In the fall of 2014 a literature review and a scientific study of the topic; "... in the extent to which companies in the industry applies the evaluation of continuous improvement? was conducted at Mälardalen University. These studies are the foundation of this thesis.A strategic improvement is often divided into smaller steps of improvements at each hierarchical level from the top down through the organization. But if there is no response system that can confirm the results of these improvements back through the organization it is very hard to see if the improvements really are improvements or just changes and a waste of resources.

This work aims to obtain information on diurnal variations of aerosol concentrations in thecity of Lund (Sweden) and trying to locate the origin of the aerosols long distance transports.The study shows that the aerosol concentrations varied quit strongly over the entiremeasurement period, reflecting air masses of different degrees of pollution, mainly as a resultof the diurnal rhythm of the traffics. Trajectories reveals that air masses originated inSoutheastern and Eastern Europe contains higher aerosol concentrations compared to other airmasses..

För företag som arbetar med måttlistor och skisser och låter mönstret skapas på en fabrik kan det vara problematiskt att få plaggen att sitta som man vill. Speciellt svårt kan det vara med ärmhål, ärmkullar och halshål. Jag har arbetat med ett sådant företag för att ta fram en kappa och klänning från designskisser i sextiotalsstil med modern passform i storlekarna XS-XL. Moderniseringen innebär till exempel mer rörelsevidd, inte spetsig byst och längre ärmar. Till detta skapas plaggmåttlistor, materialspecifikationer och plaggdelsdokument för att plaggen ska vara färdigt för att produceras på fabrik.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

This work is an experimental study where knock sensor placements are investigated using engine tests. The aim is to studythe quality of the signal from knock sensors and how the signal for engine control is affected at different sensor locations on Scanias, engine DC13. To find out at witch position on the engine youcan get a usable signal for engine control, the engine is running while the knock sensors with advanced measurement equipment is connected to the engine. Evaluation of signals from the knock sensors are made in the computer program Matlab. The program is producing a seriesof plots, from these plots it is visually possible to draw conclusions and find connections.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

Research has concluded that meaningless differentiation with trivial attributes sometimes can be a successful strategy. However, the effect varies with respect to certain aspects such as the price of the product and the decision context. How the characteristics of the consumer influence the effect of trivial attributes has until now been unknown. This thesis investigates how the consumer?s level of knowledge and personal involvement influence the effects of trivial attributes on product preferences and product attitudes.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

Today more effective computer programs are in use, regarding design of geotechnicalconstructions. There is a risk that the theoretical background of the computerprograms, its limitations and the signification of the choice of soil parameter isforgotten when the computer programs become more user-friendly.This Master thesis deals with simulation and analysis regarding three computerprograms, FEM-design, with the addition Raft, Plaxis and BE-slab. Comparisons aremade for settlement and maximum moment in a concrete-plate. FEM-design is a threedimensional FEM-program, foremost created for design engineers. Plaxis is a twodimensional FEM-program, intended for geotechnical engineers while BE-Slab is aBoundary elements program in two dimensions that is mainly used by designengineers.

Even if the main purpose is to decide if the companies profitability and financial position is a determining factor for its growth, the purpose is to determine if there are any differences between big and small companies in there economical positions then they grow, in the selected industry. This thesis is mainly a quantitative study. The selected industry for the study is extraction of turf. The financial measurement that most clearly differ the growing companies from the not growing companies or the companies that didn?t change there amount of employees was the returns of the companies own capital.