Evaporation is a part of the chemical recovery department at wood pulping mills. The purpose of evaporation is to remove water from the black liquor, which makes the liquor combustible. The process is very energy demanding, and having a well-functioning model of the system is of greatest interest. The model can then be used to study energy consumption and to test different control strategies. Two models have been developed during the master thesis.

During the last years the need for real-time database services has increased due to the growing number of data-intensive applications needing to enforce real-time constraints. The COMponent-based Embedded real-Time database (COMET) is a real-time database developed to meet these demands. COMET is developed using the AspeCtual COmponent-based Real-time system Development (ACCORD) design method, and consists of a number of components and aspects, which can be composed into a number of different configurations depending on system demands, e.g., Quality of Service (QoS) management can be used in unpredictable environments. In embedded systems with requirementson high up-time it may not be possible to temporarily shut down the system for reconfiguration. Instead it is desirable to enable dynamic reconfiguration of the system, exchanging components during run-time.

Cannibalism can have major influence on fish population dynamics. A prerequisite for cannibalism is that the cannibal and the potential victim meet, and besides density effects, the encounter rate between cannibals and their victims is therefore also largely dependent on habitat use and habitat heterogeneity. In this study I quantified and compared the potential for cannibalism in stream-dwelling European grayling populations in three rivers in Jämtland by means of habitat classifications. I also analyzed population dynamic consequences of varying the potential for cannibalism in terms of intensity, using a physiological structured population model. Findings based on habitat characteristics were that the potential for cannibalism is in general not favourable in these types of streams.

The underlying question addressed in this paper is whether or not it is possible to influence the way a company?s employees behave using monetary incentives. How efficient is money as a means to enhance work motivation? Today, the assumption that employees perform better when bribed with rewards is questioned by scholars. The previous confidence in monetary reward systems is increasingly being replaced with hope for more effective programs, where employees to a greater extent can be motivated by non-monetary incentives.

The purpose of this thesis was to analyse, model and finally generate dynamic vehicular motions in a train. The objective with the analysis was to find important motions for a realistic train experience. The motions from the analysis were then weighted against possibilities for generation in a motion platform.A dynamic motion model was created to model the selected motions. The model was implemented in a simulation environment, more specifically MATLAB/Simulink. The simulation environment was used to simulate the model and to generate outputs to control a motion platform.

The advancements in digital technology and its availability contribute to the transfer of companycentricproduct development and value creation to networks or communities. It also changes the basisfor creation of customer relationships as described in previous research on Customer relationshipmanagement (CRM). The purpose of this case study was to gain an understanding of how companieslike our case study object Memoto who developed a physical product which gets added-value fromdigital product-related services looks upon product-centered communities as a way of buildingcustomer relationships. How Memoto looks upon incentives for participation in product-centeredcommunities was also examined.Our research indicated that firms in the start-up phase (which Memoto was when this study wasconducted) initially want to have more control over the process of innovation and hence have directcontact with end-customers. The reason for this is because they see a need to define the basis forfurther innovation work.

Enligt Standish Group är det endast cirka 35 % av alla systemutvecklingsprojekt som avslutas på ett lyckat sätt när det gäller tid, budget och resurser. Inom systemutveckling är fastprisprojekt, där systemets kostnad är förbestämd, allt mer populärt. Dynamic Systems Development Method (DSDM) är en modell för utveckling som fokuserar på fasta resurser och tid med funktionalitet som den flexibla variabeln. Syftet med den här uppsatsen är att se om man kan driva fastprisprojekt med en modell som DSDM på ett sätt som gör det till en bra lösning för både beställare och leverantör.Min slutsats är att det största problemet med DSDM är att få beställaren att godkänna den som projektmodell. Ett annat stort problem är att många projekt med DSDM blir stressiga eftersom tiden är fast.

On the 1st of January 2014, new legislation was introduced on taxation of shareholders in close companies. The legislation has faced criticism from several of the respondents and the purpose of the master?s thesis is to critically examine the legislative amendments made. The base of the thesis is to present the legislation within taxation of shareholders in close companies, to examine the purposes and motives of the legislator and the criticism received for the legislative amendments, as well as provide a historical perspective of the purpose of the rules. An analysis of the incentives that the legislator is providing shareholders in close companies, with the amendments, and the extent to which they reflect the purpose of the legislation.

Vertical hydropower units has a rotating mass of up to 1000 tons. For the generator and turbine to work well the rotating system is required to be centered in relation to the surrounding structure. This is achieved by means of radial bearings. The dynamic characteristics of these bearings have a strong impact on the overall rotational dynamics of the total system and thus influence the vibrations in the unit. At Vattenfall Research & Development in Älvkarleby ongoing research is taking place on how the bearing parameters should be represented in the rotor dynamic calculations.

This thesis treats the subject of a complete steady state and dynamic model of the VSC-HVDC covering both the AC and DC system-side of the converter. The topology of the model is recreated after the scheduled transmission line in the south of Sweden, called SydVa?stla?nken. The topology covers both a simple two terminal connection as well as a multi-terminal one. This model is to be implemented in the power system simulation program ARISTO.

Många barn har svårt att tillägna sig ett korrekt uttal och de kan uppvisa olika typer av uttalssvårigheter. Termen verbal dyspraxi används då uttalssvårigheterna är neurologiskt orsakade och den motoriska planeringen och/eller programmeringen av talets rörelsesekvenser är nedsatt. I tidigare forskning har behandlingsmetoden Dynamic Temporal and Tactile Cueing (DTTC) lett till förbättring av uttalet hos barn i 5-8 års ålder med verbal dyspraxi på stimuli (ord/meningar) som de har tränat på. Huvudsyftet i följande studie var att undersöka huruvida behandlingen har effekt på uttalet hos äldre barn med komplexa uttalssvårigheter inklusive verbal dyspraxi då behandlingen genomförs 20- 30 minuter, 3 dagar i veckan i 4 veckor. Åtta skolbarn (8-13 år) med nämnda svårigheter samt eventuell komorbiditet ingick i studien.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

In this study, company reconstructions and the financing of current accounts hereof are analysed from a perspective of insolvency law. The purpose with a company reconstruction is to maintain the operations of the company despite the insolvency of the mandator. In contrast to bankruptcy proceedings the person liable for payment stays in charge of the operations. However, this person is not allowed to sign for new loans, issue pledges of security for these loans or in any other way enter new obligations without the approval from the temporary company reconstructor. Besides providing for a successful reconstruction the reconstructor also has to consider the interests of creditors, especially to maintain the preferential order of the creditor's claims, keeping them unchanged in case of a formal bankruptcy.