The purpose with this thesis was to examine the cold rolling mill located at Högskolan Dalarna and to stabilize the rolling process, to achieve steady state. Experiments with cold rolling of an aluminium strip have given results for rolling force, friction, reduction, strip tension and strain hardening. Results show that steady state has been found for the experiments with roll force and strain hardening, and not been found for the experiments with friction and reduction. Results show that increased strip tension gives lower roll forces. The roll force equation of Stone shows comparable results with reality for dry contact with reductions up to 30 %, but starts being incomparable with higher reductions.

Glass has sophisticated front properties and are used as facades in high buildings. During cold periods, these glass facades could cause thermal discomfort, due to cold downdraught. Cold downdraught can be countered by placing heaters under glass surfaces. Nowadays technology offers highly insulating windows, which is why there is an interest to investigate the indoor climate with only underfloor heating. The research in this area is limited, and few empirical methods are available.

The main goal with this thesis report was to come up with ideas of how to make the use of energy more effective and thus save money for the company.First a survey was made to find out where and how the energy consumers were divided within the company. The results were then used in calculations to find out how much money that could be saved and how long it would take to get back the investments.There is a big potential in saving money by recovering heat from the UV-lamps with a heat exchanger. It would also even out the pressure in the factory which is a source to heat loss and a cause for discomfort amongst the employees. It?s possible to save 105 000 kr in a year and the money needed for the investments is 600 000 kr.By using the recovery air more effectively the company could save up to 250 000 kr a year in lowered heat purchases, but this would require the use of automatic dampers.If you reschedule the running times for the wood chipper and invest in some kind of load management, for example Sydkraft?s ?Energidirigent? you can save at least 42 000 kr.

The aim of this report is to analyse the use of the capacity at the CNC (computer numerical control) cutters and show how the level of set up time for these cutters at Stålöv AB. This assignment is concrete whereas there are no subjective questions to this matter and there are only cold figures presented.Production economy is getting more important as the competition hardens and there are several different ways to increase productivity and efficiency in a company. In order to increase productivity and efficiency work studies are used to, through an analysis, find developments in methods that result in improved work methods and to establish the time that are used. Increased production of different parts and customer driven production in combination with increased demands on rationalisation of capital have led to an enlarged interest for shorter set up times in the production.To point out the use of capacity and the set up time of the cutters at Stålöv AB we used frequency studies. Frequency studies are work measure methods based on random observations on predetermined events to calculate the relative occurrence of these events.

In the western world, strokes are the third most common cause of death, hitting mainly the elderly population. Smoking, high blood pressure, diabetes and overweight are known risk factors for causing strokes. Previous studies show that an increased level of particulate matter, PM, is also related to an increased number of strokes. The population in this study consists of patients over 65 years old who live in Malmö. Levels of particulate matter were measured from October 2004 to April 2005 at a central outdoor monitoring site in Malmö.

With background in the acknowledgement of the current period of major change in the characteristics of traditional Swedish foreign policy, considering the membership in the European Union, as well as the new contextual scenarios that Sweden has been situated in after the end of the cold war, this thesis aims at scrutinizing the Swedish Foreign Policy from 1991 to 2010. The purpose of the thesis is further to localize continuity and change in the ideas which Sweden has explicitly stated in its foreign policy. Based on the theory of institutionalism, the thesis also aims to bring forward plausible explanations built on the main empirical findings. This has been done by identifying different types of goals and means within realism and liberalism as well as categorizing each theory within three ideal types.The chosen research method has been a qualitative text analysis with focus on an ideational analysis. The material on which the descriptive analysis is based upon is constituted by the annual statements of government policy in parliamentary debates on foreign affairs.The results of the thesis show that the ideas that are related to solidarity, consensus and active foreign policy are constant through the period of examination.

This report examines the prerequisites for LEDs to replace other technologies indifferent applications. How does the different technologies for light generationwork and what are the advantages and disadvantages? The various technologieslimitations and characteristics provides the opportunities for the LEDs.This report describes a test-construction built to examine what practical arrangementscan be built with modern light emitting diodes, in order to showsome of the possibilities. The construction consists of three different applications,a high power lamp based on cold white LEDs, one based on warm whiteLEDs for the evaluation of the light characteristics and a RGB-LED based lampable to mix any colors quickly and seamlessly. The test construction also containsthe essential peripherals including control-electronics, optics and a custombuilt watercooling solution.The potential for LEDs is huge but it is complicated to build LED based applicationsdue to the limitations which mainly includes the electronics and theneccesary cooling.

The scope of this project is to make a comparison of costs associated with wind and nuclear power in order to decide which one of these is the most suitable in the case of an increased demand for electricity. It is also investigated if there are other factors that can influence the choice of energy source.An average cost is calculated in terms of kronor per kilowatt-hour (SEK/kWh) using cost of investment, operation & maintenance and taxes & subsidies. Total investment cost is recalculated to production cost using the annuity method at three different interest rates (6%, 9% and 12%).The comparison is made between three cases of wind power and two cases of nuclear power. For wind power there are two ocean-based (300MW and 100MW installed capacity, respectively) and one land-based (60MW) wind farm. For nuclear power there is one EPR-reactor (1600MW) and one AP1000-reactor (1100MW).

This report describes an investigation of the indoor climate in two different workspaces. Since we a big part of our lives are staying indoors in artificial environments, and more particularly in our workplaces, we think it would be interesting to do this investigation. The technical solutions for air treatment systems began with simple natural systems without fans and where the thermal rise of the air applied. In modern time is technical air treating systems used to take care of the fresh air supply. This type of units can supply filtered air with the right temperature to the building. Well-functioning ventilation is essential to bring clean fresh air to the room and effectively remove impurities without sound- or draught problems. The indoor climate is relevant for the output capacity.

With background in the acknowledgement of the current period of major change in the characteristics of traditional Swedish foreign policy, considering the membership in the European Union, as well as the new contextual scenarios that Sweden has been situated in after the end of the cold war, this thesis aims at scrutinizing the Swedish Foreign Policy from 1991 to 2010. The purpose of the thesis is further to localize continuity and change in the ideas which Sweden has explicitly stated in its foreign policy. Based on the theory of institutionalism, the thesis also aims to bring forward plausible explanations built on the main empirical findings. This has been done by identifying different types of goals and means within realism and liberalism as well as categorizing each theory within three ideal types.The chosen research method has been a qualitative text analysis with focus on an ideational analysis. The material on which the descriptive analysis is based upon is constituted by the annual statements of government policy in parliamentary debates on foreign affairs.The results of the thesis show that the ideas that are related to solidarity, consensus and active foreign policy are constant through the period of examination.

The complex sound of someone walking in snow aren't easy to create in a studio. The best way to get the sound is to go out on a surface with real snow and record the footsteps there, but it is a complex procedure to get the right sound on the snow because snow sounds different in various temperature and various kinds of snow. It is important to find the right kind of snow to get the right sound on the foot steps. In a studio, the foley artist can create the sound of footsteps in snow by walking on different kind of material, like potato flour, coarse salt or corn flakes, the question is how realistic this materials sounds and what temperature on the snow they sound like. The results shows that the real snow (warm and cold snow) sounds most realistic and the potato flour sounds like warm and wet snow, the corn flakes some think sounds like cold snowwhile others think that it doesn't sound like snow at all and the coarse salt sounds like snow when it is around -10°C in the air, they all sounds similar in realism compared to each other.

This is an examination of how interdependence affects the behaviour of politicians and their ability to govern the way they want to. I analyze the memoirs of two Swedish prime ministers, Tage Erlander and Ingvar Carlsson to explore their experiences. I focus on how the increasing interdependence affects the politicians with regards to security, welfare, and financial policies. Sweden had a special position between Soviet and NATO during the cold war. This meant Sweden gave priority to it's neutrality policy during the cold war, compared to increased trade cooperation.

I den här rapporten utvärderas ett antal olika collaborative filtering algoritmer för att ta reda på vilken av dess som lämpar sig bäst för att implementera åt PlanEatSmile i en PHP/MySQL-miljö. Målet är att hitta en algoritm som klarar av att skapa rekommendationer i realtid och med hög precision. Därtill är det viktigt att algoritmen ska kunna skapa rekommendationer åt nya användare (cold-start-problemet) samt att algoritmen ska skala väl när sajten växer.De algoritmer som undersöks är user-based collaborative filtering, item-based collaborative filtering och tendencies collaborative filtering. Samtliga algoritmer undersöks i två versioner. En version som utgår ifrån receptbetyget och en version som omvandlar receptbetygen till  ingrediensbetyg.Algoritmerna testas på data insamlat genom en enkät för att avgöra deras precision.

In the beginning of the 1990?s ratite breeding for meat production was introduced in many European countries, including Sweden. The knowledge of ostrich farming and diseases of ratites is increasing internationally but is still often limited among veterinarians. This report consists of a literature study and a summary of pathology findings from ratites submitted for necropsy to the National Veterinary Institute (SVA) in Uppsala, during 1995 to 2001. The purpose is to give a general introduction to ostrich and ratite breeding and to give an overview of the most common diseases. The necropsy data from 1995 to 2001, indicate that many of the diseases are management related rather than caused by infectious agents. Due to cold climate ostrich breeders in Sweden need to supply well designed buildings and good care of the animal.

Today, individual indoor stalls and individual outdoor paddocks are the most common way to house horses in Sweden. The way that we manage, house and feed the horses are not optimal for the species natural basic behavioural needs. However, the awareness of this grows in the context of research and the emergence of alternative housing systems. One of the alternatives to the traditional format in individual boxes is called group housing. Group housing systems allow horses to live in herds and they can choose how they want to distribute the hours of the day between movement, resting and foraging. The purpose of this study is to examine how frequently the young horses in a group housing system use the indoor lying area.