With the huge amount of computers connected to the Internet the IP-addresses are starting to run out. The Internet Engineering Task Force, IETF, have decided that it is about time to exchange the old 32 bits Internet protocol, Ipv4, to a more modern 128 bits protocol called Ipv6. This thesis explores the possibility to install Ipv6 in different operating systems. By testing various operating systems and by set up criteria compare them to each other we give the reader a picture of how the installation is done. We also show which operating systems to prefer if you want to use IPv6.

ThisreportisathesisfortheTechniciansinComputerAidedDesignprogramatHalmstadUniversity.Thegrouphasdevelopedamillingmachinemainlyusedforfiberboards,onbehalfofJohanWretborn..

Detta examensarbete är det avlutande momentet på civilingenjörsutbildningen Ergonomisk design och produktion vid Luleå tekniska universitet. Målet med projektet är att designa en helt ny skotermodell exteriört. Tyngdpunkten i projektet är utseendet men även andra aspekter behandlas, så som ergonomi, materialval och tekniska lösningar. En Internetbaserad enkätundersökning, marknadsundersökning samt systematisk problembehandling ligger till grund för designen av fyra grundkoncept. Dessa undersöks genom strukturerat konceptval samt samråd med uppdragsgivaren.

Highland Group AB was helping a customer of theirs to create an All-Terrain Vehicle (ATV), a project Highland has never been involved with before. For the wishbone arms of the wheel suspension, traditional manufacturing methods and tubes with cylindrical or square shaped cross section was preferred. We performed a simulation where the ATV was driving on a bumpy road too see the forces involved. With the results we proceeded to calculate the strength of the concepts to find out which is best suited for the tough environment in which the ATV is used. The concept that turned out to be the best was a wishbone made of circular cross section, which had good structural strength and did fulfill the demands that we required for the construction.

Företaget Radius Control Systems AB sysslar huvudsakligen med utveckling och underhåll av SCADA applikationer. Radius hade önskemål om att kunna visa väderinformation från en väderstation i Radius egna övervakningssystem Uni-View. Detta skulle ske via ABB: s styrsystem AC 800M/ 800xA, med en PM856 processor. Arbetet handlar om att upprätta kommunikation mellan en PLC och väderstation, och från PLC vidare upp till Uni-View. Rapporten behandlar hela arbetsprocessen med början från en prototyp till ett fungerande system.

This is a product development project which has developed a prototype in order to facilitate for people using mobility devices when they want to buy a larger quantity of groceries. The prototype is a shopping cart composed with the upper part of a walker.Today there are many different types of mobility devices used by elderly and people with physical impairment. According to Myndigheten för samhällsskydd och beredskap (MSB) are accidental falls the most common cause of accidents in Sweden.This project has been using Computer Aided Design (CAD) as a tool to create a visual image of the prototype. The advantage of this is to modify the functionality and performance of the prototype on the computer before the modification takes place in the real model. Using human manikins, the CAD model was rendered in natural surroundings to get as true a picture as possible.

Detta examensarbete är den avslutande delen av utbildningen inom maskinteknik på Linnéuniversitetet i Växjö under våren 2013. Arbetet utfördes i samarbete med Rottne Industri AB där skogsmaskiner utvecklas och tillverkas för skogsbruk. Projektet innefattar utveckling av en hjulupphängningskomponent kallad ?hjularm? tillhörande företagets ledande produkt, skördaren H-8. Resultatet slutade i en ny design av hjularmen med hjälp av CAD-modellering, Systems Engineering och FEM-analysering..

The purpose of this thesis is to investigate if there are environments that use some kind of central authentication system within institutions/schools. The hypothesis is that an institution not using a form of central authentication service has more need for maintenance and as such is considered a higher cost for the organization. The gathering of data has been done through interviews with technical personal at Blekinge Tekniska Högskola and Linköpings Universitet. Based on the technical background of the authors, and the system limited to discussing Windows and UNIX operating systems, a discussion and analysis of the systems working today has been done, with emphasize on the hypothesis..

The CASA-paradigm, Computers Are Social Actors, was introduced in the book "TheMedia Equation" by Reeves and Nass. One of their experiments concluded that we tend to be polite to computers in the same way as we are to people. In this study I have replicated Reeves and Nass experiment but instead of a text-based interface I have used a virtual agentin order to find out if we are polite to the agents, or still to the computer. Two experimental setups was conducted. The two setups had a common first part that was carried out on onecomputer with one agent.

Texo Application has created robots that they call for satellites; with these you can feed in storage pallets into a satellite storage. Satellite storages consist of channels in height (e.g.3 to 8 pieces) and width (e.g.3 to 100 pieces). Channels can be different long (e.g. 5 to 200 pallets). At deposit of a storage pallet the truck insert the satellite in a channel and then the pallet, the pallet is driven into the channel until it reaches another pallet or the other end.

In this report statistics concerning the reliability of sprinkler systems from seven countries has been analysed. The objective of the report has been to determine the reliability of sprinkler systems in Sweden and to present suggestions on measures to increase the reliability. The main conclusion that has been drawn is that the reliability of sprinkler systems in Sweden is 92 percent according to the analysis of Swedish statistics, and that this figure finds support in statistics from other countries. Further results are that the quality of design, installation, maintenance and inspection of sprinkler has to be improved and that the Swedish incident report has to be revised..

The thesis was done in collaboration with EAB situated in Smålandsstenar. In the initial discussion faze on doing a thesis with them there was a need to analyze and ensure the strength of an existing product, cantilever racks. This included performing FEM calculations on a model and comparing the results with physical tests.EAB has two models of cantilever racks, a light duty and a heavy duty. Within the heavy duty model series there are five product variants that differ in both size and load capacity. We will be working with the product variant with a load capacity of 1000 kg/arm which is the variant that is in the middle of the series.When we started work on the thesis we did a literature study and couldn?t find any well defined methodology that integrates both product development and computer aided design analysis.

The purpose of this report is to collect, compile and complement the scientific and experience based knowledge concerning high pressure fire fighting today. The goal is to produce a decision data for the Rescue Service concerning the use of high pressure systems for fire fighting. Focus is on hose reel high pressure systems but other systems are discussed too. The report begins by describing the technical properties of the different systems. Then the fire fighting properties are evaluated, including manoeuvrability and safety for users.

The last few years a lot of media air time has been devoted to training, sports, health and weightloss on a more personal level then before. The new media arena is beeing used at its´ maximumto broadcast wievs on how we should eat, look, exercise and live. This thesis is trying to makebetter understanding on what people in general think is important when it comes to physicaltraining and motivation with the aid of digital media and IT systems. The thesis describes aworkshop that was conducted within the frames of Participatory Design and the outcome of thatworkshop. The workshop was conducted with a group of lead users (in this case instructors at avery large fitness center in Umeå, Sweden) and the main question was ?How can IT be used toachive a positive effect on physical exercise if motivation is the focus??.

One of the aims of this report has been to make an inventory of the building trade market to see which document handling systems that are available. The secondary aim was to document the users´ demands on the systems and other demands such as quality assurance. After this, the document handling systems Byggnet and Lotus Notes, which are rather complex systems, have been analysed. Finally a recommendation has been made. In the inventory of the marketthe internet has been used because it is there the latest information can be found.