Swedish energy policy aims to increase the use of energy from renewable sources and this should be done in a safe, environmentally and sustainable manner. According to the Energy Agency the use bio-fuel increased by 73% between 1990 - 2006. Stands with high share of slash are often located on areas with high productivity which often are located on soils with poor bearing capacity. This will increase traffic on susceptible soil leading to increased ground damage. To reduce the risk of ground damage at slash-forwarding, ground protection is needed.

I?ve tried to find the most effective and cost effective way to harvest straw for energy recovery.You can choose between round bales and big square bales. Square bales are the cheapest way to produce straw for fuel recovery because you can optimize the length of the bales so they fit the transportation equipment.In the Malmö area the average days of harvesting hay is 55. The effectively of transportation depends mostly of the speed, the distance and density of the bales. To increase the capacity of bale transportation larger loads and higher density of the bales is necessary.

The objective of this M. Eng. Diploma work was to validate the new version, CASMO-5M, and compare the results with CASMO-4E, by using the same input in both programs. The tasks that were included in this work was to compare TIP-measures, k-effective curves (warm), k-effective curves (cold), the effect of void on k-effective, the isothermal temperature coefficient (ITC), the moderator temperature coefficient (MTC), damping ratio calculations, internal effect in a fuel bundle of a BA-rod, the speed of BA-out burn, impact of xenon, falling control rod, margins and isotopes.The TIP-measures showed that the differences were small for all reactors, at most, 6% nodal improvement by C5M (Casmo-5M) for Oskarshamn 3. The warm measurements of k-effective showed that C5M had a higher value for all cycles of Oskarshamn 1, 2 and 3 in comparison to C4E (Casmo-4E).

This study explores the different effects on attitude and behaviour three frequently used advertising techniques have. The techniques compared are social influence and egoistic and altruistic benefit-appeals. The results showed that ads featuring social influence had statistically significant higher mean values regarding attitude towards the ad compared to both the other ads, and significantly higher mean values regarding brand attitude compared to the ad appealing to egoistic motivations. Though, all advertising effectiveness measures used in this study - that is, attitude and intention variables - indicated that social influence was more effective than the other advertising messages. Thus, in accord with earlier studies, it can be stated with confidence that social influence is an effective tool to use in marketing communications..

This thesis investigates management accounting systems in a Swedish health care environment. Through a qualitative case study of an activity-based cost accounting system that was introduced in 1994 at S:t Görans Sjukhus, a large Stockholm hospital, the following questions are addressed: What benefits can an activity-based cost accounting system offer the Swedish health care providers? What are the potential problems impeding the implementation of such a system? Main findings: an activity-based cost accounting system can improve the understanding of where costs are generated in the production processes. Comparisons between alternative production processes are improved, and the data may serve as a basis for internal pricing measures. Concerning the second question, difficulty in reconciliating the principles of economic control with the culture present in a hospital is identified as the main obstacle to a new management accounting system..

Calculations are an important part of planning around a construction project. From concept to completion of the project calculation is a tool to try to predict the actual cost. During the production stage in particular, deviations occur which makes the actual cost different from the calculations.This thesis is done in collaboration with JM Residential Stockholm. The study includes a cost follow-up in which a comparison was made between the calculated production cost and actual cost for the five projects. The aim of the study was to observe the most common reasons that a project deviates from the calculated production cost and then summing these causes in a number of categories.

With a larger awareness of the climate changes and increasing electricity prices, energy efficiency measures in the industry have become more common. By rationalize the activity and by the same time decrease the emission of greenhouse gases the company can both save money and reduce negative environmental impact. For the Swedish industries the electricity price have traditional been relative low, which has resulted in a considerable larger usage than other European countries. By a deregulation of the European electricity market the electricity price will level off between the countries, which will cause a higher electricity price in Sweden than we are use to. To prevent that the Swedish industry don?t lose competitiveness against the other European countries, it will require energy efficiency activities in all different forms.ABB Sweden has decided to decrease their total energy usage with five percent in two years.

Does goodwill affect the cost of capital? Goodwill is an asset which is characterized by much uncertainty regarding both what it is and how much it is really worth. Based on economic theory about information risk and principal-agent problems as well as theory regarding the cost of capital we test for the hypothesis that debt and equity investors perceive goodwill as something risky and hence demand compensation for taking on this extra risk. The proxies used for the cost of capital are cost of debt, beta and the EP-ratio. On a general level we find that increasing the level of goodwill seems to result in higher cost of capital as represented by the three proxies.

During the past few years an increased attention has been paid to environmental issues in the construction and property sector in Sweden. In order to simplify the work with these issues a Swedish environmental certification system for buildings called Miljöbyggnad has been developed. This thesis aims to investigate the opinion of a selected number of selected property owners of Miljöbyggnad. From that basis recommendations and actions for the future work with the system will be presented.The investigation has been conducted through personal interviews with five property owners. The main issues that the interviews have been based on are their purpose, experiences, perceived complications and future prospects in terms of certification using Miljöbyggnad.The system intends to be cost-effective, simple and to offer a relevant environmental assessment of buildings and the result from the report indicates that this is largely fulfilled.

This report deals with issues related to construction waste. Building material that has not been built into the project is defined as construction waste. Cost of construction waste amounts to 4-12 % of the total cost of the project. Moreover, cost of construction waste is 1-3 % of the production cost. The aim of this study is to increase knowledge about the main causes of waste within the construction industry.

The work with this report has been focused on developing a methodology model for control at purchase. The methodology model covers parts classification, dispatching systems, batch shaping and more. The aim with the methodology model is that it will be used as an aid for a cost effective material planning to increase the value for customer.The work covers also a description of the present situation and the purchase process at Company X. Six parts have been applied, two from each class (A, B and C), in the methodology/model. The parts that have been applied are included in the flow between Company X and their supplier Company Y.Data have been collected trough literature studies, interviews and the company?s business system.

Abstrakt -  As energy prices rise, energy-saving in buildings is becoming increasingly important. By applying different construction and installation technologies, to new buildings the energy consumption can be reduced effectively, compared to similar existing buildings. These technical measures are often an investment in the long term and will reduce energy costs significantly. The purpose of this report is to show how to reduce energy consumption in a small house. It is presented in this report that both building's technical saving arrangements (the sealing of a building) and an installation technical arrangement (changing from the F-system to the FTX-system) would reduce energy consumption in newly built detached houses, if compared with a similar existing house but without these technical measures. The report presents also detailed calculations showing how much energy an existing 2-storey house, built in the year 2007 in Eskilstuna, consumes and how much energy would be saved if these corrective measures were applied to a new building. It is also reported how much money would be saved each year over a 10 year period if the measures were applied. The results show that both solutions are a good investment in the reduction of energy consumption and hence the cost involved. Keywords: energy, heat energy, infiltration, FTX-system, free temperature effectively. .

The technology used in the development of web-applications is evolving at such rate that it has become more and more important to keep web-applications modern. If an application is based on a technical platform that is not renewed, the platform may over time develop into an obstacle in further development of the application. There may be compatibility issues and some of the code may be unnecessary due to abstraction, and therefore more time consuming to work with. Sometimes the reason may be that an application has been built to run, and is running on an application server that is no longer being maintained. The system can be large and modernization can cost a lot.

Restoration projects are planned and carried out in order to reduce the impact due to anthropogenic influence and to achieve at least good ecological status according to the EU Water Framework Directive. The resilience effort of such restorations is however ambiguous. The aim of this study was to evaluate the potential of follow up restoration measures in Swedish lakes and streams. In particular, we visualized the geographical spread of restoration measures in Sweden and quantified the different types of measures that were implemented so far. Further, we evaluated the extent of sampling of biological factors before and after the restoration measures have occurred. For the purpose of our study, we used the recently compiled national database of restoration measures in Swedish lakes and streams.

The object of this essay is to discuss the relationship between the definition of the concept of gender equality and attitudes towards gender equality and their consequences for gender equality measures. The point of departure is feminist political theory and interviews about attitudes towards gender equality at a department at the University of Linköping. The conclusions of this study is that there are a wide range of definitions and attitudes, and these conceptions are not necessarily the same as those being pointed out in the official gender equality policy at the University of Linköping. In this study the opinions of measures for gender equality among the interviewed are widely spread. Some finding Swedish men and women already being equal and therefore there is no need for measures, since this would result in discrimination of men since women would gain advantages from being women.