In the pilot plant at Hammarby Sjöstad, Sjöstadsverket, several new methods are tested in order to achieve a good use of resources. When a new technique is considered it is often the performance of the technique itself, under given conditions, that is evaluated. However, in order to evaluate the overall function the whole picture is needed. With a system analysis it becomes possible to make a comparison where all the positive aspects are put up against the negative ones, for the technique itself as well as its requirements. In this way the influence that minor components have on an entire system can be considered.This report presents a system analysis of an anaerobic membrane reactor (MBR) with a VSEP-membrane (Vibratory Shear Enhanced Process).

The ammonia emissions are an environmental issue since they contribute to eutrophication. By far the largest source of ammonia emissions is manure from agriculture and should therefore be reduced. Loss of ammonia is not only negative for the environment but also to the farmer who loses nitrogen that could have been used by the crop. The focus of this study has been emissions from spreading slurry where the loss can vary widely depending on slurry-, soil-, and weather conditions. There are mainly two different ways to reduce the emissions. One is to inject or mix the slurry into the ground to avoid air contact. The other way is to use acid to reduce the pH in the slurry to a level between 5 and 6 where the equilibrium is so strongly pushed to NH4+ that hardly any NH3 can be lost.

Aim: The aim was to investigate the ambulance nurses experiences during a specific ambulance missions that led to usage of LUCAS ?.Method: Participating ambulance nurses were randomly assigned from a total sample group of 12 women and 39 men. Five women and five men participated. Qualitative interviews were conducted, where the Critical Incident Technique approach was used. Collected interviews were valued using qualitative content analysis.Result: Interview texts were divided into three domains, 10 subcategories could be identified which were sorted into three categories.

This master thesis was carried out at Scania in Södertälje, Sweden. It investigates the possibility of changing a connector interface that is used when there is a need for splicing the wheel speed sensor and thereby determine the consequences.The problems that exist with the current connector interface occur during assembly, as more time is required to complete a connection in a reliable manner. A complete connection requires joining the male and female connector, insert the connection into a protective retainer and then strap a cable tie on each end of the retainer. This process makes it more time consuming and it requires 20-30 seconds to complete the connection. Solving this problem would save time and enable easier assembly, therefore resulting in economical benefits.This thesis was accomplished through discussions with different sections at Scania, studying available documentations, observations during assembly, writing a requirement specification and contacting suppliers.The aforementioned methods resulted in four connector suggestions, the DT and DTMH connector from Deutsch, MCON connector from TE connectivity and MLK connector from Kostal, each of them compliant with the set demands of the surrounding environment.

The measuring of logs is important in the sawmills process to the sawn products. The technology of automatic wood measurement is continuance developing. This study has the purpose to see how the different techniques and the routines works of measure frames for determining of wood value and sorting in sawmills. The study is performed as a literature study and a survey. The survey includes some of the Swedish sawmills that produce more than 10 000 cubic meters sawed products per year.

The Stradella system on an accordeon is a complicated construction. It has readymade con-nected chords, these are major, minor, seventh and diminished seventh. To reach other vari-ants of chords you have to combine chord/bass buttons. Which advantages and disadvantages do the use of combined chords/bass buttons mean? How is the pedagogic work affected by using the combined chords/bass buttons? I have interviewed four musicians/teachers to learn about this technique.

The aim of this study is to evaluate an alternative projection of the Medial Coronoid Process (MCP) of the canine elbow joint. The projection (Di35M-PrLO) was, to my knowledge, first mentioned in an article by Haudiquet et al in 2002. In that article the projection was tested in vitro, and a good sensitivity was showed for the Medial Coronoid Process. The projection might be helpful in cases of suspected Fragmented Coronoid Process (FCP) . This study is divided into three parts. The first part is an in-vivo test of the projection, including technique and subjective evaluation of the outlining of the MCP.

Title: Veingeskolan F - Investigation of the indoor environment and a structural analysisMethod: Complete analysis of structural drawings to determine if the school have been constructed correctly. In my teorethical studies of the drawings I must seek out points that may have been damaged from moisture, this contains a full survey of the foundation, walls and ceiling. To strenghten the data collected from the drawings I must visit the school and do field investigations to find out if the school has any problems with the indoor environment.Analysis: I determined that we had some damages on specific places, these damages was caused by leaking roofs, a carpet that was tarnished by strong sunlight in connection with some type of glue and also the ventilation that may have been drawing malodorous air from a shaft in the foundation.Conclusion: I was able to see that the decision to demolish the school was quite drastic, if the county would have done continuous fixups on the construcion when the employes had complained maybe the action to the tear the school down would have been unnecessary. The lack of communication between the two parts lead up to the decision to demolish and build a complete new school..

The aim of the study was to investigate if methane emission in a constructed wetland changed in a diurnal pattern correlating to temperature, humidity or light conditions. The gas measurements were carried out with a static chamber technique. The wetland (in Nykvarn outside of Linköping, Sweden) takes care of wastewater to reduce the nitrogen loads. Measurements were carried out at three different occasions in the summer of 1998 on two sites in the wetland. One site was close to the inflow, inhabited by Lemnaceae, and another site was located further downstream inhabited by the emergent macrophyte Typha latifolia.

New high strength steels require improved cold rolling techniques. The aim of this degree project was to develop a new and money saving cold rolling technique to manufacture steel strip for saw blades. The work is based on earlier rolling experiments made with a high carbon steel grade at LuCoil Steel AB. The work also focused on the mill requirements to cold roll high strength steels. The results show that LuCoil?s existing cold rolling mill was actually designed for rolling low carbon steel.

AbstractThe purpose of this bachelor thesis is to describe the use of artificial insemination (AI) in sheep and discuss the possibilities for AI in Sweden. Male and female fertility, heat detection, semen handling and insemination techniques in sheep are described. Advantages and disadvantages of AI are discussed. In order to achieve genetic progress it is important with well planned and implemented breeding programs. The Swedish Sheep Recording Scheme and computer software from Elitlamm are the basis for sheep breeding in Sweden.

One important issue faced by companies is to secure their information and resources from intrusions. For accessing a resource almost every system uses the approach of assigning a unique username and a password to all legitimate users. This approach has a major drawback. If an intruder gets the above information then he can become a big threat for the company and its resources. To strengthen the computer security there are several biometric methods for identity verification which are based on the human body?s unique characteristics and behavior including fingerprints, face recognition, retina scan and signatures.

Over the last decades, language in the public sector has changed due to influence from New public management. In this thesis, I seek to investigate librarians? attitudes towards a more businesslike way of speaking about libraries, referred to here as management-speak. For this purpose, I?ve used a modified version of the matched guise technique.

As a part of the fight against the global warming the energy production needs to be more efficient and redirected towards sustainable options. One alternative is cogeneration, which means that electricity and heat is produced in one plant. The purpose with this survey is to examine if there are any commercial available combined heat and power techniques, based on combustion of solid moist biomass, which are suitable to small-scale applications. The technique must be able to produce between 2 and 10 MW thermal and the heat demand is a Swedish district-heating system. When already published reports had been studied, the Organic Rankine Cycle (ORC) was chosen as the most suitable technique.

Syftet: Syftet med studien var att beskriva hur omvårdnadspersonal inom kommunens särskilda boende och korttidsboende upplever att vårda personer i livets slutskede.Metod: Studien bygger på åtta kvalitativa intervjuer med undersköterskor. Datainsamlingsmetoden baserades på Critical Incident Technique och som analysmetod användes kvalitativ innehållsanalys. Resultat: I intervjuerna framkom att samarbetet till de övriga i teamet och närstående hade en stor och avgörande betydelse för hur vården utvecklades. Omvårdnadspersonalen kände ibland att sjuksköterskan saknades i vissa omvårdnadssituationer. Fördelning av personal under dygnet bidrog till kontinuitet i samverkan.