The purpose with this study is to compare different systems of grain storage from a financial point of view. Grain that is supposed to be fed to laying hens. The systems that were compared were different airtight storage of grain and a system of conventional storage. To make this case study I choose to compare four different systems. In the case study there was one system with bin drying of the grain, two systems with airtight storage of the grain and one system where you buy dried grain during the season. I made several of capital investment appraisal where I found the cost of each system, then I took the cost and divided it with the total grain use and calculated the cost for each kilogram of grain, and also the cost of the feed. Then I compared the cost from my case study with the cost of buying feed. All the systems except for one, gave a lower cost for the hen feed than buying feed from a dealer The best system, witch were bin drying lower the cost with about 80 000:- SEK.

When harvesting ley you hope to get a fast drying and a faster harvest. If there is a system with round bales, you need to have a dry matter close to 45 %. To make this as fast as possible, there is made a machine which pick up the grass with an pick-up. It turn the grass over and put it behind the machine (figure 2 and 4). There are few tests to prove the efficiency of this machine.

The primary purpose of this study has been to investigate the Swedish timber industry?s perception of compression wood. A secondary aim has been to describe particular areas within the production process where compression wood is likely to cause problems. This study has mainly been carried out as a questionnaire. In order to connect the findings to current research, additional information has also been collected by means of a literature review. The questionnaire has been intended for sawmills and wood-manufacturing companies from various production classes and owner categories, as well as from different parts of the country.

The Swedish cooperative Lantmännen Ekonomiska Förening has initiated a project labelled "Operation Blåljus" that includes an extensive program for closing down elevators. The number of elevators will be reduced from 92 to approximately 15 after harvest of 2007. The objective of Blåljus is to increase the price of grain with 10 öre/kg. A project has been initiated at the Lantmännen Grain division where the purpose is to provide the farmers with support in their decisions and practical advice how they can load a 35 ton grain truck on 30 minutes. The result from the project will serve as a support system to the farmer in his ambition to achieve cost efficient systems to load a truck with grain on the farm.

It?s been noted that cows held at the section of ruminant medicine and epidemiology, Swedish University of Agricultural Sciences (IME), used for the education of veterinary students, have a lower heart rate than what is considered normal for ruminants. In this investigation the heart rates of seven lactating cows were recorded continuously during the period around drying off. The first recording took place at the farm from where the cows were bought, and then their heart rate was monitored after their arrival at IME and further on until they were completely dried off. The results were then compared to the heart rate of seven already dried off cows from the same farm.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

The varieties of paint are today very big, but many of the more popular paints are less than environmental friendly. The uses of fossilized fuel in paints are common because these paints dry fast and are color true. It would be beneficial for the environment if more renewable source were used to produce paint. Linseed oil is an old base for oil paints. It is renewable and easily procured.

AbstractConcrete foundation slabs are usually exposed to unilateral drying during the curing process. The unilateral drying causes an axial shrinkage and a concave curvature of the construction. The curvature results from the fact that the upper part of the slab is drying and shrinking faster than the lower part. This is called gradient shrinkage.A problem occurs when the slab is considered fully restrained by adjoining structural parts. The deformations caused by axial contraction due to the constant part of the shrinkage and the curvature caused by gradient shrinkage of the slab are then prevented by the fact that the slab is fully restrained.

At seed-growing the aim is to produce a commodity with high germination capacity, good soundness and purity, and also slight admixture of seeds from other species. The capacity of germination and the vigour of the seeds may become impaired in consequence of mechanical damage, infection of diseases, growth of mould, attacks of vermin, high drying temperature, secret germination, sprouting in the ears etc. The germ belongs to the outer and most unprotected parts of the seed, and consequently this is much exposed. Even quite sound seeds can instantaneously have low capability of germination. It can be due to the fact that the seeds are in rest of germination, i.e.

I föreliggande arbete har mätningar och utvärderingar av kvistreaktioner utförts. Mätningar av kvistkrypning har utförts på furubräder och mätningar av kvistsprickor i högtemperaturtorkad gran. En fältstudie innehållande en nulägesanalys och probleminventering följdes av ett antal provtorkningar. Torkningsförloppen filmades med en videokamera för att detektera när under torkningen som kvistarna kröp. Torkningsscheman togs fram med hjälp av ett torkningssimuleringsprogram samt med hjälp av erfarenheter från industrin.

The main project Dry preservation of food waste from households includes a new technique concerning drying and storage of dried biowaste as well as a study of the sorting of household waste and further usage of the dried biowaste. A question asked in the project is, can the dried biowaste be used as a soil amendment? If organic waste is used as a soil amendment, precaution concerning hygienic safety risks has to be accounted for. The objective of this M. Sc.

X-ray fluorescence (XRF) detection of heavy metals is a cost- and time-effective method for investigation of polluted areas. Compared to laboratory analysis, XRF analysis is limited by high detection limits and uncertainties in some situations. Preparation of samples is known to affect the results of measurements.The purpose of this thesis is to bring a deeper understanding of how different factors affect the results of XRF-analysis. A large number of measurements have been made with the instruments Niton XLt 700 and Niton Xli 700. Results from measurements of lead, zinc and copper have been analysed.This study has shown that a greater moisture content will give a lower measured concentration for the same sample.

A study was performed to evaluate whether established methods of analysis of protein content in barley (Kjeldahl, Dumas, or NIT (short for Near Infrared Transmittance)) gives different results for wet and dried barley. This was carried out because there are concerns regarding the well-worn NIT prediction model giving different results for these conditions and that such an error causes significant price fluctuations on the market. By performing analyses of samples, both before and after drying, of the three different barley varieties Tipple, Prestige, and Quench, with all the techniques, data was obtained that could be analyzed statistically. The study showed that the NIT prediction model gives results for wet barley that is about 0.29 percentage points higher compared to dried barley. This difference was also statistically significant when a t-test was performed.

For today's young adults, the experience of being in the age period 18-30 years is, compared with previous generations, quite different. There is more room for exploring and experimenting when lifestyles and life-choices are no longer predetermined, and most things are possible for today's young people. The object of this thesis is to examine young people2019s experiences in the transition from youth to adulthood and to illuminate those experiences and difficulties that take place during this period. In the study, qualitative interviews were used in four focus groups, divided up in two age categories. The results reveal that the feeling of being an adult arises in the latter part of the period, and that variations between individuals are readily apparent.

Detta examensarbete har gjorts på uppdrag av Skanska Teknik med handledning av Johan Sjödin. Arbetets syfte var att jämföra olika limträförband, utförda av antingen spikningsplåtar eller WT-T skruvar, och komma fram till den bästa lösningen med hänsyn till bärförmåga, kostnad och utförandetid. I ett projekt har de spikningsplåtar, som används vid limträförband, börjat rosta under extremt fuktiga förhållanden fastän spikningsplåtarna är rostfria enligt tillverkaren. En fördel med WT-T skruvar är att de är gömda inne i träet och på så sätt inte i direkt kontakt med den aggressiva miljön, men även skyddad mot brand. Andra fördelar med WT-T är att utförandetiden är kort och kostnaden är lägre än spikningsplåtsalternativet.