pain is perceived when body tissue is damaged or nearly damaged by stimuli. Nociceptors, which are receptors placed at nerve endings, responds to a provocation of pain and transmit an impulse along the nerve to the brain via the spinal cord. Pain is urgent or chronic, and can be divided into nociceptive pain (somatic pain and visceral pain) and neuropathic pain. Different pain mechanisms can arise, such as referred pain, which is when signals of pain are referred to other parts of the body.

In order to facilitate testing of anesthesia machines a patient simulator has been required by Maquet Critical Care AB. A patient simulator has been developed to reduce expensive and time consuming animal experiments and temporary lab arrangements. The patient simulator has been developed and designed to simulate human lungs with regards to anesthetic uptake, production of carbon dioxide and heating and moisturizing exhaled air.The system comprises a container and a test lung to simulate the volume and the dynamic of the human lung. The simulation of uptake of anesthetics has been implemented by pumping a fraction of the gas from the container through a bypass circuit with an active charcoal filter that adsorbs volatile anesthetics. The flow through the bypass circuit is generated by a pump and is controlled by a linear valve.The resulting performance of the patient simulator has fulfilled the requirements.

The automotive market is currently undergoing a historical change where stricter emission legislations and ever increasing fuel costs have intensified the search for effective alternatives to the conventional internal combustion engine, which has resulted in a substantial trend towards electrification of powertrains. Storage of electrical energy is the fundamental component in this technology where the lithium-ion batteries are currently considered as the most appropriate solution. Lithium-ion batteries, however, as other types of batteries, can only be used efficiently and durably within a specific temperature range.This Master thesis has been carried out in collaboration with Electroengine in Sweden AB, situated in Uppsala, which has an ongoing project regarding development of a modular battery system for electric powertrains. The project is at a stage where an initial prototype has been developed which provides the foundation for this thesis. The study has addressed the battery system performance from a thermal perspective, in order to validate the ability of the system to create a thermally serviceable environment for the lithium-ion battery cells.

Examensarbetet initierades för att undersöka hur fordonstillverkare på ett effektivare sätt kan hantera ochdra nytta av den växande marknaden av elektroniktillbehör så som mp3-spelare, GPS-navigatorer osv.Dessa produkter går förstås redan att använda i fordon idag, men är oftast inte möjliga att kontrollera medfordonets inbyggda kontrollenheter som till exempel volym knappar i ratten. En anledning är frånvaron aven standard över hur elekronikprodukter ska kommunicera med varandra. Produkterna är i första handdesignade för att användas separat, en mp3 spelare har interface (USB) för filöverföring, men är för övrigtinte möjlig att påverka utifrån för att t.ex. byta låt.Rapporten beskriver hur ett system kan designas för att lösa detta problem. Inspiration och tekniskalösningar har tagits ifrån ämnen som autonoma system där några av dess grundläggande funktioner harstått som bas för framtagande av tekniker och lösningar.

The RoHS Directive was introduced in order to restrict hazardous substances in Electrical and Electronic Equipment, EEE. It currently restricts the use of six hazardous substances/compounds; cadmium, lead, mercury, hexavalent chromium, PBB, and PBDE. The RoHS Directive currently includes category 1-7 and 10 in the categories of EEE listed in Annex 1A to the WEEE-Directive (Waste of EEE). The aim with the report is to investigate and elucidate prospects and obstacles to increase the scope of RoHS. This report mainly considers the inclusion of product categories 8 (Medical Devices) and 9 (Monitoring and Control Instruments).

En kontinuerlig ökning av tillgängligheten till Internet har lett till att flera ärenden som tidigare utfördes utanför hemmet, såsom inköp av böcker, filmer och kläder, nu även sker online. Det finns idag även flera företag som erbjuder tjänster för att signera dokument elektroniskt. Jag har i detta examensarbete valt att studera arbetsflödet för just elektronisk signering.Studien är fokuserad på företaget Comfacts lösning där de använder SMS i identifieringsprocessen. De olika stegen användarna går igenom för att signera dokument är otydliga. Genom att studera arbetsflödet för Comfacts elektroniska signering hoppas jag bringa kunskap i hur man kan utforma flödet så användarna förstår processen och upplever signeringen som enkel och smidig.Förstudien bestod av en heuristisk utvärdering av tjänsten, en konkurrentanalys av liknande tjänster samt användbarhetstester.