This thesis aims to contribute to improved functional procurement of photovoltaic systems, PV systems. Functional procurement means that criteria concerning a function are set rather than specifying technical details or products. Possible advantages and difficulties in using functional procurement have been analyzed by interviews, simulations and a case study. Electricity production and surplus production for different scenarios have been simulated via MATLAB. The MATLAB script was also used to generate rules of thumb on feasible solar fraction for six different load profiles; a church, a farm, a car mechanic, an office, an industry and an apartment building.

The residential and service sector in Sweden accounts for approximately 38% of the total energy usage and Sweden has an aim to reduce the total energy use by 20% by 2020 compared to 2008, which means residential sector will have to improve energy efficiency. As part of that a law was instituted by the Swedish parliament that all properties must have an Energy Performance Certificate (EPC) to thereby give the property owners a greater insight into energy use in their buildings and propose recommendations for energy-efficiency measures. On the EPC, a value on the building's energy performance in terms of energy use in kWh / m2 per year is declared, of which electricity is a share of it. Instructions on what to include in the amount facility electricity for running the facilities is regulated by the authority for building, Boverket while SVEBY has made an interpretation of the regulations in their report "Brukarindata bostäder" where they have a table on what should be included in the amount and what not to include.This report is a study of two similar apartment buildings, where one of the buildings recently underwent renovation, to see if the declared amount of energy for electricity, in the EPC, is consistent with the measured value, and whether there has been any reduction in facility electricity in the renovated building after the renovation.The result shows that the measured value of the building electricity was 2.6 kWh / m2 per year, 28,8 %, lower than the declared value in the building that have not undergone a renovation. Calculation of values from previous years (2011) by the same percentage of facility electricity as in the results of the measurements, 56.7%, it becomes clear that the declared value for facility electricity in the EPC of the renovated building do not correspond with reality and that there has been an increase in use of facility electricity after the renovation..

A large proportion of the energy consumption is in the building industry and a large part goes to heating our homes and premises. In the developing countries' development now threatens the large consumption of energy in our earth's climate. It is in the West world that we must be good role models in terms of energy efficiency. One solution to reduce energy consumption for heating of buildings may be to continue to build low energy houses and passive houses, but it is also about rebuilding the buildings that currently have high energy consumption such as the old Million program Houses. These buildings will be standing many years and their energy consumption will not diminish over time by itself and energy prices will certainly not diminish in the future.

In all types of learning situations, it is important to find each student where they are at the moment in knowledge. I have reflections about  what animal experience students have with them when they begin their education. This thesis is about what home environment and in home environment acquried animal experience student at agricultural college have. This work is based on data collected through questionnaire survey done in two agricultural colleges in middle Sweden in the spring of 2007. Questions were divided into four blocks, historical data such as on the environment in which pupils are growing up, animal habit, why they read on agricultural school and future data on what plans students have for future education and careers.

Floating housing is a concept gaining ground in Sweden. The dwellings are different in many ways from traditional homes, not only regarding flotation, but also several other technologies. The purpose of this thesis is to emphasize the qualities that exist in living on water. The ambition was to present a proposal for a floating residential area located in Jönköping, containing homes of varying sizes, and to present their technologies. In order to find inspiration and solutions studies have been made on existing floating homes in Stockholm and Kalmar, focusing on their technical and functional solutions.

In recent years, existing solutions for cooling personal computer CPUs have been supplemented by a new product category, factory sealed water cooling loops. These systems, consisting of a water block with an integrated pump, a fan and a radiator, perform well compared to the air cooling solutions but are less effective than larger, custom-built water cooling systems.This project aims to explore the most important aspects of a factory sealed system and to identify possible cost-effective enhancements of the performance.The most significant differences between the different groups of water cooling loops are the block design and the pumping power. The performance of both categories is also largely dependent on the fan power, but increasing fan power has a large negative impact on the noise level.Both radiator size and fan model choice appear, in tests, to be relatively unimportant, presuming that the noise level is kept constant. The position and direction of the fan, however, has significant impact on both the temperature and the sound level.Water blocks can be designed in several different ways, both regarding the heatsink design and the flow direction. In simulation, flow with the inlet centered above the heatsink result in considerably lower pressure drop and slightly higher temperatures than flow through the block, for heatsinks with fin arrays.Creating a competitive product in this product segment certainly seems possible, as there are performance-increasing changes to be made that seemingly has little impact on the production cost.

This report deals with prefabricated bathrooms and the advantage, during the production process, they have compared to ordinary produced bathrooms.The work is done together with the building company JM. The common task is to investigate if the manufactures, in spite of standardized design can meet the concept of JM, i.e. high flexibility and adjustment towards the customer. In JM they are doubtful to the method, as they did not yet worked with prefabricated modules and think that the choises for the costumer will be limited.There will be a short resume of the progress of the bathrooms and its importance as sanitary and wellbeing.The recent problems with damage caused by damp in bathrooms. Have resultade in regulations.

Environmental impact and management of energy is a highly topical issue in today's society. Climate impact must be reduced. The Government has set a target to reduce energy consumption in buildings by 20 % by 2020 and 50 % by 2050 compared to the energy use in 1995.With this in mind, we chose to examine how property owners can work on improving energy efficiency in existing apartment buildings. We also wanted to investigate profitability of different increasing energy efficiency measures and the calculation methods and the risk assessment performed by such investments. To tie in with government objectives, we also saw the possibilities of achieving these goals.20 companies were interviewed, of which 14 were property owners and 6 were consulting firms that works with energy efficiency.

The Swedish potential of electricity production from roof mounted solar panels has been determined in three steps: accessing the existing roof top areas, simulating the amount of electricity solar panels can produce on these areas and finally analyzing how large the necessary economical change is to make the solar cells profitable.The total existing amount of roof top areas are 319 square kilometers and the area distribution follows the distribution of people. This leads to an installed power of 47,9 GW which are expected to produce 49,0 TWh electricity per year. If the quality of the electricity is prioritized the highest the power is reduced to 3,7 GW, generating 3,8 TWh yearly, but if the hosting capacity is calculated from Sweden?s total electricity need, the capacity is 42 TWh per year.Today, solar panels are not profitable in Sweden for houses, even though there is a subsidy of 35 % of the investment costs, discounted in 25 years. The profitability is calculated with a cost of capital of 5 %, a price on electricity of 1 SEK/kWh and an investment cost of 20 SEK/Wp.

Today's urban centers become denser, which contributes to higher demands on sound and noise. It is therefore highly relevant to build homes with good sound environment while maintaining living space. This thesis aimed to reduce the current concrete walls and see how the mass law affects the reduction index value and flanking transmissions. Handmade calculations were calculated according to the Swedish standard SS-EN 21354-1, where only air sound was calculated.Calculations we­­­re performed on wall elements with different weights and thicknesses, and compared with results from Bastian.In Bastian calculations of flanking transmissions were also made, this was made to see the impact of the flanking transmission when changing the mass per unit area. Mass law's impact was examined by flanking transmission and the result shows that they are not affected as long as the ratio between the thickness and the density remains the same.A questionnaire survey was conducted to determine the actual sound experience; this questionnaire was conducted on three concrete buildings in Växjö.

Predation is one of many factors that form the structure of the macroinvertebrate community in lakes, wetlands and watercourses. Earlier studies lack an examination concerning how fish- and waterfowl predation affect macroinvertebrates during shorter periods in the spring. I performed an exclosure study in the shallow eutrophic Lake Tåkern which is located in the western part of Östergötland County, Sweden. The experiment was performed during a three week period (1-21 April 2012) when the water temperature was low and the density of migrating diving ducks was high. The experimental cages used included three out of four different treatments; general predation (open cages), bird exclusion (net with mesh size 90*45mm) and no predation (net with mesh size 1*1mm).

Uppsalahem is the leading housing corporation in Uppsala with its over 160 real estate properties. Uppsalahem is owned by the municipality of Uppsala, which has a climate and energy goal that aims for 100 MW of solar energy to be installed in Uppsala by 2030. The 100 MW goal, combined with Uppsalahem?s environmental policy, is a strong incentive to investigate the possibility of installing PV modules on the many available roof areas that Uppsalahem possesses. The objective of this thesis is to create a foundation for future decisions regarding PV systems for Uppsalahem.

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

Abstract Semester and year: Spring, 2008Writers: Victor Andersson and Filip ForslundTutor: Thomas HelgessonProgram: Marketing program, Halmstad University - School of Business and EngineeringTitle: Differentiation from a consumer perspective - How important is differentiation from a consumer?s perspektive when choosing a residence? Presentation of problem: How important is differentiation from a consumer?s perspective when choosing a residence?Purpose: The purpose is on basis from previous theories on the subject to describe what kind of differentiating that from a consumerperspective is the most important when choosing a residence. Key words: Differentiation, brand, apartment market Methodology: This thesis is built on an qualitative method, where eight open individual interviews have been made. Our choice of respondents was based on what kind of respondents that could give us the most accurate information on the subject which we based on relevant variables. Theory: The framing of the theories is based on a marketing perspective within the area of differentiating and focuses on how companies use different tools to differentiate their offer to create competitive advantages.

Equality is a central aspect within development work. All development work is expected to be influenced by a gender equalty thinking, and these directions are distributed by the Department of Foreign Affairs, through Sida to Forum Syd and down to the very grasroot level, through Forum Syds local cooperation organisations. The essays question of research is a reflection over empowerment, with other words how international organisations influence other societies understanding of the society dynamics. This aspect triggered my interest for the subject, aswell as the link between aid, equality and men, and how these factors are in need of eachother. My study is mainly build on theoretical starting points, and not on earlier studies.