In order to measure the quality of the logs, one can with help of Fast Fourier Transform technique get the signals resonance peaks. With help of these peaks you can see whether the quality of a tree is good or bad. This report contains the work of a where a program has been developed to be able to process a vibration created by an automatic hammer hitting on a log of wood. From the processed signal the program should be able to show both the raw wavesignal and the processed measured data from the resonance peaks. Beyond the raw wavesignal and resonance peaks the program should also be able to control the automatic hammer.

In order to measure the quality of the logs, one can with help of Fast Fourier Transform technique get the signals resonance peaks. With help of these peaks you can see whether the quality of a tree is good or bad. This report contains the work of a where a program has been developed to be able to process a vibration created by an automatic hammer hitting on a log of wood. From the processed signal the program should be able to show both the raw wavesignal and the processed measured data from the resonance peaks. Beyond the raw wavesignal and resonance peaks the program should also be able to control the automatic hammer.

Introduction: The auditor's going-concern warnings express the quality assurance of information and if these are wrongly based, the stakeholders become deluded. Previous research has shown that auditors do not have any major difficulties in identifying companies that are financially distressed to the extent that they risk receiving a going-concern warning. International studies on the determinants of going-concern warnings have instead focused primarily on the auditor's decision regarding companies that are already in bad shape financially. Auditor grounds for issuing a going concern warning may be linked to factors related to the client, the auditor, the audit firm, the relationship between the client and the auditor and the environment. Purpose: The purpose of this study is to find out what specific factors that affect the auditor issuing going concern warnings for financially distressed companies.

The purpose of this study has been to evaluate whether a Low temperature bio-mass dryer could be integrated with the local district heating system in Malå. The aim is to increase the thermal efficiency of the cogeneration plant in Malå, by lowering the temperature of the cooling medium. Another benefit that comes from this is improved combustion efficiency at the power plant, since drying the fuel causes an Increase of the heating value.Simulations has been made in Excel, and with use of linear regression, to find out if it is profitable. Data for this purpose has been supplied by the power company Skellefteåkraft and furthermore SMHI.The result of the Calculations shows that a very efficient bio-mass dryer is needed, if yield of investments should be made possible. An Investment of 4,27 Mkr, in a dryer, could at a such criterium return 60000 kr/year, if the price of the biomass is 190kr/MWh.

Mindre företag är viktiga för den samhällsekonomiska utvecklingen och för skapandet av nyaarbetstillfällen. Lån har visat sig vara en viktig finansieringskälla för dessa företag, men pågrund av informationsasymmetri och högre operationella kostnader har tillgången tillkonkurrenskraftig lånefinansiering framhållits vara problematisk. Den externa redovisningenkan användas för att minska informationsasymmetri och reducera detta problem.Redovisningskvalitet, upplevd revisionskvalitet och revisionens utfall utgör delar av denexterna redovisningen, vilka i tidigare studier visat sig påverka företags kostnad för lånatkapital. Svenska privata mindre företag är en grupp av företag som tidigare inte behandlats idetta avseende och syftet med denna studie är att undersöka hur dessa företags kostnad förlånat kapital påverkas av redovisningskvalitet, upplevd revisionskvalitet och revisionensutfall. Med hjälp av årsredovisningar från ett stickprov om 395 slumpvis utvalda företag ochen regressionsanalys besvaras studiens problemformulering.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

This study concerns how organizations manage various problematic areaswhen implementeing Business Intelligence and experiences from BusinessIntelligence project failures on management level. In order to highlightthese questions, we have carried out interviews with four organizationswhich have great experience in working with Business Intelligence on adaily basis.The result of the study shows that all organizations deal with difficultiesregarding cost-benefit issues and justification concerning BusinessIntelligence investments. The result also showed that the organizationsfaced difficulties with integration concerning time and cost. Documentingand securing support systems presented different attitudes between theorganizations, primary in the question about sub complements to BusinessIntelligence and in the way that they were documented. In the discourse oflegal issues and privacy the majority of the organizations chose not to storepersonal information relative to legal security demands.

The purpose of this thesis is to compare if a charter company's attitude and vision of service can be reconciled with the attitudes and visions that the customers have in the same area. In order to carry out the study a qualitative approach is used. The data has been collected by interviews, focus groups and observations. The framework is theories on the subject of customer satisfaction, quality of service at customer meetings, Self-Service technologies, quality assurance and gap in service.The study has concluded that the approach to service is relatively equal between the company and customers, but the future visions differ. Focus group participants have been thinking bigger and further into the future, while the company focuses more on specific functions.

This report is a master thesis performed by Adam Lundin at the company Sandvik Coromants production facility in Gimo. The work started in January 2013 and went on for the duration of 20 weeks, which is equivalent to 30 hp. The project was executed at the department GVR10. The scope of the project was to create a base for improvements in the purchasing process of direct material to the production. The background to the project was that the centralized purchasing department has gone through changes and decision was taken to decentralize the purchasing of direct material to Gimo.