In connection with riding and handling of horses, many accidents that can cause severe injuries to both horses and humans are existent. The cause is in most cases that the horse is frightened. The horse's fear also affects its usefulness and it has been shown to have adverse effects on the horse's welfare. To increase safety and improve the welfare of both humans and horses, it is important to find appropriate training methods to reduce the fear of horses in frightening situations. This experimental study compares handled habituation to free habituation.

Swedish Trotting association was formed in 1925. They are the ones who design the regulations concerning what is permissible and not permissible for the horse, driver and trainer, when they have a license at a Swedish racing track. The Veterinary department of Swedish Trotting association decides in consultation with representatives from veterinaries around the country what is allowed and not allowed, based proven experience, combined with the availability of scientific data and Veterinary Department's own assessment. After stricter regulations for good animal welfare from the Swedish government, Swedish Trotting association is going to work out a workable model for how new equipment can be tested in the future to see how the equipment affects the horse. In the future, all equipment will be objectively tested before approved. The purpose of this work was to develop a well-functioning model for this. The research-question for this work is: Is this study design a well-functioning model of how the equipment should be tested in the future? The equipment used for designing this model was bitless bridle with a bit.

The E-department at GETRAG All Wheel Drive in Köping have problems with the efficiency on parts of their production equipment. The equipment with the most significant efficiency problems are four automated multifunctional production cells that produces housing for rear drive units. The major part of the problem is the large amount of small stops that causes the low efficiency.The department already worked with logging of interruptions and efficiency calculations before this project started. However this work was not done to the extent considered necessary for a systematic follow-up of the interruptions.The aim of this paper is to point out a more effective and systematic way to work with logging of interruptions and the follow-up. In addition the equipment were studied with a method for efficiency calculation that ? if used properly- is a more powerful and a visually better method than the one used by the company today.As the initial current state analysis of the equipment was made a lack of documented knowledge about the equipment was discovered.

This thesis describes the redesign ofequipment designed for drying bags thatis used in Fresenius Kabis´manufacturing of their nutritionmedicine in Uppsala. The need of thistask arise during the start of thedevelopment of a new packaging line werethis equipment were meant to be used. Anevaluation of the bagdryers capacity andcapability was necessary.The work started with gathering ofinformation from suppliers of the usedcomponents and from the responsibleengineers for this equipment. Aneducation to learn how the equipmentworked and how to operate it were taken.That was followed by the creation of astudy plan were the tests were plannedto test different parameters effect onthe drying result and to see if thebagdryer managed to handle the bags ofthe correct format in the pace that theequipment should be designed for.The test results detected a need ofdesigning a unit with a function thatholds the bags in place while passingthrough the dryer in order to attainhigh quality results. The results werelater used for optimization of thedesign.

Syftet med detta examensarbete är att på uppdrag av Volvo Construction Equipment hitta en metod för att hantera och kategorisera idéflödet i deras idéhanteringssystem Interact. Den metod som användes var kvalitativ innehållsanalys. Slutsatsen är att metoden gick att använda för att kategorisera idéflödet men att ett material som sträcker sig över många ämnen tenderar att sänka tillförlitligheten på resultatet. Vidare bedöms materialet som detta arbete har producerat kunna användas för att bättre ta tillvara på idéer, vilket uppskattas av Volvo Construction Equipment..

This paper deals with archery in the Viking Age settlement of Birka and in particular the presence of Euro Asiatic, steppe nomadic archery equipment at the Birka Garrison and one Birka grave. The equipment contains for example closed quivers and a bow case. This paper also contains a discussion of archery battle techniques and tactics in Viking Age Birka and the implications of the above mentioned equipment to this discussion. The analysis insinuates the importance and status of archery in 10th century Birka..

The purpose with the report is to show that it is possible to design a class-D amplifier, using a programmable FPGA mounted on a developing card from Xess and a H-bridge. The FPGA was programmed in VHDL which is the language the software from Xilinx use to implement a logical function into the FPGA The logical function corresponds to a modeling of the music signal and the modeling can be described as a comparator which compare the music signal with a triangle wave and as a out signal produce a pulse width modulated (PWM) signal. The report is also a review and evaluating of two different modulating technologies, AD- modeling and BD-modeling. A detailed part about how the H-bridge was designed and how it works. The result of this project is a working audio amplifier to a significant lower price than the products in todays market..

ABSTRACTThe discussions about energy use have increased year by year everywhere in the society, and so also in the healthcare sector. But what is actually energy use in a hospital facility, and what affects it?The typical way today to express the energy use is in kWh/m2. The problem with a key performance indicator that is expressed as energy use in relation to a specific area is that it does not take into account the activity in the building. Even though the activity to a very high extent affects the energy use.

This thesis describes the redesign ofequipment designed for drying bags thatis used in Fresenius Kabis´manufacturing of their nutritionmedicine in Uppsala. The need of thistask arise during the start of thedevelopment of a new packaging line werethis equipment were meant to be used. Anevaluation of the bagdryers capacity andcapability was necessary.The work started with gathering ofinformation from suppliers of the usedcomponents and from the responsibleengineers for this equipment. Aneducation to learn how the equipmentworked and how to operate it were taken.That was followed by the creation of astudy plan were the tests were plannedto test different parameters effect onthe drying result and to see if thebagdryer managed to handle the bags ofthe correct format in the pace that theequipment should be designed for.The test results detected a need ofdesigning a unit with a function thatholds the bags in place while passingthrough the dryer in order to attainhigh quality results. The results werelater used for optimization of thedesign.

The purpose of this thesis was to develop and optimize a method of analysis for combustion of organic chemical products, followed by an ion chromatographic quantitative analysis. This was to be achieved with the decomposition equipment IKA AOD 1. The aim was to receive a precise and repeatable method that would be able to be applied to the process of qualification and technical marking of chemical products at the company, OKG AB in Oskarshamn. A complete instruction for the decomposition equipment and the method of analysis was written. A number of parameters were chosen from the general method of the combustion equipment, which then was tested parallel with a simultaneous development of an appropriate ion chromatographic method.

Modern agriculture equipment are more computer based today, and many equipments use a terminal in the tractor where the driver have the opportunity to make adjustments to the equipment. This is the reason why ISO developed a new standard called ISOBUS. It is a communication standard based on CAN specially adapted for griculture equipments. The purpose of the standard is that it should be ossible to equip a tractor with a standard terminal called Virtual Terminal that can be used to control the equipment. The use of the terminal should be independent of the manufacturer of the tractor as well as of the equipment.The purpose of this report is to ?nd a solution of how to use CC Systems on-board computer, CCP XS, as a Virtual Terminal.

Plant Protection Products (PPP) used in the horticulture industry can be both chemical and biological. They are used for weeds (herbicides), insects (insecticides), and fungi (fungicides) and as growth retarders.Many horticulture workers get in touch with plants, treated with PPPs and many of these don?t use any protective equipment.The aim of this project is to illustrate the work environment hazards for staff working with greenhouse pot plants, after they have been sprayed.The method used was observations of the operations for packing plants. I studied the operations and took notes of how operations were performed and what protective equipment they used. I also took photos and asked questions.A literature study completed the observations.

ABSTRACTThe discussions about energy use have increased year by year everywhere in the society, and so also in the healthcare sector. But what is actually energy use in a hospital facility, and what affects it?The typical way today to express the energy use is in kWh/m2. The problem with a key performance indicator that is expressed as energy use in relation to a specific area is that it does not take into account the activity in the building. Even though the activity to a very high extent affects the energy use.

ABSTRACTThe discussions about energy use have increased year by year everywhere in the society, and so also in the healthcare sector. But what is actually energy use in a hospital facility, and what affects it?The typical way today to express the energy use is in kWh/m2. The problem with a key performance indicator that is expressed as energy use in relation to a specific area is that it does not take into account the activity in the building. Even though the activity to a very high extent affects the energy use.

In Sweden there are 354 000 private individuals owning forest. Of these forest owners there are at least two thirds that are self-employed, which means that about 215 000 forest owners conduct some kind of work in their own forest. Those numbers do not refer to firewood production, but every year 7.3 million piled cubic meters of firewood are used for heating Swedish households. This implies that many households are also producing firewood. The objective of this study was to assess and analyse the small-scale firewood production in the Umeå-region in terms of persons engaged in the work, equipment used, produced volumes and share of forest-owning households involved in these activities. According to results from a questionnaire, the average firewood producing person is a man between 40-60 years old.