Sök:

Sökresultat:

86 Uppsatser om Drying - Sida 2 av 6

Uppfattningar om tryckved bland träbearbetande företag i Sverige :

The primary purpose of this study has been to investigate the Swedish timber industry?s perception of compression wood. A secondary aim has been to describe particular areas within the production process where compression wood is likely to cause problems. This study has mainly been carried out as a questionnaire. In order to connect the findings to current research, additional information has also been collected by means of a literature review. The questionnaire has been intended for sawmills and wood-manufacturing companies from various production classes and owner categories, as well as from different parts of the country.

Gårdsbaserade system för spannmålshantering i den framtida Lantmännenorganisationen :

The Swedish cooperative Lantmännen Ekonomiska Förening has initiated a project labelled "Operation Blåljus" that includes an extensive program for closing down elevators. The number of elevators will be reduced from 92 to approximately 15 after harvest of 2007. The objective of Blåljus is to increase the price of grain with 10 öre/kg. A project has been initiated at the Lantmännen Grain division where the purpose is to provide the farmers with support in their decisions and practical advice how they can load a 35 ton grain truck on 30 minutes. The result from the project will serve as a support system to the farmer in his ambition to achieve cost efficient systems to load a truck with grain on the farm.

Energieffektivisering genom förvärmning av flis till kokare med sekundärvärme

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level Drying is the Drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

Ytbehandling baserad på hampolja

The varieties of paint are today very big, but many of the more popular paints are less than environmental friendly. The uses of fossilized fuel in paints are common because these paints dry fast and are color true. It would be beneficial for the environment if more renewable source were used to produce paint. Linseed oil is an old base for oil paints. It is renewable and easily procured.

Axial- och gradientkrympning hos golv på mark enligt Eurokod 2 : Sprickbredders beroende av betongkvalité, tvångseffekter och armeringshalt

AbstractConcrete foundation slabs are usually exposed to unilateral Drying during the curing process. The unilateral Drying causes an axial shrinkage and a concave curvature of the construction. The curvature results from the fact that the upper part of the slab is Drying and shrinking faster than the lower part. This is called gradient shrinkage.A problem occurs when the slab is considered fully restrained by adjoining structural parts. The deformations caused by axial contraction due to the constant part of the shrinkage and the curvature caused by gradient shrinkage of the slab are then prevented by the fact that the slab is fully restrained.

Odlingens och lagringens inverkan på utsädes grobarhet :

At seed-growing the aim is to produce a commodity with high germination capacity, good soundness and purity, and also slight admixture of seeds from other species. The capacity of germination and the vigour of the seeds may become impaired in consequence of mechanical damage, infection of diseases, growth of mould, attacks of vermin, high Drying temperature, secret germination, sprouting in the ears etc. The germ belongs to the outer and most unprotected parts of the seed, and consequently this is much exposed. Even quite sound seeds can instantaneously have low capability of germination. It can be due to the fact that the seeds are in rest of germination, i.e.

Kvistreaktioner vid förhöjd torktemperatur

I föreliggande arbete har mätningar och utvärderingar av kvistreaktioner utförts. Mätningar av kvistkrypning har utförts på furubräder och mätningar av kvistsprickor i högtemperaturtorkad gran. En fältstudie innehållande en nulägesanalys och probleminventering följdes av ett antal provtorkningar. Torkningsförloppen filmades med en videokamera för att detektera när under torkningen som kvistarna kröp. Torkningsscheman togs fram med hjälp av ett torkningssimuleringsprogram samt med hjälp av erfarenheter från industrin.

Hygienisering av torkat bioavfall

The main project Dry preservation of food waste from households includes a new technique concerning Drying and storage of dried biowaste as well as a study of the sorting of household waste and further usage of the dried biowaste. A question asked in the project is, can the dried biowaste be used as a soil amendment? If organic waste is used as a soil amendment, precaution concerning hygienic safety risks has to be accounted for. The objective of this M. Sc.

XRF-analys av förorenad mark : undersökning av felkällor och lämplig provbearbetning

X-ray fluorescence (XRF) detection of heavy metals is a cost- and time-effective method for investigation of polluted areas. Compared to laboratory analysis, XRF analysis is limited by high detection limits and uncertainties in some situations. Preparation of samples is known to affect the results of measurements.The purpose of this thesis is to bring a deeper understanding of how different factors affect the results of XRF-analysis. A large number of measurements have been made with the instruments Niton XLt 700 and Niton Xli 700. Results from measurements of lead, zinc and copper have been analysed.This study has shown that a greater moisture content will give a lower measured concentration for the same sample.

Protein i korn : En torkstudie utförd med etablerade analysmetoder på tre kornsorter

A study was performed to evaluate whether established methods of analysis of protein content in barley (Kjeldahl, Dumas, or NIT (short for Near Infrared Transmittance)) gives different results for wet and dried barley. This was carried out because there are concerns regarding the well-worn NIT prediction model giving different results for these conditions and that such an error causes significant price fluctuations on the market. By performing analyses of samples, both before and after Drying, of the three different barley varieties Tipple, Prestige, and Quench, with all the techniques, data was obtained that could be analyzed statistically. The study showed that the NIT prediction model gives results for wet barley that is about 0.29 percentage points higher compared to dried barley. This difference was also statistically significant when a t-test was performed.

Användning av rötrest från kombinerad etanol och biogasproduktion : en jämförelse mellan tre alternativ

Scandinavian Biogas is involved in the planning of a combined ethanol and biogas factory in Karlskoga, Sweden. Besides biogas and ethanol large amounts of digester residues will be produced, about 450 000 liquid tonnes residue (~7,3 % Dry Substance( DS)). The objective of this thesis was to investigate possible uses of the residue from the biogas production process ScandgasEthanol developed by Scandinavian Biogas, and to derive a methodological approach how to evaluate and compare handling systems. Three systems where proposed and compared in this thesis; spreading of the untreated residue as fertilizer (system 1), dewatering to a higher DS content to reduce transportation before spreading as fertilizer (system 2) and production of a solid fuel by dewatering and Drying the residue (system 3). The general conditions for the proposed systems were investigated in terms of practical viability, economical aspects, environmental impact and energy inputs/outputs.

Inverkan av torrsubstanshalt och temperatur på kompostens syrabildning :

Composting is a process in which organic matter is mineralized by microorganisms. In January 2005 landfilling of organic waste was prohibited in Sweden. With this prohibition composting has become an important alternative to handle the produced organic wastes. One problem with continuous small-scale composting is the production of organic acids that will inhibit a further composting process. The aim of these theses was to study what effects temperature and dry matter content had on the production of organics acids, and what effect the organic acids had on the mineralisation of the substrate as well as the stability during storage of the product.

Modellering av en panna med rörlig rost :  

The aim of this master thesis was to create a dynamic model for the processes in a solid fuel boiler of the moving grate type. Another aim with the model was to keep it as simple as possible but still able to catch the dynamics of the processes in the bedplate of the boiler. The creation of the model had its origin from Drying and combustion equations used in earlier modeling work of boilers. The represented model has been used to simulate different kinds of disturbances in a boiler and different ways to control the boiler. These tests show that controlling a number of parameters in the bed of the boiler is an effective way to keep the grate stable during disturbances.

Energy efficient storage of biomass at Vattenfall heat and power plants

Storage of biomass is often associated with problems such as heat development, dry matter losses and reduction of fuel quality. The rise in temperature can potentially cause a risk of self-ignition in the fuel storage. Moreover, emissions from storage piles can cause health problems in the surrounding. The dry matter losses and reduction of fuel quality can have economical effects. The aim of this thesis project is to develop guidelines on how to store large amount of biomass at Vattenfalls heat and power plants in an optimal way.

Methane emission from nitrate-treated tannin rich feed for cattle in Vietnam

In developing countries such as Vietnam the population consumes more animal products for example milk and meat than before which requires greater livestock production. Ruminants contributes to more methane emission which creates a dilemma between food production and its environmental impact. By feeding ruminants with nutritive crops which humans can not assimilate the animal performance will increase in terms of better growth and milk production without inpinging on food that can be consumed directly by humans. Increasing animal performance reduces methane emission in terms of amount of methane in kg-1 milk and meat which today is much greater in developing countries than developed countries. The aim of the study was to investigate tropical tannin-rich legumes for their potential as a feed supplement for ruminants made in vitro.

<- Föregående sida 2 Nästa sida ->