AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

The purpose of this report is to increase the awareness about the problem that occur when the waste hierarchy is applied to management of contaminated land. The work with remediation of contaminated land in Sweden is part of the efforts towards reaching the national environmental objectives. Therefore a subsidiary aim is to analyze how this influences the prospects of reaching the objectives. The work consists of two parts; a case study and a comparative literature study that focus on England, the Netherlands and Sweden. The case study is intended to provide a practical perspective through a comparison of the climate impact from two methods.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

Background and research problem: The former highly inflationary property market is currently undergoing a stagnation process. Investors have been used to annual growth figures in double digits,but now this is no longer considered to be a realistic outlook for future years. According to a report from PriceWaterhouseCoopers and Urban Land Institute, published by Avanza Wealth Management,the three most attractive markets for property investment in Europe are London, Paris and Stockholm. Because of this the authors have focused their investigation on two companies in the London andStockholm. The authors will additionally use an international bank, an estate agent and a consultancy firm for further information, with regards to the property market and risks associated with these typesof investment in particular.

Sale and acquisition of a business is risky, since vague legislation and lack of literature often contribute to the fact that it is not possible for the parties to know beforehand how a dispute about the agreement shall be resolved. The objective of this thesis is to clarify what should be applied in terms of liability and the allocation of risks between the parties, in order to help avoid disputes about the agreement. In order to fulfill the purpose of the thesis, the legal status of the agreement has been investigated, as well as the question whether the sale of goods act should be applied, even though the sales agreement between the parties should be the primary regulation. Furthermore, another question that has been investigated is whether the buyer?s duty to investigate, and the seller?s duty to inform, affects the allocation of risks between the parties, and thereby also their liability..

This masters thesis concerns a modeling project performed at Volvo Technology in Gothenburg, Sweden. The main purpose of the project has been to develop a physical model of the climate in construction vehicles that later on can be used in the development of an electronic climate controller. The focus of the work has been on one type of wheel loader and one type of excavator. The temperature inside the compartment has been set equal to the notion climate. With physical theories about air flow and heat transfer in respect, relations between the components in the climate unit and the compartment has been calculated.

A large amount of our time is spent indoors in an artificial climate. To make the experience pleasant there are requirements on the ventilation and the heating system. At the present time the most common form of heating is a radiator system complemented with a ventilation system. A ceiling heating system with combined heating and ventilation can replace the two separated systems. The benefit with a ceiling heating solution is that it saves space since the radiator system is no longer needed.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

Intergovernmental Panel on Climate Change (IPCC) recognizes glaciers as the best land-indicator of climate change. A variety of studies have concluded, using both modeling and field studies, that above all climate parameters precipitation, particularly winter precipitation, and summer temperature controls the change in glacier mass balance. With global warming almost all glaciers on Earth are losing mass. In this study, the summit-glacier constituting Kebnekaise's south summit (called the Southern-summit henceforth), Sweden's highest point, is studied to see how it is affected by winter precipitation and summer temperature during the period 1968?2013.

This thesis aims to present the essential background on how to perform climate changeimpact assessments, and to present the results from a climate impact assessment on waterbalance and nitrate leaching for an arable Swedish soil. The soil is a sandy soil in southwesternSweden, grown with spring cereals. This study is meant to be a benchmark example,and cannot be seen as a regional or national assessment for Sweden, rather as an approachto present and analyze the most important parts of these kinds of assessments.A dynamical simulation model (COUP, Jansson and Karlberg, 2004) was used for thisstudy. The model was parameterized and calibrated against data from an experimental site,located in Mellby in Hallands county, south western Sweden. Measurements were carriedout between 1st of April 1988 and 1st of April 1991.

The aim of this report is to investigate, on the basis of two consult agencies perspectives, what the possibilities and obstacles are to integrate the work with antagonistic and accident related risks. The report is based on two consult agencies where each agency´s work procedure is represented by a risk management method. The work with accident related and antagonistic risks is analysed and evaluated compared to four different components. The components are risk management process (IEC´s and FEMA´s model), driving forces, education and competence, and resources to control risk management with COSO?´s ERM framework.

Few issues have been exposed in media recently as much as the climate change issue. Afterthe documentary film ?An Inconvenient Thruth? presented by Al Gore was released in 2006,most of the world saw a lot of attention directed towards global warming. This was a turningpoint that is refered to in this dissertation an history-graded critical event, which is assumed tohave a significant impact on peoples lives.The purpose of this dissertation is to examine whether or not political parties in Swedenresponded to this critical event in the way that they, in their party programmes, haveformulated policies related to climate change. Alternatively if media produces an image ofpolitical activity which does not comport with the forming of actual political standpoints.

A major issue that has been a subject for quite some time is whether there will be a scarcity of metals in the bedrock in the future and whether or not we might end up with a problem similar to that of the big oil crisis in the mid-seventies. Following the oil crisis many oil companies started up with risk management to control future risks. This work presents how Swedish mining companies work with risk management to handle risks that might come up in the future due to metal scarceness. How Swedish mining companies look at the possible metal scarceness and if they use risk management in their decision-making process is studied. By doing interviews with Swedish owned mining companies it was found that the mining companies did not see the future metal scarcity as a risk, even though 2/3 of the companies acknowledged the scarceness to be a reality.

This thesis aims to illustrate how environmental impact can be reduced, through the use of lean concrete. It also illustrates how environmental data can be applied to a house through implementation with BIM. In this study a unique concrete structure developed by Swedish Cement and Concrete Research Institute is assessed for environmental impact, by calculating the carbon dioxide equivalents using LCA methodology. The construction is a sandwich element where the concrete is made ??up of three layers.