Each year, the coffee machines at Ericsson in Kista produce around 100 tons of ground coffee waste.The companies Coor Service Management, Löfbergs Lila and Selecta are all responsible for differentstages in the logistical chain in delivering coffee and, together with Ericsson, they want to increasetheir environmental benefit. The plan is to produce biogas through anaerobic digestion instead ofincinerating the coffee waste in a heating plant. The results are to be presented as different businesscases in which different biogas plants are compared with the reference case (heating plant),comparing costs and environmental impacts.There are two major environmental benefits from producing biogas; reduced carbon dioxideemissions from when fossile fule is replaced by carbon neutral biogas, and reduced emissions fromreturning digestate from the bio reactor to farmland instead of using industrial fertelizer.In order to determine the biogas potential in coffee waste, a couple of properties had to bedetermined in a laboratory. Properties such as the dry substance content, heating value, moisturecontent and ash content. The results show that 100 tons coffee waste could produce around 16 500Nm3 biogas which would contain 163 MWh.The biogas reactor and upgrade plant both need energy gas to function and uses around 14 MWh ofthe produced gas.

The defence unit´s archive stretches over a time limit between the middle of 1971 to the end of 1987. The records the archive mainly contains are concerning the civil defence, inspection and construction of shelters, war- and crisis planning. The majority of the records are registered record, as often is the case with an authority?s archives. The main problems that occurred concerned what should or shouldn´t be public, the principle of provenance and what to prioritize; finish the project before deadline or make sure the records are prepared for a storage that ideally should last for several lifetimes..

The aim of this paper was to investigate whether or not it is possible to keep bottlenose dolphins and killer whales in captivity while maintaining good animal welfare. Today, many zoos and aquariums claim that their primary function is to conserve species and educate people about conservation and threatened species. The keeping of wild animals is justified by conservation programs and by the information spread to the zoo visitors. This does however not seem to be the case for marine mammals such as bottlenose dolphins (Tursiops sp.) and killer whales (Oricnus orca) since these species are not threatened in the wild and neither of them are listed as threatened in IUCN's Red List. Bottlenose dolphins and killer whales are entirely aquatic carnivores and are distributed in all coastal and pelagic waters from the Arctic ice in the north to the Antarctic ice in the south.

The NIPF (Non Industrial Private Forest) owners in Sweden have very differentiated goals and needs with their forest. They have different backgrounds and some of them live at their forest estate while other live in an urban environment, and some are economically dependent on their forest estate while others are not. The heterogeneity among these forest owners creates problems for market actors that want to aim marketing messages to catch their interest. This is the problem background to the task that was provided to us as an investigative masters thesis for us. Their request was a plan for ensuring a successful marketing towards different segments of the NIPF owners. We commenced with a literature study based on market information and previously carried out similar investigations. We summarized the most important market information from the literature and created some hypotheses regarding goals and needs of the NIPF owners.

Nature conservation on certified small private forest owners- a comparison between the two certification systems FSC and PEFC in southern Sweden Today two different certification systems are used in Sweden to certify forest, FSC (Forest Stewardship Council) and PEFC (Pan European Forest Certification). During the last years certification of forests in general and different certification systems have frequently been debated. FSC is a globally widespread system and about 10 million ha out of 23 million ha Swedish forest is FSC-certified. The FSC-standard is mainly used by major forest companies and to some extent also by smaller private forest owners. PEFC is a European system and about 2 million ha Swedish forests is PEFC-certified today.

This thesis aims to propose a plausible design and construction of the lost gable pediments of the Glassworks Villa in F?glavik, anno 1875. Through a combination of building inspections, photo analysis and 3D modeling, the researcher utilizes the combined results to digitally recreate the decoration that once adorned the gothic revival villa's gable, to serve as basis for its actual reconstruction. The study further highlights the use of modern technological tools, such as 3D modeling software, to further enhance the understanding of historical architectural elements. The researcher also emphasizes the challenges and considerations involved in preserving and reconstructing historical architectural details for future conservation endeavors..

This paper deals with archery in the Viking Age settlement of Birka and in particular the presence of Euro Asiatic, steppe nomadic archery equipment at the Birka Garrison and one Birka grave. The equipment contains for example closed quivers and a bow case. This paper also contains a discussion of archery battle techniques and tactics in Viking Age Birka and the implications of the above mentioned equipment to this discussion. The analysis insinuates the importance and status of archery in 10th century Birka..

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.

At Sandvik Materials Technology, Argon gas is used as furnace atmosphere when heattreating hot rolled wire. Upon heating chromium steel wire, a rich oxidelayer forms on the wire surface. The abstract of this masters thesis is to enhance the understanding of the constitution of the oxidelayers and the influence of the furnace atmosphere. This will be achieved by performing a number of annealing experiments on laboratory level. Also, the aim is to understand the chemical reactions and physical mecanisms controlling the pickling process.

This study you are about to read have two investigated areas concerning the need ofsources in terms of architectural historys terminology. The investigation is based on aquestionnaire study.The first aim of this study is to describe the intergrated conservations professionalqualifications in the subject. In what condition are the knowledge of them who recentlypassed the examination, what needs do the professionals have, what kind of sources duthey use in fields and are they satisfied with the amount of sources?The second aim of the study is to find out if there are any place for developing a newsource at the market? If it is, how can a new source include the informed needs?The study came up with several needs pointed out by the professionals in the field.These needs are the groundwork of a new source that the study introduce, aarchitectural glossary of terms, made of illustrations! The point is that the new idea ofglossary will meet the needs of today, rationalise the work and improve the knowledge inthe subject..

The purpose of this paper is to investigate the process of transferring information from science to "the field" of environmental protection in Sweden. I have studied four Swedish environmental organizations, Greenpeace Nordic, WWF Sweden, the Swedish Society for Nature Conservation and Friends of the Earth Sweden to see how they search/get information. I have also studied the Swedish Environmental Protection Agency and its role as sender of information, since it is the authority which is responsible for environmental information in Sweden. I have used information and communication theories as a help to analyse my results. While working on this paper I realized that my methods were not the best.

In this final thesis a rough description of aluminium extrusion is made, the importance of temperature of both the raw material and the extruded profile for a good profile quality. The difficulty in controlling these temperatures are discussed and attempts to increase the control are described. The attempts are basically made by controlling the furnace that is heating the raw material. This is done in a manner that the raw material reaches its final temperature shortly before it is extruded. An IR-camera at the press can be used for profile temperature measurements.

The Swedish building and property management sector are responsible for about 30 % of the total energy use. In order to take environmental consideration, different environmental assessment tools and standards are used. Miljo?byggnad, Svanen, FEBY12 and PHI are some of these. There has been increased interest to certify buildings and therefore it is of interest to evaluate the assessment of the energy field to see if relevant energy aspects are assessed.

The building industry consumes approximately 40 % of the total energy consumption in Sweden, where the using stage is dominating with 80 %. There is a lot of work in progress to reduce energy use in the building industry, and the demands from authorities regarding energy use increases. As a part of this work Building and planning department of Sweden has established a requirement that has been applied since 2006, and restricts a maximum energy use for buildings.The requirement includes that an energy simulation must be done in advance to demonstrate that it is possible to meet the demands.Reality is however more complex than an energy simulation program, that frequently underestimates the energy use of buildings. The purpose of this thesisis to study and analyse deviations between estimated and actual energy use in modern apartment buildings. The study includes four apartment buildings in Stockholm, Gothenburg and Jönköping that were built in 2007-2009.