The municipality in Uppsala has set up goals for the future work concerning climate-and energy issues. As one way to achieve these goals the municipality started aproject called Uppsala climate protocol. During one of the project meetings anabatement map was presented. The map showed what savings in carbon dioxide andmarginal costs for different actions can be made. Statistics show that 40 % of thepopulation in Uppsala lives in a condominium.

Sweden has an environmental goal to achieve until the year 2020. To achieve this goal the construction business has to take an initiative to use the modern techniques that are available to lower the energy consumption I buildings. There?s also a debate going on today regarding the energy demands set by the Swedish government through Boverket, some communities throughout Sweden thinks that the demands are to low and have therefore set up own demands regarding energy in buildings.The possibility to construct energy-saving buildings is today very great, with energy-efficient heating-systems and dense climate envelope. The interest to raise energy-efficient buildings have also increased as a consequence that the population have become more aware about their impact on the environment.

Storm water is rain and melted snow that runs off, primarily from impervious surfaces.Future storm water management is facing the challenges of increased precipitation, asclimate changes, and increased areas of impervious surfaces due to the expansion anddensification of the cities. Impervious surfaces reduce the potential for water to infiltratein the ground leading to increased surface runoff and higher peak discharge.The runoff coefficient is closely related to the percentage of impervious surfaces andrepresents the maximum percentage of a catchment that can contribute to runoff. In thisstudy, the objective was to evaluate the weighted runoff coefficient for three differenturban types; Apartment buildings, townhouses and residential areas and a comparisonbetween today and the 1970`s was made.The runoff coefficient was determined by manual mapping of the different surface typesin each area based on data in the form of orthophotos and aerial photographs. The surfacetypes that were mapped were asphalt, permeable areas, tiles, sand/gravel and roof.Tiles and sand/gravel were the most difficult surface types to map. In order to see towhat extent these categories influenced the weighted runoff coefficient a sensitivityanalysis was carried out and the runoff coefficient based on surface type was changed indifferent scenarios.The results of the sensitivity analysis showed that the surface types tiles and sand/gravelhad little impact on the weighted runoff coefficient which in mainly due to the fact thatthe percentage of these surfaces types of the total area is small.The result of the study showed that the largest change in the runoff coefficient occurredin residential areas where the increase in the percentage of impervious surfaces causedby new roofs in the form of porches and garages and from paved or tiled driveways.

The report aim to increase awareness of factors that have a major role whenremodelling an apartment building from the 1950s to offices.The thesis can be used for future projects when remodelling apartments to offices.The report can provide ideas and inspirations on how this can be done in aneffective way, ie . A way that does not require rebuilding the supporting structure,but only non bearing walls. The thesis also gives insight on the parts that will needto be supplemented from Boverket?s requirements in terms of accessibility,acoustic and fire requirements.The methods used in this thesis are literature studies, case study and sketch work.In the literature studies, the primary sources were Boverkets byggregler BBR, andArbetsmiljöverkets föreskrift AFS 2009:2 but other literature were also used. Theprimary items were chosen from the literature studies and they were furtheranalysed in the sketch work.

As a result of increased property prices on Apartment buildings in Halmstad many local investors thinks that the market behaves illogical. This because these investors can?t find any profitability in many real estate transactions. The valuation between different investors on the same object therefore goes their separate ways. One example of this is a property in central Halmstad which starting price was about 23 million SEK.

In today?s society a large focus is put on energy systems and how our energy systems are built up. In order to make sure that we in the future still can enjoy the living standards that we are used to today, Sweden and EU have made a number of decisions on making our energy system more energy efficient and consequently reduce the usage of energy resources. By 2020 the European Union should have reduced its energy consumption by 20 % compared to 1990?s level, and by 2050, 50%.

Energy efficiency is today more important than ever, mainly due to the high energy prices and the approaching climate changes. Heating of buildings is an essential area within energy efficiency. Many buildings are old and were built at a time when the energy prices were low and the term ?energy efficiency? was unheard of. By applying today?s broad range of energy saving actions on these old, and thereby often, heating ineffective buildings, this area has a large potential in reducing energy consumption and costs.Churches and chapels are generally old buildings with, in many cases, ineffective heating systems and therefore consume much more energy than needed.

The purpose of this thesis is to examinethe possibilities for adding a floor to anexisting building using the two materialswood and sheet metal profiles as the loadbearing structure. An apartment buildingfrom the 60s has been used as referencehouse. Two different suggestions for thedesign are presented in the rapport. Oneof them has been analyzed with wood andsheet metal as the load bearing structure.Using the old constructional calculationsand blueprints of the existing buildings,the load bearing capacity has beencalculated. In the calculation programFEM-Design the building has been testedwith the loads that an extra floor wouldgive.

certain building or environment can get a protection as a notable building if it contains certainvalues. These values are established by a certain category of people from the cultural sector.These people use established criterions to define the cultural value of the object. The objects canbe evaluated differently depending on who has done the evaluation. The people who protect thecultural environment and choose which buildings that are to be defining as notable buildingsoften uses a special model to characterise the different cultural values. This model is produced bya man called Axel Unnerbäck.

Environmental impact and management of energy is a highly topical issue in today's society. Climate impact must be reduced. The Government has set a target to reduce energy consumption in buildings by 20 % by 2020 and 50 % by 2050 compared to the energy use in 1995.With this in mind, we chose to examine how property owners can work on improving energy efficiency in existing Apartment buildings. We also wanted to investigate profitability of different increasing energy efficiency measures and the calculation methods and the risk assessment performed by such investments. To tie in with government objectives, we also saw the possibilities of achieving these goals.20 companies were interviewed, of which 14 were property owners and 6 were consulting firms that works with energy efficiency.

Between 1965 and 1974, the Swedish Parliament decided to build one million dwellings, called Million Program. The million program buildings were erected with new, untried design solutions, in a short range of time, and at low cost. The residential buildings from that time are now greatly in need of renovation. The municipal housing company, Gavlega?rdarna, renovates and improves the energy efficiency at some of it?s Apartment buildings in the district Sa?tra, Ga?vle.

In the report we have investigated four high-rise buildings with the intentions to find out witch parts are prefabricated and what relation can be found between structural design, prefabrication and the logistics. After the investigation we noticed that the grad of prefabrication in each one of the projects is good in relation to what purpose the building have and the given background. During the report we found that layout ? structural design ? prefabrication ? logistics is an order that we think can make the production of the building more effective if followed. We believe that the prefabrication of high-rise buildings have potential to grow and get more optimized in the future..

The viscosity of air buildings is a hot topic within the construction performers, which the industry feel they have too little knowledge about. This study is mainly aimed against air density in Apartment buildings and airflow measurement. The study consists of a theoretical reference, educational visit, interviews and a survey conducted among construction workers at Magistratshagen in Linkoping.Earlier requirement in terms of air leakage through the climate screen was removed and today there are only energy requirement for a dwelling in Boverkets Building Regulations. The difference between a passive and a typical air tight construction is that the passive house have a maximum requirement of 0.3 l /s m2 of air leakage through the building climate screen. The requirement imposed on passive houses is to minimize the supply of power and energy for heating the building.Air tight constructions have heavy demands on the performance and accuracy of everyone involved with the project. The client must specify their requirements and also be prepared to pay for any additional costs. The architect and building planners have to design the building with regard to air tightness. Finally, the construction workers are required to do a careful work in order to get all the connections in the building air tight.The study suggests that an air tight building is a closed system where no forced ventilation exists. There are no reasons not to build too tight as long as there is a functioning ventilation. In this study the authors ask themselves how an air tight building changes over time. No theoretical information has been found on these changes, but the respondents assume that air density decreases with time. The deterioration is mainly assumed to be caused by construction materials changes over time. The study shows that construction workers knowledge of air tight construction is mixed, which they themselves admit in the survey..

This thesis aims to increase understanding and knowledge of issues affecting the redevelopment of older office buildings to housing. The rising demand for housing in recent years has resulted in a need and an increase in cost housing projects. The need has led property owners wanting to build old office buildings to apartments. The case study is carried out in Lycksele town and in close contact with consultancy TM (Technician Mercantile) ? consulting, which has operations in the area.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.