When rubber equipment in a milking system ages, physical and chemical deterioration occurs and cracks, crevices, as well as deposits of organic and inorganic material is formed on the surface. Bacterial colonization can accumulate, especially on ageing rubber equipment and if the cleaning procedure is not functioning properly. Formation of biofilm in milking equipment could in turn cause bacterial contamination of bulk tank milk. ATP bioluminescence is a fast and easy way to determine the hygienic status of a surface based on its ATP content, and results are given in relative light units (RLU). The method measures both bacterial contamination as well as residues from other organic material.

The last decades have shown increased nitrogen leeching from soil to water recipients. This is inSweden mainly due to over-manuring of agriculture land, effectivization of drainage systems and thedeclining extent of wetlands. The accumulated amount of nitrogen in water doesn?t only make itunsuitable for use by humans and cattle, but also decreases the biological diversity as well as negativelyaffect tourism and fish industry. In the most severe cases shallow maritime grounds can be completelydepleted of oxygen due to decomposition of the increased amount algae and plankton growth.This study have the aim to describe and quantify the nitrogen leeching from the Genevad drainagebasin, located in southern Halland, Sweden.

The idea with constructions made out of prefabricated elements is that it should be quick and easy to build as the demands for lower production costs, increased profitability and shorter production times are constantly increasing. High accuracy in measurements and well-balanced tolerances is required to achieve this. The fact that the concrete-elements doesn?t fit and that damage occurs during assembly is a highly topical issue even though we now have methods and systems that make this high-intensity construction possible. Through this report we want to highlight the problems that cause the dimensional and tolerance problems and give suggestions on how to come to terms with these.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

This master thesis investigates the possibilities of using GPS-information from trains to create a model of a railway system, register the routes of the the trains and predict how the trains will travel in the railway system.The thesis work was done at Icomera AB which is a company that specializes in internet connected vehicle solutions.We describe how the GPS-information is sent from the trains in the form of samples and investigate limitations and possibilities with the available information. About three million samples from 83 SJ-trains were analysed and the samples were filtered with the intent of removing erroneous information. We here found that about 30 % of the samples from the trains were unreliable.A solution for how the samples from the trains can be used to create a model of the railway system traveled by the trains is presented. We use a large set of historical samples and use Cluster nodes and Hermite curves to generate a graph that represent the railway system with stations, nodes and the railway itself. A fully automatic solution is not presented since it did not fit into the time frame of the thesis; instead we created a simple tool which can be used to manually finish the model of the railway system.Furthermore, we describe how the railway system and the samples from the train can be used to register the routes the trains travel.

AbstractTitle:HelpTube: A Study on the Motivation behind Crowdsourcing with STD & Motivation Functions for Volunteer Work as Explanatory Models. Level: Bachelor Thesis in Business Administration; C-level. Authors: Honey H. Shahraki & Linnea M. Pira Supervisor: Jonas Kågström Date: 2013- June Background: In recent years the trend and usage of social networking has increased significantly amongst individuals as well as businesses.

Igf2 (insulin-lik tillväxtfaktor 2) och H19 är präglade gener hos däggdjur. Präglade gener uttrycks ojämnt; den allel som ärvts från den ena föräldern uttrycks mer än den från den andra. Igf2-genen kodar för en viktig embryonal tillväxtfaktor och uttrycks till protein bara från den paternella allelen. H19 transkriberas bara från den maternella allelen, men translateras inte till protein. Igf2 spelar en viktig roll under dräktigheten, då den bidrar till tillväxten av både placenta och foster och reglerar såväl näringstillgång och tillväxthastighet för embryot. Enligt en teori kallad ?the genetic conflict theory? (~konflikten mellan genomen) så ligger det i honans intresse att fördela resurserna jämnt mellan alla syskon.