Title: The component approach - From the harmonization process as a background to the perception of benefits and Costs as effects.Authors: Elin Börjesson & Emma KarlssonTutor: Titti EliassonKey concept: Harmonization, Component approach and Benefit/CostBackground: With IFRS for SME's as a basis, the Accounting Board developed K3 which shall apply from financial year 2014. Upon introduction of the K3 companies will be forced to apply the component approach. When K3 with the associated component approach went out for consultation it resulted in a debate where some actors opposed the imposition of a requirement and not an option. It was questioned whether the Costs with the component approach would be greater than the benefit of the implementation.Formulation of the problem: How is the introduction and use of the component approach seen by different operators from a benefit-, cost perspective?Aim: The aim of this essay is find out how the introduction and use of the component approach is seen by different operators from a benefit-, cost perspective.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in Costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

In recent years, the Swedish railway track system has been neglected in terms of capacity and maintenance. To adapt the existing system to current traffic load there is a great need for extensive improvement and maintenance. Shortcomings are especially occurring on older embankments running over soft subgrades. To select the most suitable method for reinforcement of the embankment, it is important to evaluate different solutions from a life cycle cost perspective. In long-term perspective, it is often shown that a method with low investment cost causes a higher maintenance cost and a shorter technical lifetime.

Mechanization of Swedish agriculture started in the beginning of the twentieth century, to be able to have more animals without raising the number of employers. The horse business has not by far kept up with these cost savings solutions. Cleaning out stables and feeding horses are the most time-consuming tasks in horse stables today. The most common way to clean out the stable is still by shovel and wheelbarrow. The clean out process can easily be mechanized through semi- permanently beds with movable walls between the boxes so that the litter can be removed by a tractor or a loader.

The purpose of this thesis is to describe property definition and special boundary demarcation and to analyze the differences between the two cadastral procedures. Property boundaries, especially unlawfully determined boundaries created through unofficial parcelling, can create conflicts between landowners and make it diffi-cult to know which land that a property contains of. It is possible to clarify the boundary conditions through a property definition or through a special boundary demarcation re-establish boundary marks.The methods used are: (1) A literature review to collect background information, (2) A case study to summarize court cases and (3) A questionnaire study to collect opinions from cadastral surveyors.The result is summarized in two comparisons. Firstly between restoration of landmark and special boundary demarcation (which replaced restoration of landmark in a legislative change in 2010), which demonstrated that the change in the law is considered positive because special boundary demarcation gives a legal effect on the boundaries. Secondly between property definition and special boundary demarcation which demonstrated that the two procedures are similar to each other.

A third party access to district heating networks has been proposed in Sweden, to increase the competition on the district heating market. Such third party access could create opportunities for the agricultural sector as an energy producer. This study describes the technical, economical and environmental prerequisites for a farmer cluster to build and run a heating plant, fueled with local wood fuel. The heating plant in the described scenario is 8 MW and will supply a village of 1000 houses, and is fueled with wood chips exclusively. Supplying a heating plant with fuel puts high demands on the logistics, since there need to be a continuous flow of fuel. In the scenario, wood residues from felling and thinning is stored in stacks in the forest, and a few times a year chipped and transported to a storage area at the heating plant. In the study, an estimation of the profitability has been made by estimating the cost of the investment, personnel, operating and maintenance Costs and Costs for the fuel and ash handling.

Companies that invest in e-learning have different expectations regarding the outcome of the investment. According to literature and articles it is common that companies see reduction of Costs as the primary benefit with e-learning. Therefore we ask ourselves the question if companies have attained the expected benefit of the investment in e-learning and to what extent cost reduction have been a determining factor in the investments? The purpose of the thesis is to examine if companies that invest in e-learning have attained the expected benefits. We also want to examine what the reason for investing in e-learning is and if cost reduction is the primary reason for investing. The study is founded on a qualitative method that is based on a case study in eight companies.

This paper analyzes the Swedish labor market during the interwar and early postwar period within the framework of modern labor market theory. The development of unemployment during this period - according to the commonly cited source of labor union reports - represents a conundrum for research. The unemployment rate rose after the initial diverse shock of 1921 and stayed at a permanently higher level for the rest of the interwar period. This development was reversed after World War Two when the unemployment rate decreased and stayed permanently low for the rest of the postwar period until the oil price chock of the 1970s.In a first step the available sources of unemployment statistics is investigated and compared. The general conclusion is that the labor union reports overestimate the level of economy wide unemployment while being a reasonably good indicator of movements in the rate.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in Costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

No accidents or injuries should occur because of our public health care. It should be a place with high security and good quality in order to avoid this type of accidents. This is a tough situation when the public health care organization should have as good quality as possible despite savings. It is difficult for middle managers to improve patient safety in the absence of money.The purpose of this study is to explain the work with patient safety that middle manager perform during saving times. The perspective we will look into is how they work with patient safety as an ongoing change.

The avowed aim in this project was to see how the Swedish egg production is today. My first question was if the Swedish egg producers egg production turn a profit. I have done five after calculation at five different egg producers with different systems from case to case. The difference has been the living system, the fodder and the egg price. They made a report in Uppsala, Sweden (Hoffman & Andersson, 1996), where the look forward to a Swedish cage ban and made calculations after that coming ban. After that they lift the Swedish ban of cages and the egg producers could invest in new cages who called the decorated cage.

The enterprises of today are beginning to realize that environmental issues are a important part of their activity. Companies and organizations are expected to a greater extent communicate their environmental work to the world surrounding them in a trustworthy and structured way. Lack of information or information that is incorrect may bring farreaching consequences. Communication is mentioned in several of the ISO 14001-standards. But what is missing is a guideline how companies should act to create and be sure of the quality of the data that can be used in the environmental communication.

Today Scania give a high priority to the continuous improvements on the quality of their vehicles. To follow up the flaws in product quality, which are recognized by the repairs at the local workshops, material requests are carried through to be able to analyze the defects at the plant in Södertälje ? in purpose to improve the product quality. The material requests are also carried through to compensate the workshop for their expenses and to check that they are working according to the company?s warranty manual.Due to local routines and different distribution structures at the different markets the lead times and the Costs caused by the flow of material are hard to estimate.

Machine-to-machine (M2M) communication is a phase in the digital revolution connecting computing devices with each other bringing along new business opportunities for companies. Although being a fast growing field it has not been researched to any greater extent, particularly not within the academical literature. Consequently, information on how M2M can affect organisations seems strongly needed. This thesis uses three perspectives, derived from already recognised business benefits of M2M, as an aid to select proper theoretical tools to investigate the phenomenon. The purpose of this thesis is to gain knowledge of how an M2M adoption affects a firm?s organisation, customer offerings and customer relations.

Reverse logistics is getting more and more attention both from companies and the public. It is an area with the possibility for companies to do good in the eyes of the public. This work focus on the return system of a one-way handling material called the loading ledge. The loading ledge is developed by IKEA as a substitute for the EUR-pallet in transports from suppliers with a long distance and even flow and in transports from suppliers with short distance and uneven flow. The loading ledge is made out of 100 % recyclable plastic.The purpose of this work is to find the most efficient set-up for recycling of loading ledges within IKEA on a European level from a transport and handling point of view considering aspects like cost, environment, time and, from an administrative point of view, user-friendliness.Who will the participants of the set-up be, where will they be located, which transports are needed and which income and Costs does the set-up generate, are questions that will be answered.