This bachelor thesis examines the relation between countries? degree of economic freedom and their economic performance. Economic freedom as a concept is defined as the degree of market economy within a nation.The variable of measure that is used is the Frasier institute Economic freedom of the world index (EFI). The paper is built upon the Solow growth model and is extended by incorporation of additional variables; among which of course economic freedom. The study is performed through regression analysis, based on the neoclassical model both on rich countries, poor countries and on all investigated countries.Two investigations are performed: i) the impact from economic freedom on countries level of GDP per capita and ii) the impact from economic freedom on the growth rate in GDP per capita.The finding is that economic freedom can be seen as a relevant determinant of differences in GDP per capita growth rates between nations.

The dairy cow?s ability to resume estrus after calving and to conceive is affected by their metabolic status after calving. For high yielding cows there is a high risk that the feed intake will not be sufficient to cope with the increased energy demands after calving, and the cow will end up in a state of negative energy balance. Energy balance can be measured in various ways, for example by body condition score or by plasma concentration of several metabolic hormones and metabolites. After calving, endocrine pathways stimulate tissue mobilization; insulin signaling is blocked, the concentration of insulin-like growth factor-1(IGF-1) and leptin decreases, and the concentration of growth hormone (GH) increases.

In cooperation with the Gislaved company Lerocon AB [1], a separation module wasdesigned as a further supplement to the Module System. The aim of theprojectimplementation was that the separation module could be flexible enough to feed themetal pieces, screws, nuts and other items with large variations of size, appearance andmaterial composition. The module should also be cost effective to manufacture.A separation module is a design which is ment to streamline the work in industries withautomation of the lineoperations. The module feeds the details such as screws, nuts, washersand pieces of metal in a continuous flow in which traps separate the details from each other.Traps may vary depending on the purpose and of the details that are fed. Perhaps it isimportant for the user that the detail-orientation is right after the separation module, whichmeans that all the pieces witch aren´t are fed back in return.For companies and industries in lineoperations that can be made more efficient withautomation, are production flow an important watchword.

The aim of this literature study was to analyze how milk urea concentration is working as a measure of the nitrogen supply to rumen microbes and indicator of the environmental load. Questions included in this literature study were how to improve the dairy cattle nitrogen efficiency and what correlations there are between milk urea, nitrogen efficiency and crude protein content in the feed. Effects on the reproduction from high ration protein content are also addressed. Dairy cattle are today fed with large proportions of protein which could lead to high expenditure of feed and environmental pollutions. The nitrogen can be lost to the environment by different pathways; leaching, denitrification or by emission to the air.

The aim of this literature study was to analyze how milk urea concentration is working as a measure of the nitrogen supply to rumen microbes and indicator of the environmental load. Questions included in this literature study were how to improve the dairy cattle nitrogen efficiency and what correlations there are between milk urea, nitrogen efficiency and crude protein content in the feed. Effects on the reproduction from high ration protein content are also addressed. Dairy cattle are today fed with large proportions of protein which could lead to high expenditure of feed and environmental pollutions. The nitrogen can be lost to the environment by different pathways; leaching, denitrification or by emission to the air.

Wermland was affected by the Spanish flu like the Swedish national average, about a half percentage of Wermlands population would lose their lives to the flu during the autumn 1918. The flu has for many fallen into oblivion. This oblivion is so wide spread that it´s possible to talk about a "collective forgetfulness". The society have selected to remember 1918 for "when the guns went quiet on the western front" and not for the millions who died from the treacherous Spanish flu. The world had already suffered enough from the four years of war that had been fought, thus the victims of the flu would be honored but would soon fade in to oblivion.  When you investigate deeper you get the picture that the national average don´t do Wermland and its cities or rural areas any justice when a large variations seems to occur within regional areas.

This study is based on an earlier interdisciplinary study made by Redbo et al., (2000), Extensive cattle production systems ? out wintering, which lasted over two winters, 97/98 and 98/99, with two groups of heifers indoors and two groups of heifers outdoors raised in different environments, indoors or outdoors during their second winter. Both indoor and outdoor heifer groups were fed grass silage ad libitum throughout the experimental period that lasted from October until May. The objective of this study was to evaluate the long term effects of being raised in these two environments. This study includes data collected during the period lasting from the start of the experiment of Redbo et al., (2000) until the heifers had calved a second time and the results mainly deal with the performance of the animals after the experiment during their first two calvings and their first lactation.

This master thesis was carried out at Scania in Södertälje, Sweden. It investigates the possibility of changing a connector interface that is used when there is a need for splicing the wheel speed sensor and thereby determine the consequences.The problems that exist with the current connector interface occur during assembly, as more time is required to complete a connection in a reliable manner. A complete connection requires joining the male and female connector, insert the connection into a protective retainer and then strap a cable tie on each end of the retainer. This process makes it more time consuming and it requires 20-30 seconds to complete the connection. Solving this problem would save time and enable easier assembly, therefore resulting in economical benefits.This thesis was accomplished through discussions with different sections at Scania, studying available documentations, observations during assembly, writing a requirement specification and contacting suppliers.The aforementioned methods resulted in four connector suggestions, the DT and DTMH connector from Deutsch, MCON connector from TE connectivity and MLK connector from Kostal, each of them compliant with the set demands of the surrounding environment.

This study investigated the possibility of implementing three standards, Transistion Minimized Differential Signaling (TMDS) and two versions of Stub Series Terminated Logic (SSTL), for inter-chip communication in a specific manufacturing process. The two SSTL standards were implemented in one transceiver system while TMDS was implemented in a separate system. The evaluation was done with Spice simulations on schematic level with some parasitic capacitance and resistance. The idea was to investigate the possibility of implementing these standards and get an idea of eventual shortcomings. In order to create models as a basis for evaluation, simulation environments with models for circuit board and packages were created and transmitters and receivers were designed.

The purpose of this Master?s thesis is to investigate how academic librarians experience reference work aimed at international students. International students are a growing usergroup in Swedish academic libraries. The study?s main research question is:- How do academic librarians experience reference work aimed at international students?The study was performed with a phenomenographic methodological approach where seven qualitative interviews with academic librarians were conducted.

If you keep cattle in a herd outside all year round on big varying grounds, their possibilityto perform their natural behaviour increases. This way of keeping cattle requires that youprovide them with their other needs, like shelter and a dry and clean resting place.According to the animal welfare authority´s regulations on livestock farming, only animalsthat are suited to stay outside during the cold season are allowed to be kept outside. Theyshould also have access to a shelter or another building that gives them protection from theweather and wind and provides a dry and clean resting place.Research has shown that as long as cattle do not get exposed to precipitation and wind theywill manage low temperature well. Some of the things that will affect how well the animalshandle different climates are the isolation ability of the fur, the animals´ body size and thefeed intake. A dry lying place that is both insulating and moisture absorbent is also of greatimportance.

In Sweden, grass is the single largest crop grown. Nearly 1 000 000 Ha grows on the fields, this is primarily used as feed for livestock. To get a good seed, you need to handle the crop carefully from planting to delivery. The part that I have been interested in, is how to dry the harvested seed with out destroying the growth in the small seed. This is very easily done if you aren?t careful during the drying period.

Rett syndrome is a congenital neurological syndrome, which in the classic phenotype only affects girls. The symptoms include lack of speech, stereotypic movements of hands, dyspraxia and mental retardation, and these symptoms lead to communicative impairments. The purpose of this study was to examine whether the intervention method Intensive Imitation affected interaction/communication and initiative in a girl with Rett syndrome. The design of the study was a Single Subject Experimental Design with a three-week long intervention period where the girl participated daily in 30- minute sessions of Intensive Imitation together with the test conductor. Interaction, communication and initiatives were observed and analyzed before (Baseline A), during and after (Baseline B) the intervention period.

That animals should be able to express their natural behaviours, even in captivity, has become a more important issue lately. Nowadays Zoos work much more with educating people and helping conservation projects for endangered species. This is two important reasons for making the environment as natural as possible for zoo animals. Both in captivity and in the wild capuchin monkeys have been seen to use tools such as stones and sticks to get food and are therefore seen as a natural and important behaviour for them. This study was carried out to evaluate a specific sort of environmental enrichment where a group of three capuchins had to use sticks to get different kinds of food out of bottles.

There have been, in some rare cases, difficulties with clamping of inserts with U-holesin their tool holder. According to the complaints, the inserts could not be properlyclamped or could fracture when clamped. A study has shown that variations inclamping behaviour are mainly depending by the position of the screw hole in the toolholder and the centering of the screw hole in the insert.The focus of this project has been the centering of screw hole in insert. It has beenshown that the screw holes are not always enough centered in the insert. Theproblem may occur after a certain step in the production, i.e.