On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Tillsynsrond är en stor del av arbetsgången, för driftpersonal, i maskinrummet på ett fartyg. Det tillhör det förebyggande underhåll som tillämpas ombord. Idag använd till största utbredningen en metod som innefattar en färdig rondlista som skrivs ut på papper för att sedan kunna användas av driftpersonal vid rondering. Utifrån detta undersöka en ny metod för rondering till sjöss. Syftet med arbetet var att undersöka hur en digital rond uppfattas av maskinbesättningen.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

Enköping?s Rugby Club has long lacked a bigger hall to gather their members in, where they can meet and socializes outside trainings and games. Thanks to Enköping?s municipality, The Swedish Inheritance Fund, Swedish Sports Confederation, sponsors and club members the clubhouse will be built out with additional 100 square meters.The project is planned in two phases of which phase one is the buildup of the new clubhouse and phase two is the renovation of the existing part. Phase one started with the first groundbreaking in December 2006 and was finished for the season 2007.

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

Superficial digital flexor tendon injuries are common causes of premature retirement or pre-longed convalescence periods for race horses. The curve gradient at Täby Galopp race track is very small and most races as well as high speed training are done on the left rein. It is believed that the horses left foreleg is under considerably more strain then the right foreleg when being ridden on the left rein during gallop at high speed. During gallop on the left rein the horse puts its entire weight on the left foreleg when regaining ground contact. The purpose of this study has been to find out, through analyzing the statistics concerning the horses that visited the ATG clinic at Täby during a period between January 2003 and September 2006, whether there is a higher frequency of superficial digital flexor tendon injuries on the left leg rather than the right and if so, can this support the theory that the design of the race track in combination with continuous left rein races can be a contributing cause of these injuries. The result of the study shows that 57% of the tendon injuries occurred on the left front leg and 38% on the right front leg. The difference is not large enough to support the above theory of the underlying cause of these injuries..

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

I den här uppsatsen presenteras en undersökning om bruket av även fast som bisatsinledare iskrift. Syftet med undersökningen är att ta reda på om bruket av bisatsinledaren även fast harbörjat sprida sig från informella texter till mer formella texter. Syftet är också att undersökahållbarheten i ett antagande som förts fram av språkvårdare att fast i även fast uttrycker någotsäkert och verkligt i förhållande till om i även om som uttrycker något osäkert och osannolikt.Metoden består av sökningar i olika databaserade textkorpusar, lucktest till elever i årskurs 9och enkäter till eleverna och deras svensklärare om attityder till även fast i skrift.Resultatet av korpussökningarna visar att även fast verkar ha ökat över tid i vissaskriftsammanhang som i elevers skoltexter och i bloggtexter. Resultatet från elevernaslucktest kan dock varken sägas stödja eller förkasta antagandet att även fast uttrycker någotsäkert och verkligt och även om något osäkert och osannolikt. Däremot visar elevernasattityder till även fast i skrift de problem som den officiella språkvården måste ta ställning tillvid språkförändringar.

The aim with this literature review is to describe the ensilage process in a bunker silo. The process from harvest and chopping to filling and unloading the silo is explained. The sealing of the bunker silo plays an important role for the final quality of the silage. This review covers some of the techniques used. There are many silage additives on the market, some of them are presented including how they act in the ensilage process.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.