This study is about the potential advantages as an investment option in a portfolio. The study shows that the incorporation of bitcoins in a portfolio, even to a small degree, gives significant increases of both risk and return. The different studied portfolios sharpe ratio rises, which in turn shows that the risk reducing return increases when bitcoins is used as an investment option.This study is based on Virtual Currency, Tangible Return: Portfolio Diversification with Bitcoins by Brière, Oosterlinck and Szafarz. The authors of this study have compared their own results with the study mentioned and seen its similarities and differences. The study investigated a total of eleven different assets percentage return over 192 weeks ranging from July 2010 to March 2014.

This master?s degree project concerns the combination of a multi dwelling passive house with solar energy for the generation of electricity and domestic hot water (DHW). Different alternatives with either solar thermal systems or photovoltaic (PV) systems are compared with two reference alternatives producing DHW from electricity or district heating. The economical comparison uses a life cycle cost (LCC) perspective based on the present value of expenditures for investment, energy and annual operating and maintenance.The energy yields from the solar energy systems were calculated by hand and with simulation software. Calculation and dimensioning of PV systems were carried out with a software called PVSYST.

At the Division of Electricity at UppsalaUniversitythere are ongoing researches, including a research concerning turbo generators.Turbo generators produce a large share of electricity in the world; however they are costly mainly due to the fact that the cooling and ventilation that are needed to eliminate the excess heat from the generators are expensive. Turbo generators work with high efficiency and in this project, the main task is to simulate a generator while taking into account that the generator must be designed against self-oscillation, centrifugal force, exhaustion and heat. The turbo generator must be simulated without being too expensive and complicated.In this project, the dimensions of the turbo generator depend on the efficiency of it, and where the losses are in the generator. Furthermore, the optimum values need to be chosen with the help of the ACE simulation program. The report begins with an introduction describing the project followed by a task description that is dealing with the project.

The main object of this diploma work thesis is about how computer programs can bea tool to use for work on stormwater investigations. The advantage of using acomputer program compared with calculations made by hand is evaluated anddiscussed. The computer programs that have been used for studies and a sequence oftesting of the possibilities are Autodesks Storm and Sanitary Analysis and DHIs MikeUrban.Focus on sustainable development now permeates the building industry. As a resultstormwater investigations have been conducted in an increasing extent the recentyears. Stormwater is water produced due to precipitation, such as rain and snowmelt.Stormwater investigations normally contain descriptions of existing land use, plannedland use and suggestions of measures and technical solutions for the future disposal ofstormwater.The initial part of the thesis consisted of literature studies on stormwater andstormwater investigations to understand the science.

The Stockholm office market segment have for a long time been considered a safe havenwhen it comes to withstand negative turmoil in the form of rental compression due toeconomic fluctuation, especially in the CBD demographic. Recently however, a large numberof banks and institutions, amounting to some 200000 square meters, have decided to relocateto more peripheral locations with the aim of cost reductions on rent. This mass exodus isstudied with focus on rental dynamics as the result of increased vacancies. Other variables arestock changes and employment. The method is econometric combined with an interviewseries.

This thesis describes how the development of a mechanical enclosure to an alarmsystem proceeded. The project was made on behalf of Inferno Light Indusec AB.The goal set to this housing would offer a home alarm in which Indusec?s uniquesound system would give the customer a new alternative on the market. They wantedto, among other things, create an aesthetically but at the same time affordable alarm.The aesthetic theme is something that is missing in today?s market.

The E-department at GETRAG All Wheel Drive in Köping have problems with the efficiency on parts of their production equipment. The equipment with the most significant efficiency problems are four automated multifunctional production cells that produces housing for rear drive units. The major part of the problem is the large amount of small stops that causes the low efficiency.The department already worked with logging of interruptions and efficiency calculations before this project started. However this work was not done to the extent considered necessary for a systematic follow-up of the interruptions.The aim of this paper is to point out a more effective and systematic way to work with logging of interruptions and the follow-up. In addition the equipment were studied with a method for efficiency calculation that ? if used properly- is a more powerful and a visually better method than the one used by the company today.As the initial current state analysis of the equipment was made a lack of documented knowledge about the equipment was discovered.

The design of the building envelope affects the energy consumption of a building. As the energy requirements for new buildings are becoming more demanding, the performance of the building envelope must be improved. Energy efficiency and durability are important attributes to consider.This report includes investigations of the building envelope, moisture and passive solar energy. It is based on the analysis of two different buildings with different designs. These buildings stand as reference for two of the companies who are working on a new, climate smart, residential area in Uppsala, Sweden.Studies and analyses on energy consumption and moisture transportation were made.

Present master of science thesis has been carried out at the Swedish Road Administration consulting services (Vägverket Konsult) in Karlstad. The purpose of the study is to investigate how well the calculated drawdown of the groundwater table predicts the actual drawdown when the road and railway gates at the studied sites are built. For this purpose the groundwater levels at the three bridges were measured during 6 months. The bridges in question are two railway bridges situated in Ölme and Ulvåker and one road bridge crossing a pedestrian and cycling path in Lidköping.In Ölme the calculated area of influence was smaller than the measured one. It differed up to 30 meters, i.e.

Lattelement AB in Ornskoldsvik is one of the leading companies in Sweden in composite elements in walls, floors and roofs in particular. The company supplies elements to buildings located with a wide geographical variation, which means that the products are subjected to very different climate with regard to snow, wind and humidity. This places high demands and requires the elements to withstand large variable loads.The elements are made of lightweight beams with flanges of structural timber and beam webs made of OSB. These are bound together by nogging pieces with the same kind of structure. On top of the beams a nailed and glued plywood is added to absorb compressive forces and on the underside of the element a sheet of steel is added for tensile absorption.These elements are then attached to the building framework in different ways depending on the particular element height, loads and the structual supporting material of the frame work.

Energy costs are high nowadays and that is the reason why the energy consumption needs to become as small as possible in most of the companies. To accomplish the small energy usage one needs to map the energy flows, study them and monitor them. One method that can be used for this is energy balance calculation. The method gives an opportunity to separate different energy flows and see where each flow is heading. There is also another method which is more advanced than energy balance calculation.

An important process for grid companies in order to reduce power losses in electricity distribution grids is to figure out where and how they appear. This report describes the factors that cause power losses in low voltage distribution grids and methods for how they could be measured and analyzed. Measurement data for consumed and injected energy were collected for twelve low voltage distribution grids owned by Gävle Energi AB in order to analyze the size of the power losses and how the measurement uncertainty affects the collected data. Then models of three of the grids were created in MATLAB in order to analyze the data and the power losses were calculated to be compared to the collected data. Curve fitting were also used as a method in order to analyze the power losses from collected data.The results show that the losses in the studied grids are low.

This report relate a concept study that consider a number of different proposals to improve the overcharging system in BAE Systems Ha?gglunds tracked vehicle series BvS10, to maintain sealevel power at extreme altitude.At high altitude the power losses beacuase of the air density that decreases, which results in less fuel can be burned. The decreasing of air density also gives rise to fatigue failure of the turbocharger unless power is reduced.The proposals shall be as required by BAE Systems Ha?gglunds economically sustainable and defensible from a packing perspective. That means the selected solution must have a reasonable price tag and at the same time a minimal impact on adjacent components.The basis for this thesis is based on benchmarking of both the auto industry as the flight industry, to find inspiration and tips for improvement.Some of the concepts have after gathering facts and calculations been excluded while other solutions has been considered as workable and thus interesting for BAE Systems Ha?gglunds.Initially the current turbochargingsystem was analyzed in order to determine the starting point and thus be able to fix the current problems surrounding high altitude driving.

The project has been done in cooperation with Schenker Åkeri AB in Sweden, Halmstad. Theproject is based on an inspection made by Arbetsmiljöverket, where they found minorshortcomings with distribution of goods for the employees. The project is an investigation ofthe drivers? working environment.Schenker Logistics is one of the world's leading providers of integrated logistics services.Schenker Åkeri AB is a subsidiary to Schenker Logistics and transports 2.4 million tons ofgoods yearly.The project started with a background study to evaluate drivers working environment. Wehave studied goods receptions, the working environment, strain injury and injury mechanisms.Methods used was observations, tests, questionnaire surveys and ergonomic andbiomechanical calculations.One result of the study is a working model, which gives recommendations for the maximumweight a driver should push and pull.

Uppsala County has ambitious environmental aims for the planned residential area inÖstra Sala backe. In this thesis different energy sources have been evaluated todetermine which system that would be most favorable given currently availableinformation about the project. Planned energy usage has been divided into tap waterheating, space heating and power. Three base case scenarios were made with districtheating, small scale bio fuel and heat pump. Solar power and solar heating were thensimulated and the production from the two could individually be deducted from theenergy need in the base cases, constituting 9 different scenarios.