The energy sector of modern time is currently faced with several challenges. These are both production oriented and environmental oriented in nature. The energy of the future is intended to support an increasing demand while at the same time reduce its environmental affection. This stresses a development towards production methods of renewable energy. Among the existing methods, biogas is presented as an attractive alternative.

The aim of this study about wind power planning in forest was to examine the factors and restrictions, which represent technical limitations, biodiversity, tourism and amount of energy for wind farms in Kronoberg County. Suitable areas for wind power were identified from the collected information about planning principles and potential conflicts. From the suitable areas the potential energy gain is calculated. Methods used were mainly a literature review, interviews with experts and practitioners, GIS analysis and a rough calculation of the energy gain. The section of information and facts describes in general wind power planning and possible conflicts.

Biogas is increasingly used for fuel in for example vehicles and it´s produced in a biogas processconsisting of the steps of pretreatment, digestion and gas cleaning. The pretreatment is a method usedto increase the gas production and / or destroy pathogens. The digestion is the stage when anaerobicmicroorganisms convert bio-mass of a substrate to a raw gas containing about 65% of methane. Thegas cleaning is used to increase the methane content to about 97% so the gas can be used for motors invehicles. The biogas part of the Ekeby sewage plant in Eskilstuna is using multiple substrates.

The Swedish energy companies have several different systems for data collection of the energy consumption of their clients. Often computerized remote meter readers are put in practice in order to register the energy consumption of large companies. The majority of household clients, however, are read off by the assistance of manual methods. Household power consumption is read off once a year. As a result, these clients are not debited for their actual consumption; their invoices during the year are the result of estimations. At times when the electricity supply system is highly loaded, electricity is more expensive.

In recent years, moisture damages have been noticed in rendered, undrained stud walls. The design is built on the principle one-stage tightening which means that there is no air gap in the construction. The damages have occurred when water has permeated through the rendering in leaking connections and fittings for windows, doors, canopies, balconies, terraces and awnings. Behind the plaster carrier, which consists of either polystyrene or rigid mineral wool, plasterboard has often been used as a wind protection barrier. In many cases the wind protection barrier and the underlying wooden studs have been exposed to mould and in some cases even rot.

The New National Elevation Model (NNH) is a new high-resolution digital elevation model (DEM) of Sweden from airborne laser scanning. It creates many new opportunities, particularly in the area of flood mapping. NNH is provided by Lantmäteriet in two formats, both in raw LIDAR (Light Detection and Ranging) data and in grid format with two meter resolution. These alternatives have advantages and disadvantages and the aim of this thesis research is to identify these. One of the focuses of the study is data storage and thus data structure analysis, resolution and storage facilities. The research questions are:Why and in what context the different NNH-products from the National Land Survey are used (DEM 2+ or point cloud)?What constraints and opportunities are created by the different options, mainly in terms of different software, resolution, and data storage?The study area is Kärsön in Ekerö municipality located in Stockholms län and has an approximate area of 25 square kilometers. The study is divided into two parts. The first objective is to identify the consequences of using different software to create DEM from pointcloud compared to the DEM2+ model. Height models with a two meter resolution are created in FME and ArcGIS. The models are then compared with the grid from Lantmäteriet, created in TerraScan. The second objective is to examine the impact of the change in resolution, both the storage aspect and both the accuracy aspect. Inverse Distance Weighted (IDW) is an interpolation method which in previous studies proved to have the best results on high resolution LIDAR data. This model was tested and compared with a model from FMEs built-in function and the model from Lantmäteriet wich are based on triangulation (also proved a good method in previous studies). The grid created in TerraScan has good properties such as accuracy.

This Master degree project has been performed at the Braviken paper mill on papermachine 53 (PM53) which produces newsprint paper. The current economic situationhas contributed to declining demand for newsprint, which means it is extra important tobe competitive by high energy efficiency. Particularly as energy prices are expected torise when the economic growth returns.One way to increase energy efficiency is by reducing the water use in paper and pulpmills and consequently save energy through reduced heating of water. The thesis's maintask is to evaluate whether a water purification plant (microflotation plant) forpurification of process water in PM 53 is profitable. The microflotation plant enablesreuse of warm process water instead of losing the energy to receiving waters.

The use of energy is an important question in today´s society, and a substantial part of the energy that is used today is used in our homes. To lower this usage is vital, and there are regulations in place both on the national and the local level, that say that new apartment blocks must be built to consume less energy, which in the end will lower the impact on the climate.One way to make the housing sector more environmentally sustainable, is to produce energy issions that are bad for the environment, for example to build wind turbines close to or even on the buildings, so called urban wind power. The scope for this report is to see if urban wind power could be a sustainable alternative for the residential area that Svenska Bostäder plans to build in Albano in Stockholm.There are extensive scientific theories regarding wind and wind power, and a literature study is made to investigate past knowledge in the area. Efforts have been made to find earlier trials with urban wind power and, both scientific research and trials where urban wind power actually has been installed. The theory chapter deals both with the wind itself and how electricity can be generated from wind.

Preservation of cells and tissues by freezing at temperatures below 70°C has led to new possibilities for the storage of germ cells for fertility preservation. During the freezing process problems might occur, the greatest being ice crystallization which can cause membrane destruction and thus cell death. To minimize this risk, solutions that reduce the freezing point can be added to reduce crystallization and increase survival rates. These solutions are called cryoprotectants. The best method for freezing is still not known.The aim of this study was to analyze the effect of various parameters on the survival rate of human semen frozen with liquid nitrogen.

In recent years it has become more and more evident that man has contributed to much of the climate changes that have taken place during the last century. A major challenge today is to reduce emissions and energy usage at the same time as the global population is growing. To contribute to a better environment, Stockholms Stad has set at target of becoming fossil fuel free by the year of 2050. The construction of new districts is done with this goal in mind; energy efficiency and renewable energy sources are examples of methods to achieve this.Solar energy is considered to be a sustainable energy source and the most common techniques to harvest solar energy in Sweden are solar cells and solar collectors which produce electricity and heat respectively. This report aims to investigate whether an investment in any of these systems would prove to be economically beneficial at Kvarnholmen, a district under construction in eastern Nacka, Stockholm.Since the finished blueprints only cover a small portion of Kvarnholmen, the report examines the possibilities for a house where construction has already begun, Nya Kvarnen.

Mechanical ventilation is the most common type ofventilation in newly constructed office buildings. Therehas been an interest to utilize natural ventilationinstead of mechanical ventilation among architects andHVAC consultants in recent years. This is due to thesize of mechanical ventilation systems, which arespace consuming. The mechanical ventilation system isalso complex and requires maintenance. Furthermore,the fan uses a considerable amount of energy.

The purpose of this study is to investigate how much of the estimated annual electric energy production from Swedish wind power that actually was produced, as well as the history of this agreement over time. The aim is to also examine if there are properties that have caused some group of wind power plants to produce more or less, compared to their estimated production. Operational data on wind turbines collected by the Swedish Energy Agency was analyzed. A survey was made among owners of wind power plants with a nominal power of at least 2 MW. Two different methods for normal year correction of production data were used and compared.

The use of fossil fuels such as coal and gas are a contributor to the global warming. The climate change is a worldwide problem with far reaching consequences that is believed to be very expensive. The United Nations has been introducing a framework convention on climate change. One component of the convention is the Kyoto protocol. The protocol is obligating the developed countries to decrease their emissions of greenhouse gases by 5.2 percent during the time period 2008-2012.

Grubbe Ventilation AB is a sheet metal and ventilation company who provides design, installation, service, and repair of ventilation. The company is expanding their business by building a new facility in Umeå, Västerbotten. The property is designed to be used for both office and industrial work.Grubbe Ventelation AB has not yet decided upon wish system which is to be established to provide the building with heating and cooling. The consulting firm Umeå Projekt Team has therefore been asked to investigate the possibilities to invest in geothermal- heating and cooling.If the investigation of a geothermal heating- and cooling system would provide favorable results it would be a very appropriate alternative that provides energy at low costs and are an environmentally friendly option as the energy comes from stored solar energy in the ground is provided by stored solar energy in the ground.The facility ´s heating and cooling consumptions are calculated in the program BV2 and the result indicate a heating demand of 185 000 kWh per year due to thermal transmittance, transmission losses, heating of warm water and a cooling requirement of 5500 kWh.Three different systems of geothermal heating and cooling were tested in the computer program Energy Earth Design. The results show no difference in the dimensioning of the drill hole if merely heating were to be used or both heating and cooling were to be established.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.