I have in this essay looked at what stand NWT took to the three leading countries in The First World War, Germany, France and England, and if it changed during the course of the war.I worked based on the theory that NWT, as a politically conservative newspaper was pro-Germany, which also showed to be true.I have look at the official stand, what is shown in the published material, what stand that the newspaper showed outwards. The result shows that NWT held a neutral stand during the war being loyal to the conservative government. At the end of the war the papers sympathies for Germany are shown more openly in its political material..

The purpose of this report is to investigate and compare the difference between stand-thinning machines and strip-road thinning machines, and how they affect the stand on behalf of future growth, theoretical economic result, wind impact, snow pressure and density of stand. The investigation is regarding the first commercial thinning of pine stands, after pre-commercial thinning that was well conducted. The investigation area was located near Katrineholm, Sweden. The measurements that were measured were strength of thinning and amounts of wind throws, snow-breaks and hauling damages. The results that emerged, was that thinning with strip-road machines had a significantly higher strength of thinning over all, as compared with the stand- thinning machines (45 percent versus 30 percent). Comparisons between wind-throws, snow-breaks and hauling damages of the stand could not establish any significant differences between the two methods that were investigated. Conclusions, over all, were that if forest owners want to have more timber volume left for second thinning and final cut of the stand, the forest owners should choose the method with stand-thinning machines. From the point of view of gentle treatment of the stand and ground damages the choice should be the same. However, the method with strip-road thinning machines is the most common and accessible method in Sweden. Most likely it is the most economical way to manage the stand for forest owners in present time. If the method with stand-thinning machines is becoming more common in Sweden, it is suggested for forest owners to consider the stand-thinning method as a candidate for treatment due to economic aspects..

Half of Sweden's productive forest land is owned by individual forest owners. Research studies show that forest owners have more objectives with their forest than a high net present value, and that the suggestions of the forest management plans doesn?t always correspond to the forest owners? objectives. Through a qualitative study we conducted a discussion about objectives at stand level with the aim of making a more specific formulation of the forest owners? objectives. We asked about the forest owners' objectives at stand level, what forest management they conduct in order to achieve the objectives and how this management affects the net present value of the property. Based on the results of the interviews, we analyzed what kind of factors decide where the objectives place themselves in the landscape and if the objectives at stand level are consistent with the overall objectives for the property. Many forest owners questioned the idea of talking about objectives at stand level, and they didn?t always have their objectives clearly defined.

Nowadays the majority of the thinnings made in Swedish forests are done by machines, harvesters and forwarders. The most common model in thinning with a harvester is strip-road operated thinning and stand-operated thinning with one intermediate passage between the strip-roads. This study is a time study with some quality follow ups on a strip-road operated thinning model, a stand-operated thinning model with one intermediate passage between the strip-roads and a stand-operated thinning model with two intermediate passages between the strip-roads. The machines in the study were a small harvester (Forestline MPM C90) and a medium sized forwarder (Timberjack 1110). The study was made in Litsnäset outside the city of Östersund in Sweden and was made during the autumn 2007. In a lodgepole pine stand six study units (0,6 ha) were thinned with the three different models, two study units per model.

Young stands in urban forests often lack a shrub layer, though shrubs play an important structural and biological role in forests. All layers interact with one another to form a multilayered stand, in which shrubs have a vital role.In this diploma thesis, theoretical models for forest dynamics are compared with four reference stands to detect factors, and principals for introduction of shrubs in young stands. In these stands four different ways of introduction were found. In one trees and shrubs were planted together at the same time. Shrubs spontaneous spread under a canopy of mature forest, in another.

The purpose of this study is to investigate whether it is possible for SCA to update their stand register with use of digital aerial photos photographed with a Zeiss/Intergraph DMC. ?Updating? in this study implies the delineation of stands and estimating stand variables such as average stand height, volume density, stand volume, and tree species composition in order to identify stands which can be of current interest for thinning. The study also includes how the aerial photo material and experience of the interpreter can influence the quality of the interpreted variables. The aerial photo interpretations were made by both experienced and inexperienced interpreters.

The purpose of this study is to show the technical building requirements for modern arenas inSweden. The study will also create an understanding of how the requirements affect theSwedish football arenas which are affected by the regulations valid from 2014. As one of theSwedish football arenas there is Örjans Vall located in Halmstad. The aim of this study is todevelop alternative solutions regarding the technical problems Örjans Vall is facing 2014,when the new arena requirements for ?Svensk elitfotboll? are taken into use.

Approximately 4000-5000 hectares, of SCA´s forest land area in Västerbotten, are in need of pre-commercial thinning (PCT) every year. Within the management district, the areas annually treated with PCT must increase, in order to decrease the area with an urgent need for PCT. This can be done by employing more forest workers or entrepreneurs, by mechanized PCT or by an extended season for PCT. Positive experiences from a private forest owner, who started to carry out PCT when the first snow came and then continued for several months, gave an idea to investigate the possibilities to prolong the season of PCT. The purpose of this experiment was to compare PCT carried out when there was snow on the ground with PCT performed when there was no snow on the ground.

I got a request from Eleiko Sport AB regarding them needing help with trying to improve one of their products. The following examination project includes the principal- and primary construction reports within trying to make some improvements and optimizations on a stand for Kettle bells. I have in this project both made my own proposals to the stands legs, proposals on how to strengthen the shelf and also made an optimization of the original Kettle bell-stand. In this report, the project goes from idea to being built and analyzed in Catia, including the creation of drawings and material definition..

Due to soft grounds in combination with seasonal variation in soil humidity, there is a lack of stands that are possible to cut during spring and autumn in some geographical regions. For Holmen Skog this sometimes means that a large proportion of the contracted private forest is cut during the winter when the ground is frozen. One consequence of this is that the proportion of winter stands in the stand bank of own forest increases while spring and autumn stands becomes a scarcity. This in combination with milder winters, especially when there is a long period of reduced bearing capacity in spring or autumn, means that the situation rapidly can become critical. The overall goal with this study was to generate basic data for decision support in the work to achieve a sustainable distribution between own forest and contracted private forest in the stand bank. The study took place at Holmen Skog, district of Umeå, during autumn 2007 and was based on interviews and an analysis of harvest planning and delivery data. The study showed that there is a problem with how the cutting is distributed between own and contracted private forest during the year and that it foremost is the proportion of winter thinning of own forest that has increased in the stand bank.

The hybrid larch (Larix x eurolepis Henry) is a fast growing tree species and was introduced in Sweden for about 50 years ago. The high growth and expected resistance to diseases are probably the main reasons of introducing the tree species into the Swedish forests. The purpose of this thesis was to document the production of hybrid larch planted in the Snogeholm landscape laboratory and to compare the production in the pure hybrid larch stand with the mixture together with pedunculate oak (Quercus robur). The data collection in Snogeholm since the establishment has been carried out by the Swedish University of Agricultural Science (SLU). The fieldwork for the thesis was carried out in 3 stands, containing hybrid larch, pedunculate oak and a mixture of hybrid larch and pedunculate oak, in order to be able to compare the total stand production of the areas. The results show that the total production of hybrid larch in the mixed stand only is 35 % compared with the total production of hybrid larch in the pure stand. Therefore, the hypothesis that the total production of hybrid larch is equal to the planted mixture with pedunculate oak was rejected. The other hypothesis that the total production of a 2 hectare large stand containing a mixture of hybrid larch and pedunculate oak would be greater than the total production of two pure stands of 1 hectare containing hybrid larch and oak each was also rejected. In the studied case the total production was 45 % greater if hybrid larch and pedunculate oak was planted in pure stands. The results from the case-study only indicate that the total production of hybrid larch and oak under the investigated conditions can be higher when planting the two species in pure stands compared with a mixture of the two species.

In the Kolmården area, northeast of Norrköping in south-central Sweden, it was discovered that shoots of spruce Picea abies, plants to a seemingly large extent had been browsed by deer. The area inhabits a dense red deer population, alongside with moose and roe deer, and red deer is thus suspected to cause the damage. The main purposes of this study are, however, to estimate the extent of the shoot-damage and to investigate what factors that may affect the browsing of shoots. For each stand information was recorded about the age of the plants, area for the stand, height over the sea for the stand, site productivity, type of plants and stand-history. The study was done in three areas: Simonstorp, Stavsjö and Valinge. At Simonstorp and Stavsjö, respectively, 10 stands were chosen for study and on Valinge six stands. In each stand, 10 plots were sampled.

With knowledge of how the southern Swedish forests have been affected by storms the past years, this study intended to find out which factors affect the storm firmness of a stand the most. The study was based on data from stands in the, by the storm Gudrun, affected area. The results of the analyses that tested the stand factors that influence the amount of storm damage to the greatest extent showed that the storm sensitivity of Norway spruce stands were largely due to previous management actions. The factors that could be controlled by thinning and had relevance of storm damage standpoint, according to the results were; the dominant height, volume, basal area weighted mean diameter and stand age at last thinning. In this study, these results are not as clear for Scots pine.

In Sweden, harvesting pre-commercial thinning (PCT) stems for energy purposes is a interesting way of financing the high cost of preparing dense stands for a profitable first conventional thinning. This concept can be labelled bioenergy thinning. The aim of this study was to quantify the productivity of a Vimek 404R light harvester with an accumulating Naarva-Grip cutting head during the bioenergy thinning of a self-regenerated stand west of Sunnansjö in Dalarna. The stand was birch-dominated, contained 15 371 stems/ha, and measured on average 4,6 cm Dbh and 7 m tall. Even though the driver was well experienced with the machine, the stand in question was the first one that he ever thinned in this manner. Nevertheless, the driver strived to accumulate as many stems as possible during each crane cycle and chose to cut taller stems in half so as to make the handling and forwarding of the harvested stems easier.

This essay is about the Swedish folk and troubadour singer Fred Åkerström and particularly his interpretations of the Swedish national poet Carl Michael Bellman. With Åkerström being a socialist, he converted his beliefs into what he believed Bellman should stand for and not stand for, politically and historically and the picture he did not take kindly to is called "The bourgeoisie". And in his interpretations of Bellman Åkerström used his deep bass voice and singing with maximum potential that earned him the nickname "Carl Michael Decibelman" along with a trio he created called Trio CMB. But along with alcoholism and financial problems Åkerström died at an age of 48 years old and had probably much more to give the Swedish musical society..