The work that is the basis of this Master Thesis was performed on Scania´s group of cabdevelopment, and concerns the GPS-system in Scania´s trucks. Today, the GPS-systemconsists of an active antenna mounted on the roof of the truck. The antenna is connectedto the receiver with a coaxial cable.The purpose with this Master Thesis was to develop and evaluate a new GPS-system,where the information is distributed using a LIN-network. Today, each unit requiringGPS-information is equipped with its own antenna and receiver. This solution has beenthe most cost effective to this point.

Purpose:Our purpose with this essay was to see how a health promotion initiative could be profitability and how human resource cost accounting could be used for decision making. Does it cost more than it taste? Method:We have been using qualitative interviews with politicians, human health developerand accountants in a municipality. We have also collected data from a university lecturer which shows numbers from the health promotion initiative and how it is been affecting the involved staff. Result:The result show us that the politicians, human health developer and accountants all want to introduce physical exercising at work.

Swedish energy policy aims to increase the use of energy from renewable sources and this should be done in a safe, environmentally and sustainable manner. According to the Energy Agency the use bio-fuel increased by 73% between 1990 - 2006. Stands with high share of slash are often located on areas with high productivity which often are located on soils with poor bearing capacity. This will increase traffic on susceptible soil leading to increased ground damage. To reduce the risk of ground damage at slash-forwarding, ground protection is needed.

Människor utsätts idag för så mycket information och intryck att de tvingas vara selektiva i vad de uppmärksammar och påverkas av i det eviga mediebruset. Därför måste företags marknadsföring utmärka sig gentemot konkurrenterna. På tjänstemarknaden idag finns många alternativ av tjänster att välja mellan som alla påstås tillfredställa samma kundbehov. En bransch där detta gäller är lokalvårdsbranschen där alla aktörer erbjuder liknande tjänster. Av denna anledning är kvalitet en viktig del.

Swedish energy policy aims to increase the use of energy from renewable sources and this should be done in a safe, environmentally and sustainable manner. According to the Energy Agency the use bio-fuel increased by 73% between 1990 - 2006. Stands with high share of slash are often located on areas with high productivity which often are located on soils with poor bearing capacity. This will increase traffic on susceptible soil leading to increased ground damage. To reduce the risk of ground damage at slash-forwarding, ground protection is needed.

In today's society, the availability of energy plays an integral part in our everyday lives. Unfortunately, the price of energy in Sweden has increased in recent decades. A large part of our energy consumption goes to heating modules for houses, where heating methods that depend on energy sources such as electricity, district heating, fuel oil, gas and biofuels are the most common ones. During the winter period, the increase in energy costs becomes significantly evident, especially for small property owners. This increase in energy cost is most noticeable for home owners with electric heating.This thesis is written at the Halmstad University, in cooperation with a company, which makes parts of this thesis confidential.

Calculations of net present value are based on a discount rate, which requires knowledge about the company?s cost of debt. A common way to do this is by observing the company?s credit rating, when no credit rating is given it?s possible to use a synthetic rating model based on quantitative data to estimate a credit rating. Thus, the aim of this study is to increase the understanding of which quantitative data, in terms of key figures, that can be used to explain the given credit ratings for companies from the Nordic countries.In developing the model, key figures found significant in previous studies are being tested for whether or not they are applicable for companies from the Nordic countries.

An increasing number of automotive supplier companies are investing in Central and Eastern Europe (CEE) in order to gain cost advantages. This has happened in a rapid pace since many of these countries did not have any foreign direct investments (FDI) at the turn of the century. The problem now is for how long these countries will be able to maintain the low costs. One purpose was to create a model of country advantages for automotive supplier companies when relocating further production to CEE. This dissertation was written in cooperation with the Trelleborg Group.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

In this thesis a possible cost effective runner change of some of the units in the hydroelectric power station Olidan is investigated. The possibility to drive a unit at the same efficiency point through a change of the turbine shaft speed and the rate of discharge is tested. Furthermore the theories behind model testing, determination of efficiency increase from model to prototype and efficiency measurements shall be discussed and analyzed with Olidan as a starting point.A predicted curve has been built on information from model tests and field measurements on the existing runners and runner data from the test of the new model. The predicted curve shows the difference in efficiency between an existing runner and a modern one. It is the difference in efficiency that is used in the calculations that are to show whether changing to a pair of new runners will be cost effective or not.

The main aim of this study was to investigate and compare different methods for the extraction of forest fuel from environments close to an archipelago. The study was based on relevant literature and published reports as well as personal communications. Forestry has traditionally been characterized by intense efforts to rationalize and mechanize the cutting technique used for timber and pulpwood. In line with the increasing importance of forestry, more concentrated efforts can be expected in the area of techniques and methods, especially for the above-mentioned product lines. In Sweden, forestry is of major importance and the Swedish economy and standard of living have mainly been created based on the revenues generated from it. Thus, it is vital that Swedish forests are harvested in an efficient and responsible manner. The demand for biofuel is growing and today accounts for 15% of total Swedish energy production, a share that will probably increase. This study is based on three research questions, which are described under the heading of Aim. The results reveal that the most profitable method for handling forest fuel is the traditional one, which is also the most commonly used method in southern Sweden, namely the stockpiling of logs in a clearing by means of forwarders followed by splintering at the place from where they will be distributed. Today, the high cost of barge transport required for the extraction of forest fuel in an archipelago environment renders such operations unprofitable.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

This project was started within the Market-Design programme of Elforsk, with the aim of developing representative test systems of Swedish distribution networks. Using such test systems as a basis for reliability and customer interruption cost calculations makes it feasible to analyse the network tariff regulation of Swedish power  istribution companies. In particular, it enables studies of the incentives for companies to invest in system reliability. Until now, the available test systems are either not representative of Swedish conditions, or too small in scale and limited in function.Within this project we have created two test systems. In order to represent the diversity of actual Swedish distribution networks, we have created one test system for urban environments and another for rural environments.

The economic analysis of building contracts is an unexplored field within Law and Economics. This paper makes an attempt to cast some light over the subject and encourage to more research within the field. The main purpose has been to describe why the actual price in a public construction project often turns out to be higher than the contract price and offer a way of handle that risk. In the paper a model is set up that shows an optimal contract given expectations on actual price and gaps in contracts. Cost increases for the buyer can mainly be explained by two situations.

The Capturetheory wants to give an alternative explanation for the need of regulation. From this point if view the government does not have enough information to make an optimal regulation. There is a possibility for different interest groups to take advantage of the political arena by rent- seeking behaviour. An industry may be willing to be regulated to protect itself from competition. The objective of this paper is to account for the pros and cons of the theory of regulatory capture and also if it can be applied to the Swedish market of pharmaceuticals.