The company Sol & Energiteknik wanted to examine the possibility to make a standardhouse totally energy independent. Based upon this I have, during the spring of 2007,examined the possibilities available at the market today through litterature studies, contactwith several companies and reading reports at the internet.The first thing to examine has been to determine the energy consumption for a standardhouse, and find out if there are better technologies to be used for energy conservation.My conclusion in this matter is that there are possibilities today for building a house moreenergy efficient.When I had reached the point at which my design for the house was decided, I also hadto choose the different products to use to produce energy as well as to store that energy.To produce heat and electricity to the house I decided to use a wind turbine and a solarwater heater.The most difficult part of designing a house that is energy independent is that theproduced energy must be stored somehow. Storing the heat is relatively easy beacuse theheat can be stored in a large water tank. The electricity is a bigger problem beacuse itmust be stored in batteries, which today are too expensive to be used in a standard house.In the future producing and storing hydrogen might be used to produce electricity, buttoday that technology is both expensive and not tested enough.My final conclusion is that a standard house can not be built to be totally energyindependent today, unless it is very expensive to connect the house to the electricitynetwork. As an alternative solution I came up with a proposal for a house which isconnected to the electricity network and have some amount of own produced energy.This house prooved to be a good investment if you choose to build it today, and it couldbe a very good investment in the long run beacuse energy prices increase every year..

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

The biogas plant Kungsängens gård, owned by Uppsala Vatten och Avfall AB, produces biogas and biomanure from organic household waste, food processing waste and slaughterhouse waste. In year 2012, 4.4 million Nm3 of biogas were produced from 25 200 tons of waste. Before digestion all substrate is sanitized by pasteurization at 70°C in order to kill pathogens. Another method, integrated thermophilic sanitation (ITS), is of interest in order to decrease the energy demand. The method implies that the substrate is sanitized during ten hours in the digestion chamber, where the temperature is 52°C.

The aim: was to describe and compare a group of experts and critical care nurses' agreement in detecting delirium in intubated, ventilator treated patients with sedation / analgesia, before and after an in house training intervention with the instrument Confusion Assessment Method for the Intensive Care Unit (CAM-ICU).Method: A quasi-experimental study, one group pretest - posttest design. A convenience sample of 17 critical care nurses in a general intensive care unit included. To detect delirium the instrument CAM-ICU was used, 21 paired tests before and 22 after an educational intervention.Main Results: The results showed that after an in house training intervention sensitivity and kappa coefficient improved of the characteristic 1 "acute onset and fluctuating course," an improvement that was significant. In other features, and overall values were signs of numerical improvement and deterioration in sensitivity, specificity and kappa coefficient but no significant change.Conclusion: Implementing a new instrument for detecting delirium in clinical practice requires education and follow-up. A small sample of critical care nurses with varying ability to use the new instrument and the fact that patients' status may change rapidly making it difficult to draw any conclusions from this study.

The energy use in a workshop company has been examined in this work in order to find areas for energy efficiency improvement. The combined oil and electricity heating in the company were compared with other alternative heating systems including cooling of the premises in following combinations:Ground source heat pump for heating and coolingDistrict heating and absorption coolingDistrict heating and low temperate surface water coolingEnergy use, operation costs and carbon dioxide emissions were calculated for the current heating systems and the three alternatives including cooling. The ground source heat pump for heating and cooling decreases bought energy with 34 MWh annually compared to current heating only. The district heating and low temperate surface water cooling has the largest reduction of operation cost and carbon dioxide. The operation cost decreases with 42 kSEK and the carbon dioxide with 43 metric ton CO2 annually.

Metoder och system för mätteknik får en allt större betydelse för moderna tillverkningsföretag. Allt fler företag har insett det strategiska värdet av en förbättrad kvalitetsuppföljning för att minimera kostnader på grund av kvalitetsbrist. Syftet med denna rapport är att ta fram en strategi för standardisering av kontrollmätningen vid den nya typ av mätplats, en Q-plats, som ställts upp inom avdelning DXMH vid Scania Transmission. Q-platsen ger möjligheter för operatörerna att i större grad själva genomföra kontrollmätningen i närheten av produktionslinjen. I rapporten analyseras först Q-platsens funktion utifrån en studie av Scania Transmission DX, dessutom redovisas fallstudier på andra avdelningar inom Scania och vid andra tillverkningsföretag.

The need for snow-free surfaces at squares, bus stops, platforms, car parks and sports facilities increases and at the same time energy price rise and the environment is becoming a hotter issue. The construction of the ground heating systems often lack thermal insulation under the heating pipes, which means that the heat from the pipes not only warm up the soil surface but also heats the surrounding soil. The insulation also has more features, by insulating the risk of frost damage is minimized. The goal of this report is to demonstrate the large heat loss and energy costs in the absence of insulation under the heating system.The report begins with a scientific way to study and treating the soil heating system uses, and the theory involved. Furthermore it also deals with different routing principles of heat pipes depending on the facility.All calculations are made with so called finite element method (FEM), in COMSOL Multiphysics 3,5a, where models are created with different conditions.

In modern industrial robots the components in the transmission contain nonlinearities. These nonlinearities need to be to estimated either for better control or to use the parameters for diagnosis of the system. There is a lot of work done within system identification and mainly within the field of iterative parameter estimation.This thesis considers recursive grey-box identification for a nonlinear model of the transmission in an industrial robot. The nonlinearities that are identified are friction, spring stiffnes, hysteresis and backlash. These nonlinearities are a part of the models that are presented in this thesis.

The biogas plant Kungsängens gård, owned by Uppsala Vatten och Avfall AB, produces biogas and biomanure from organic household waste, food processing waste and slaughterhouse waste. In year 2012, 4.4 million Nm3 of biogas were produced from 25 200 tons of waste. Before digestion all substrate is sanitized by one hour?s pasteurization at 70°C in order to kill pathogens. Another method, integrated thermophilic sanitation (ITS), is of interest in order to decrease the energy demand.

Heat stress negatively influences the performance of dairy cattle such as lactation and reproduction. Heat stress can cause production losses as well as welfare problems. Years of research have shown that heat stress is a huge problem for dairy cattle in both the tropics and temperate zones but no such research have so far been done in northern European countries. It seems like shade is an important tool when improving pasture conditions and therefore deserves more attention. The aim with this study was to investigate whether there is a need of providing shade for grazing dairy cows during the summer in Sweden. Two groups of lactating Swedish Red dairy cows (n=15 per group) were kept on pasture.

Finnhamn is a small group of islands in the Stockholm archipelago. At Stora Jolpan, the biggest island, there is a hostel. The main building was built in 1915 and is called Utsikten. The purpose of this project is to on behalf of the Archipelago Foundation (Skärgårdsstiftelsen) find alternative systems that can replace the existing heating system of Utsikten (an oil-fired boiler and electricity heaters) to a system with renewable energy. The alternative system that this project focuses on is a system of solar collectors combined with a wood chip boiler.

A district heating plant has the advantage that it can take advantage of the waste heat from industries and use of cheap fuels to produce heat. But for the long term is competitive requires that energy is also saved in district heating plants. One way to save energy in a district heating system is to increasing cooling to the return temperature. This leads to less power needed to drive the distribution pumps,  and that more energy could be extracted from the same amount of fuel by an improved flue gas condensation.In Karlskoga the return temperature into the district heating plant is high. They would therefore reduce the return temperature in order to extract more energy from the flue gases.

Husaberg Scandinavia AB is a company producing and developing a range of motorcycles for both on- and off-road use. Husaberg provided the project group with a task of developing an entirely new way of operating the sequential transmission that can be found in today?s motorcycles. The target was to bring the product from idea to a functional prototype ready for further tests. Operation of the motorcycles transmission is today made by a foot pedal placed on the left hand side of the bike.

Kompaktaggregat är ett integrerat FTX- och FVP-system som används i passivhus. Vi har gjortenergiberäkningar i programmet VIP+ för att se hur kompaktaggregatet skulle kunna fungera ipassivhus i Sverige.De resultat vi har fått fram ur VIP+ visar att passivhus med ett installerat kompaktaggregat klararav att nå passivhuskraven ända upp till Skellefteå. De beräknade värdena understiger kraven förpassivhus, men en viss marginal behövs för att kraven ska nås även efter uppförandet avbyggnaden. Vi har även tolkat tekniska uppgifter på ett sätt som enligt oss har en positiv effektför passivhus på kallare orter. Därför tror vi inte att värdena för de tre nordligaste platserna ärhelt tillförlitliga.

Syftet med detta arbete är att analysera hur Ringhals reaktor II kan ersättas med hållbar energiproduktion. Detta görs genom att analysera vilka produktionstekniker som är kommersiellt gångbara i Sverige. Sedan analyseras dessa utifrån dess geografiska och tekniska begränsningar i regionen Västra Götaland och Halland för att bestämma hur den nya energimixen kan utformas. Utifrån energimixen simuleras sedan energiproduktionen i elzon 3, SE3, under varje timme över ett år för att undersöka om den nya produktionen kan möta efterfrågan och huruvida elnätet kommer att belastas hårdare på grund av eventuell ökad transmission till/från andra delar av landet. Från energimixen beräknas även vad produktionskostnaden för elektriciteten blir för den alternativa produktionen. Resultatet visar att den föreslagna energimixen klarar av att ersätta energiproduktionen från Ringhals reaktor II med endast en marginell ökning i transmission till/från regionen.