Denna rapport redovisar utvecklingen av en webbapplikation fo?r att skapa moodboards. Sy!et med webbapplikationen var att skapa ett verktyg som go?r det mo?jligt pa? ett enkelt sa?tt att spara bilder digitalt, samt samarbeta med andra i skapandet av moodboards. Rapporten beskriver hur vi arbetat med allt fra?n konceptet till utveckling av sja?lva applikationen.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

The majority of all power cuts that affects individuals and communities are caused by earth faults on the power transmission lines at 10kV and 20kV level [1]. If these power cuts could be eliminated, less disturbances and interrupts would lead to large amounts of money savings.Swedish Neutral has developed such a protection system. When an earth fault occurs power is injected into the neutral point of the transformer. The RCC (Residual Current Compensation) protection calculates a compensation current exactly 180 degrees out of phase to the fault current. Doing this, the voltage at the fault location becomes very close to zero, without affecting the power transmission.The protection system can only compensate automatically for the fundamental frequency (50Hz), and manually for the 3rd, 5th, 7th and 9th harmonics.

The City of Gothenburg has an urgent need to upgrade its public transport. The capacity of its light rail transit (LRT) has reached maximum capacity within the inner city limits years ago. The construction of an underground metro will be very expensive and time consuming due to the soft clay beneath the city. The apparent need of developing another type of mass rapid transit (MRT) is urgent. An elevated metro have turned out to be a success in Greater Vancouver, but is it possible for the system to operate well in Gothenburg with its narrow streets and current land use; will its route coexist with the current LRT or will the noise disturb people too much?.

AimThe purpose of this study was to examine the relationship between physical strain and recovery in dancers at The Ballet Academy in Stockholm, Sweden. Research questions used to guide the study were: How great is the dancers experience of physical strain? Do any of the dancers show mental or physical signs of overtraining syndrome?MethodPhysical strain was studied by letting the dancers fill out a booklet catloging their intensity during practice. Utilizing a questionnaire, data was gathered regarding preceding year. To give more nuance to the data gathered, The Profile of Mood States was used to detect possible mood disturbance.

This thesis is carried out on behalf of watermixer manufacturer Ostnor AB in Mora.The thesis deals with the area of Article Bound Instructions (ABI) at the company'sassembly department, regarding the layout and management routines involved withthese instructions.In the current situation there are problems with no uniformity in the manner in whichthe ABI is written, then referred to both the civil structure, images and specificityrates in the text.Another problem is that operators do not make use of the ABI that are available inthe current situation, and that there are no clear procedures for who has theresponsibility to write, update and change these ABI.During this work has several people that were identified as key personnel of thethesis held in order to get a handle on how the current situation of the variousobjects of the work looks like, and to examine different desires about the future ofthese should look like from the different subjects perspectives been interviewed.During the work, a number of deficiencies, including that the current program that isused to write the ABI, Lotus Notes, do not possess near the prerequisites for being asimple program to deal with when writing the ABI, which is a condition since wishesare about to put the responsibility for the ABI generation to the departmentsoperators, since their main task is to assemble and do not bother with a program in acomputer.The result of this work has generated new layout and structure of the ABI, designedto be used continuously in the assembly for evaluation, routines regardingresponsibility of the ABI for the Department of Production Engineering (PT),procedures for how the ABI should be written regarding amount of detaileddescriptions in the text and use of pictures.In addition, proposals for further work and improvements has been developed basedon experience during the work and presented at the end of the report..

This master thesis describes the development of an UPS module. UPS is an acronym for Uninterruptable Power Supply. The UPS module has been developed at the company AerotechTelub AB. The UPS module delivers the necessary voltage and current in case of a power interrupt. If a power interrupt occur, the computer system has one to three minutes available to store data and shut down correctly.

This thesis is carried out on behalf of watermixer manufacturer Ostnor AB in Mora.The thesis deals with the area of Article Bound Instructions (ABI) at the company'sassembly department, regarding the layout and management routines involved withthese instructions.In the current situation there are problems with no uniformity in the manner in whichthe ABI is written, then referred to both the civil structure, images and specificityrates in the text.Another problem is that operators do not make use of the ABI that are available inthe current situation, and that there are no clear procedures for who has theresponsibility to write, update and change these ABI.During this work has several people that were identified as key personnel of thethesis held in order to get a handle on how the current situation of the variousobjects of the work looks like, and to examine different desires about the future ofthese should look like from the different subjects perspectives been interviewed.During the work, a number of deficiencies, including that the current program that isused to write the ABI, Lotus Notes, do not possess near the prerequisites for being asimple program to deal with when writing the ABI, which is a condition since wishesare about to put the responsibility for the ABI generation to the departmentsoperators, since their main task is to assemble and do not bother with a program in acomputer.The result of this work has generated new layout and structure of the ABI, designedto be used continuously in the assembly for evaluation, routines regardingresponsibility of the ABI for the Department of Production Engineering (PT),procedures for how the ABI should be written regarding amount of detaileddescriptions in the text and use of pictures.In addition, proposals for further work and improvements has been developed basedon experience during the work and presented at the end of the report..

The object of this master thesis was to examine the significance of fairy tales for children and the extent which children today are able to share fairy tales through the activity of the libraries. The main question was: how current were fairy tales at the investigated libraries activity for children and how current were fairy tales in todays book publication? The qualitative methods used were in the form of interviews, statistics and source studies. The theoretical literature in this thesis described the folkloristic context of the fairy tales. There was also a psychological and a pedagogical view of the possibility of the fairy tales.

Inertia is often described as an unavoidable state that organisations reach when they grow to a certain size. Theorists present a number of different phenomenons, which together create the foundation for inertia. This study deals with the apparent resistance that appears among the large Nordic betting companies with regards to establishment on the electronic sports (eSports) market. The analysis is based on how the old phenomenon inertia takes place in young and seemingly flexible industries. This area has received limited coverage in current theory on inertia.

The current study sought to examine if post-produced semantic memory cues are a good aid for memory recall. It also focused on remembering units with a meaning, instead of just remembering lists of words. In the current study a factual text was used where the participants were tasked with recalling as much information as possible either with the aid of cues (keywords written by the participants themselfs), computer with Internet or no aids at all. The results showed that keywords are significantly better for memory recall. The results were discussed in regards to modern models describing semantic memory.

Arcoma is a company that develops and manufactures X-ray equipment for hospitals. One of the most crucial components is the digital detector. Due to the high cost it is made removable so it could be transferred and used in other X-ray apparatus. The detector is placed in a so called detector holder. The current detector has a rectangular shape which sometimes requires a 90 degree rotation to match the shape of the patient.

Föreliggande arbete utgör en delstudie i projektet Automatiserad telefonuppföljning inom Kriminalvården. Projektets övergripande syfte var att undersöka tillämpbarheten av Interactive Voice Response (IVR) som en modern metod för utvärdering, övervakning och påverkan av intagna som blivit villkorligt frigivna från ett fängelsestraff. IVR är en metodik baserat på automatiserade telefonintervjuer som bl. a innebär att en dator har programmerats för att ringa upp, ställa frågor, registrera svar och ge feedback till klienterna. I tidigare publikation från projektet undersöktes med hjälp av automatiserade telefonuppföljningar (IVR) hur stress och mående samt användande av alkohol och droger utvecklas under de trettio första dagarna efter avslutad anstaltsvistelse (Andersson et al, 2011).

In this study, we investigate various lighting applications in a virtual environment, where we compare between light based in naturalism (natural light) and pictorialism (artistic light). The purpose of this study is to gain further knowledge in lighting, which is increasingly important for game graphics. Theory are examined to gather information and recommendations on how to use various light settings that convey different emotions. We then use this information to illuminate the environment that we have built. The environment is presented in Unreal 4 for respondents who are allowed to move around freely in the environment.