The swedish national board of housing, Building and Planning,recommends that all stakeholders in the construction industryperform a moisture control design to make sure that the buildingachieves good moisture resistance. Since June 1, 2006 there are nospecific requirements or quantitative values for air leakage.Although the swedish national board of housing does presentrequirement that the building envelope must be sealed so that theclient?s requirements for specific energy consumption and installedelectric power for heating purposes are met. Despite this, studiesfrom SP shows that few buildings meet the client?s requirements inspecific energy, which increases the risk of occurrence ofcondensation-related moisture damage.This study aims to evaluate curtain walls connections from airsecurity and moisture safety.

This is a qualitative study with four interviews, in four different preschools, in the same municipality. By making it so, it becomes a case study to describe a phenomenon in a municipality which also is the definition for this investigation. The purpose of my study is to examine what it means, in a municipality, to have different types of introduction at preschool. Where I ask the question why preschools choose to have a specific method of introduction and what are the basics and ideas behind the choice of the method? What significance do these different methods have to attachment theory? What do teachers think about the advantages and disadvantages with their choice of method?The versions of introductions are many and may vary; the duration of the introduction may vary from 1-3 days up to 3 weeks.

The student project Elba at KTH started in 2011 and is a project where a battery driven prototype car is developed. The vehicle competes in Eco Shell Marathon in Rotterdam, Holland. In this competition the vehicle that travels a certain distance including several starts and stops with the lowest energy consumption wins. To minimize the consumption is therefore very important, which requires knowledge of the vehicles energy losses.A vehicle's energy losses depends on several factors and can be divided into the powertrain efficiency and the driving resistance. The driving resistance can then be divided in to rolling and air resistance, if smaller losses like vibrations are ignored.

An information system is something that evolves over time to enhance the company that is using it. The technology for building an information system is also evolving. New methods and new programming languages make system development easier. As new technology breaks ground and the demands of a company?s information system grow, the company will sooner or later get to a point where a change in the base of the system is necessary.

How do the police prevention methods work against juvenile delinquency? The purpose of this study is to see how the police work to prevent juvenile delinquency in two municipalities in Stockholm, Södertälje and Sundbyberg. Additionally, the purpose of this study is also to find out if there are any similarities or differences between the police methods the police use in these two municipalities. We have used qualitative method in which we have interviewed the police and young people from the communities. We interviewed young people to see their attitudes to the police and the area to find their perception of police work in the fields as well as the police forces attitude toward the young people.

Högbytorp is Ragn-Sells? largest waste facility and it is located north of Stockholm. There is an old landfill still in use, but at the end of this year it will be closed. The waste deposited on the landfill can, through decomposition, give rise to a large amount of methane gas, which is an energy rich gas that can be used for heat and electricity production. To receive a relatively large amount of gas, the decomposition requires a high moisture content in the waste.

As a result of increased energy prices more and more energy-efficient homes are coveted. An energy-efficient alternative is passive houses, which is characterized by an extremely well insulated building envelope that recovers the heat without the use of radiators or under floor heating. But a passive house requires a higher investment cost than a conventional building project, since it will require more construction materials, training of construction workers, greater land area, and long construction period. But the lower operating cost expects to pay back the higher cost of investment. We therefore question how profitable a passive house is in relation to houses built according to modern conventional building techniques.The aim of our study is to investigate the viability of passive houses compared to convent­ional houses.

Prioritisation of software requirements is a critical part of the development of software. Whichrequirements and in which order they will be developed is one of the main tasks that requirementprioritisation supports.There are different ways that a requirement prioritisation can be used, for example alone or in agroup and with different methods.The purpose of this report is to map out how you can carry out a requirement prioritisation alonewith different types of prioritisation methods and how you solve the problems that can arise whenprioritisting requirements. This is done by documenting the use of three different types of methodsthat can be execute alone. The methods are "100-dollar test", "Ranking" and "Top-tenrequirements".To be able to prioritise requirements, you need to establish which requirements you shall prioritise.The paper retrieves this information by interviewing stakeholders in the system and analysing theresult of the interviews and the execution of the requirement prioritisation.Three problems arose during that work and I present solutions on these problems. The problemswere 1) equivalent requirements when using the "100-dollar test", 2) low differentiation gradebetween the prioritised requirements in the "100-dollar test" and 3) that the requirements that wereprioritised weren't classified before the prioritisation, which leads to inaccuracies in the resultingprioritisation.The solution to the problems that the paper presents is to increase the amount of distributable unitsin the "100-dollar test" to 1000 per requirement, suggestions of classes of the requirements andthe combination of the methods "100-dollar test" and "ranking" to bypass the equivalentrequirements.The report is written in Swedish.Nyckelord: GoTRIS, requirements retrieval, requirements analysis, Viktoria Swedish ICT,requirements prioritisation, requirements, 100-dollar test, ranking, top 10 requirements..

Skin temperature is detected through signals in unmyelinated C-fibers and thin myelinated A?-fibers in the peripheral and central nervous system. Disorders in thin nerve fibres are important and not rare but difficult to diagnose by the most common neurophysiological methods. In this pilot study different methods for quantitative sensory testing, QST, were compared to give some ideas about which method could be the most efficient to use in order to point out injuries of the sensory system in clinical practice. The comparison was made between Békésy (separate warmand cold thresholds) and Marstock test (combined warm and cold thresholds).

A place that mixes different kind of uses of space. Two main theatres inside and a lot of smaller rooms for different venues. A methaphor the tide have strong impact of shaping the building.

Amongst the published literature researching wet cleaning of paper there is a limited amount of studies conducted researching the method simmering water treatment. There are even less studies conducted on how simmering water affects the paper being treated when used as a cleaning method. Despite the limited research, there are literary reviews describing the method and suggesting it as an alternative for conservation of paper with iron-gall ink. The following study will therefore be examining, the somewhat unusual method, simmering water treatment, and comparing it to one of the more common wet cleaning methods: immersion washing. This is done to compare how the different temperatures of the water affect the paper. The types of paper used in this study consists of three dyed and four undyed papers. All of the papers are new, apart from one sample originating from 1847.

The building industry consumes approximately 40 % of the total energy consumption in Sweden, where the using stage is dominating with 80 %. There is a lot of work in progress to reduce energy use in the building industry, and the demands from authorities regarding energy use increases. As a part of this work Building and planning department of Sweden has established a requirement that has been applied since 2006, and restricts a maximum energy use for buildings.The requirement includes that an energy simulation must be done in advance to demonstrate that it is possible to meet the demands.Reality is however more complex than an energy simulation program, that frequently underestimates the energy use of buildings. The purpose of this thesisis to study and analyse deviations between estimated and actual energy use in modern apartment buildings. The study includes four apartment buildings in Stockholm, Gothenburg and Jönköping that were built in 2007-2009.

The purpose of this essay is to examine if the municipality has a real freedom of action to control the use of the land and the shaping of the buildings in a large and prestigious building project.In Karlstad there is now (2006) a large building project in form of a shopping mall. This project is in its final stage of completion and offers me a suitable case to examine. To undertake the purpose of the essay, the following research question is formulated:Do the municipality have a real freedom of action to control the use of the land and the shaping of the buildings in a large and prestigious building project as the Mitt I City project?In an attempt to examine the project and the planning process, three themes are applied. The first theme derives from the hypothesis that the part that initiate the process gets the upper hand as future discussions are taking place in relation to the original ideas.

ABSTRACTMany wind turbines have problems with icing and there is still no effective method to de-ice without stoppage of production and power loss. Here I therefore consider other methods than those available today, and particularly, I consider how these methods could be applied to wind turbines of the company Oxel. A surface where the water droplets do not attach might be the basis for a useful method. If no water attaches, no ice could form. To accomplish this a hydrophobic surface is nessesary, for example wax.

This essay is written about how the physical environment affects teachers? own learning. The purpose is to see how the teachers? work is affected by various factors, such as the uses and placement of the teachers? offices, common room, or any other places where a meeting may occur. The survey was conducted using both interviews and observations of the teacher?s office.