The aim of the study was to install a biogas system consisting of three tubular polyethylene biogas digesters at a rural household in Malawi and to evaluate the constructed biogas system with regards to relevant system parameters. The purpose was to evaluate if the technology is a possible solution to reduce deforestation and support Malawi in climate change mitigation and adaptation. The study was carried out in the southern part of Malawi in cooperation with the University of Malawi. Locally available materials were used to construct and install the system. Three different feed materials, cow, goat and a mix of cow and goat manure, were used in order to determine which one was best suited to utilise as a digester substrate. After the installation, measurements of temperature, pH, biogas production, biogas composition and system functionality were made. The results of the study show that a biogas system with tubular polyethylene biogas digesters can be successfully installed at a rural household and that the most suitable feed material is a mix of cow and goat manure.

Lattelement AB in Ornskoldsvik is one of the leading companies in Sweden in composite elements in walls, floors and roofs in particular. The company supplies elements to buildings located with a wide geographical variation, which means that the products are subjected to very different climate with regard to snow, wind and humidity. This places high demands and requires the elements to withstand large variable loads.The elements are made of lightweight beams with flanges of structural timber and beam webs made of OSB. These are bound together by nogging pieces with the same kind of structure. On top of the beams a nailed and glued plywood is added to absorb compressive forces and on the underside of the element a sheet of steel is added for tensile absorption.These elements are then attached to the building framework in different ways depending on the particular element height, loads and the structual supporting material of the frame work.

The aim of the study was to assess the speech outcome in children with cleft palate operated with the Gothenburg Technique at Maria Sklodowska Curie Children?s Hospital. Eighteen participants with unilateral cleft lip palate were recorded and assessed through a single word test. Percent consonants correct and cleft speech characteristics were calculated after phonetic transcription. Intelligibility ratings and velopharyngeal composite scores were reported.

The Swedish Textile industry has since the beginning of the 70-ties moved their production to countries with cheap labour further and further away. The production in the Baltic countries and Asia has become reality for many Swedish manufacturing companies. With today?s technology the communication with remote countries has ceased to be a problem. The difficulties have instead turned out to be more focused on transportation of goods and just in time deliveries to Sweden.

This thesis deals with the compatibility between analysis software Revit Structure2012 and Robot Structural Analysis 2012. The purpose is to become more aware ofinformation management models to be compatible across different softwareapplications. The structural model is made to be optimal for the compatibility of othersoftware Aim is also to gain an understanding of the transferring methods that exist,and which method is most convenient to use and to examine whether the methodswork in practice. Objective of this project is to make the modeling processtime-efficient for constructors. Models do not need to be structured in severaloccasions in different software; it only needs an optimal model that transfers properlybetween software.The method used in the thesis consist cases where the transferring process isexamined.

In the current situation a big part ofthe settlements that exist in Sweden isin need of renovation and energyefficiency in order to survive.Therefore, also many of the older houseswith a wooden structure are in a need ofenergy efficiency, which can be done ina variety of ways, including addinginsulation.This project deals with whether the useof a diffusion barrier or a vaporbarrier affects a wall structure byadding insulation to an older house witha timber frame. The insulation materialswhich are concidered in thisinvestigation are mineral wool and woodfiber insulation. Efforts are focused onthe effects of moisture on theseinsulation materials.To demonstrate the differences thatarise the moisture measurement programWUFI have been used to simulate avariety of wall designs. These designsare developed in consultation with theconstruction carers who are active inthe industry.Using WUFI graphs illustrating themoisture levels of the wall structureswere obtained and from these conclusionsvould be drawn. The work demonstratesthe differences that arise when using adiffusion barrier or vapor barrier inwall construction.

The current study aimed to test the public self-consciousness impact on creative performance. An experimental design was used in which 40 participants were randomly assigned to two groups, one of which was the experimental group and the other was the control group. A mirror was used in the experimental group to induce public self-consciousness among the participants while they performed creativity tests. A consequence test was used where the participant had to give suggestions for the given scenario "What would happen if everyone became blind?" which was then measured in the number of proposals (fluency).

The current study aimed to test the public self-consciousness impact on creative performance. An experimental design was used in which 40 participants were randomly assigned to two groups, one of which was the experimental group and the other was the control group. A mirror was used in the experimental group to induce public self-consciousness among the participants while they performed creativity tests. A consequence test was used where the participant had to give suggestions for the given scenario "What would happen if everyone became blind?" which was then measured in the number of proposals (fluency).

Fuel produced from renewable resources is of big interest. In this project the difference between a few different renewable materials are compared on the matter of environmental load when ethanol is produced. The renewable materials that are compared are Salix, straw and reed canary-grass (rörflen). The cellulose in the material is cut down to small pieces and then hydrolysed so that the sugar from the cellulose can be fermented into ethanol. Tha amount of ethanols that is studied in this work is the smount of ethanol needed to cultivate 1000 ha. The functional unit in the report is 1000 ha.

Staden Sulaymaniyah ligger i den kurdiska delen av Irak och har på senare år utvecklats då många valt att flytta från landsbygden till den centrala delen av staden. Nybyggandet sker under tidspress och långsiktigt hållbara lösningar prioriteras inte. Målet är att ta fram ett hus som är anpassat för majoriteten av befolkningen och samtidigt få ett bra och energieffektivt inomhusklimat. En faktainsamling genomfördes för att ge bakgrundsinformation till projektet. Vidare gjordes en planlösning till huset i AutoCAD vilken har använts som grund till utformningen av huset och smarta lösningar.

AbstractMotor sports have been around as long as motor vehicles have been. Sports are often seen as costly polluter but in the same time the motor sports have encourages a large part of development, both for vehicles and other industries. Inventions like rear mirror and ABS brakes come from motor sports. One way to once again drive development forward while making motor sports carbon-neutral is to run the race cars on hydrogen. In this thesis, the goal is to convert a spark ignition engine for hydrogen operation.

Staden Sulaymaniyah ligger i den kurdiska delen av Irak och har på senare år utvecklats då många valt att flytta från landsbygden till den centrala delen av staden. Nybyggandet sker under tidspress och långsiktigt hållbara lösningar prioriteras inte. Målet är att ta fram ett hus som är anpassat för majoriteten av befolkningen och samtidigt få ett bra och energieffektivt inomhusklimat. En faktainsamling genomfördes för att ge bakgrundsinformation till projektet. Vidare gjordes en planlösning till huset i AutoCAD vilken har använts som grund till utformningen av huset och smarta lösningar.

The purpose of this thesis is to collect knowledge of techniques and materials for planning roofgardens. Gardens built on top of buildings is not a new phenomenon, already in the beginning of the century architects were experimenting with roofgardens. During the Modern Era roofgardens appeared as a part of the design and worked well together with flat roofs and the ideas of light, air and greenery. Today the most common kind of roofgarden is on a ground-level joist that hides parking or other underground functions. The most important difference between planning a roofgarden and a garden on the ground is the limitation of the load of the roofgarden. Plants, paving-material and equipment must be chosen with this in mind. A light and thin layer of soil demands plants with small needs for water and nutrition.

Changes in the climate and the environment are largely consequences of human influences. Resources are given to teach adults about the environment. However, there are problems in focusing on adults because it is difficult to influence people when they already have created a lifestyle. We have instead chosen to focus on teaching children about changes in the climate and the consequences of this.Many of the toys available on the market today encourage children to consume. Luxury cars and dolls with hundreds of accessories are often made of materials that has have a negative effect on the environment.Another problem we often encountered during the year is the declining interest in technology and science.

This our bachelor thesis of 15 p ECTS. Our subject is What makes a good park? ? And how to make it better. The purpose of our bachelor thesis is to provide an overall direction for instrinsic qualities, resource (areas and materials) maintenance, visitor use, visitor experience and a basic foundation for decision-making for the maintenance and enhancement of the parks in Danderyd municipality.