This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.

In this work, a method was developed and evaluated for calculating the life of welds under the influence of fatigue loads from a vibration environment. Typically, a shaker table is used for testing a component against vibration loads. The shaker table creates a vibration environment that is defined in the frequency domain by a power spectrum.Similarly, a virtual vibration table can be used to calculate the same type of load environment, which can then be used to calculate the expected lifetime. The benefit of this method is that it can be used in design, as well as in simulation of tests before physical verification tests are carried out.Today there are methods for calculating fatigue life of non-welded base material, but since many components contain welded joints, there is a need to apply this method to those types as well. To achieve this, the thesis combines two different areas, which together provide a method for fatigue assessment of welds using a virtual shaker table.The methodology is carried out by modeling the component, and its welded joints, in a finite element program.

The digital map product kNN-Sweden contains nationwide data of the country?s forest land. The estimated forest variables are mean age, mean tree height, volume per tree species and total volume. Today Södra Skog?s assessments of timber potentials are mainly based on experience rate and subjective assumptions.

Introduction: This study aimed to investigate the validity and reliability of the 20m multistage shuttle run test (MST) for elite ice hockey players as a predictor of the maximal aerobic capacity and the how the result is affected by the players age, aerobic and anaerobic capacity, body composition and test surface. The purpose of this was to find out the potential of the 20-m shuttle run test as a measuringtool for the maximal aerobic capacity in frequent testing periods during the season. It is very interesting to be able to administer this easily because the competative phase of the season is very long compared to the pre-seasonal phase and earlier studies have shown that the aerobic capacity is being lowered during this competative phase of the season for elite icehockey players.Methods: 34 elite ice hockey players participated in this study (20.0±3.6 yrs, BMI 24.2±1.6 and VO2-max 58.0±4.8 ml O2?kg-1?min-1). During 3-5 days they underwent 2 MST tests (wood and rubber surface), treadmill running with VO2-max assessed with open-circuit technique, Wingate10% and FFM-assessment with underwater-technique.

Titel:                                 Marknadsstrategi för lead generation: En studie om digitala marknadsstrategier och dess effekt på marknadsleadsNivå:                                 C-uppsats, kandidatexamen i FöretagsekonomiFörfattare:                        Anna Pettersen och Emma StåhlHandledare:                     PhD Agneta SundströmExaminator:                     PhD Lars-Johan ÅgeDatum:                             2014-JuniSyfte:                                Syftet med denna studie är att öka förståelsen för hur företag planerar, tillämpar och utvärderar strategier för digital marknadsföring med avsikt att generera leads.Metod:                              Flerfallstudien är av kvalitativ karaktär. Empirin samlades in genom en primär datainsamling av tio semistrukturerade intervjuer utförda på tio olika företag med verksamhet inom svenska IT-industrin. Genom ett rutnät har vi kodat och analyserat insamlad primär data för att finna teman och mönster som mynnade ut i en kärnkategori; Effekt.Resultat & slutsats:        Studien visar att de medverkande respondenterna anser att lead generation och digital marknadsföring är viktiga områden för deras företag. Respondenterna väljer att basera sin planering för marknadsstrategier på intuition och tillämpar strategier genom ?trial and error?.

Simulations of simulink models using Kalman filters are often very time-consuming. This problem depends mainly on the fact that the Kalman correction has to be performed at each sample instance through the whole simulation. The goal for this thesis work is to reduce that time-consumption for the filtering part (the integration partis treated in a complementary report) of a simulation. Furthermore a Matlab routine to perform parameter tuning and finally a graphical user interface is developed.The filtering part of the simulation in this thesis is based on an Extended Kalman Filter (EKF). The time optimization of this filter considers searching for the possibility to replace the today?s existing Matlab functions that is used to perform the filtering calculations.

Every plan and program decided on by an authority or municipality, where the environmental impact can be considerable, must be environmentally assessed according to Environmental Code, the Planning and Building Act (PBA) and the Regulation on Environmental Impact Assessment.The purpose of this study is to examine the Environmental Impact Assessment (EIA) for The Region Development Plan for the Stockholm Region, RUFS 2010. The plan was approved by at that time the Regional Planning Office (Regionplanekontoret), which procured the process by consultants. RUFS 2010 includes two merged plans ie. a regional Development Plan (RUP) and the Regional Spatial Plan for Stockholm. It was necessary to establish an environmental assessment of RUP, but not for the regional plan.

Sambandsanalys av surveydata kompliceras av förekomsten av slumpfel och metodeffekter i de avgivna svaren. Dessa felkällor kan leda till betydande över- eller underskattning av sambanden mellan undersökta variabler, och riskerar att leda till felaktiga slutsatser.En sedan länge känd metod för att estimera och kontrollera för slumpfel och metodeffekter i enkätdata är den så kallade Multitrait Multimethod-metoden (MTMM). Nackdelen med MTMM-metoden är att den kräver att varje fråga som ska analyseras ställs minst tre gånger i samma enkät, vilket gör att ansatsen i praktiken oftast inte är möjlig att tillämpa. Sedan 2012 finns dock ett verktyg, SQP 2.0, som gör det möjligt att skatta slumpfel och metodeffekter i enkätdata utan att genomföra MTMM-experiment. Den här uppsatsen utvärderar prediktionerna från SQP 2.0 på en enkät om arbetslivsrelaterade frågor besvarad av svenska och brittiska respondenter.

Every plan and program decided on by an authority or municipality, where the environmental impact can be considerable, must be environmentally assessed according to Environmental Code, the Planning and Building Act (PBA) and the Regulation on Environmental Impact Assessment.The purpose of this study is to examine the Environmental Impact Assessment (EIA) for The Region Development Plan for the Stockholm Region, RUFS 2010. The plan was approved by at that time the Regional Planning Office (Regionplanekontoret), which procured the process by consultants. RUFS 2010 includes two merged plans ie. a regional Development Plan (RUP) and the Regional Spatial Plan for Stockholm. It was necessary to establish an environmental assessment of RUP, but not for the regional plan.

This study was carried out at the request of the Swedish forest company Sveaskog which is an important producer of logging residues (branches and tops) intended for energy production. The company wanted to increase the average dry content to 60 percent in their delivered logging residues. At the time when this study was initiated, the dry content in the chipped logging residues originating from the Bergslagen district was at 52 percent. The aim of the study was to find out how windrows of logging residues could be arranged in order to help obtain desired properties such as increased dry content. Sveaskog had developed a system for evaluation of windrows and a standardized form was utilized to describe different properties of the windrows.

Background: Since the early 60?s, the CAPM or Capital Asset Pricing Model, has been an invaluable tool for assessing an asset's expected return, assuming that the asset is added to an already well-diversified portfolio of assets. CAPM theory assume that the unsystematic risk can be diversified and that the systematic, market-specific, risk is determined by the Beta value, from the Greek ?. An investor who takes big risks expect higher returns.One of the CAPM?s basic assumptions is that disruption in the market is not taken into account.

Every plan and program decided on by an authority or municipality, where the environmental impact can be considerable, must be environmentally assessed according to Environmental Code, the Planning and Building Act (PBA) and the Regulation on Environmental Impact Assessment.The purpose of this study is to examine the Environmental Impact Assessment (EIA) for The Region Development Plan for the Stockholm Region, RUFS 2010. The plan was approved by at that time the Regional Planning Office (Regionplanekontoret), which procured the process by consultants. RUFS 2010 includes two merged plans ie. a regional Development Plan (RUP) and the Regional Spatial Plan for Stockholm. It was necessary to establish an environmental assessment of RUP, but not for the regional plan.

When planning new wind farms, the cost for the internal electrical grid is estimated to account for 8-9 % of the total investment cost. On top of that, the cost for accumulated reduced income over several years (due to electrical losses), has to be added. The economic lifespan is relatively long (about 20 years) which means that an error in the loss calculation could lead to a bad decision basis. The accumulated reduced incomes due to electrical losses can be higher than the initial investment cost for the internal electrical grid.Today, Statkraft Sweden is using a template number when estimating the electrical losses in a wind farm. The actual losses are probably lower than the template number which could lead to an unnecessary high loss cost when planning a new wind farm.The aim of this M.Sc.

More than 90 % of all business activity in the world market consists of small and midsized companies today. Recent studies have shown that there has been an increase in small companies? certification to ISO's management standards. Smaller organizations tend to have more limited amounts of resources at their disposal than larger ones. This can result in difficulties during the implementation process of ISO 9001.

Storm water is rain and melted snow that runs off, primarily from impervious surfaces.Future storm water management is facing the challenges of increased precipitation, asclimate changes, and increased areas of impervious surfaces due to the expansion anddensification of the cities. Impervious surfaces reduce the potential for water to infiltratein the ground leading to increased surface runoff and higher peak discharge.The runoff coefficient is closely related to the percentage of impervious surfaces andrepresents the maximum percentage of a catchment that can contribute to runoff. In thisstudy, the objective was to evaluate the weighted runoff coefficient for three differenturban types; apartment buildings, townhouses and residential areas and a comparisonbetween today and the 1970`s was made.The runoff coefficient was determined by manual mapping of the different surface typesin each area based on data in the form of orthophotos and aerial photographs. The surfacetypes that were mapped were asphalt, permeable areas, tiles, sand/gravel and roof.Tiles and sand/gravel were the most difficult surface types to map. In order to see towhat extent these categories influenced the weighted runoff coefficient a sensitivityanalysis was carried out and the runoff coefficient based on surface type was changed indifferent scenarios.The results of the sensitivity analysis showed that the surface types tiles and sand/gravelhad little impact on the weighted runoff coefficient which in mainly due to the fact thatthe percentage of these surfaces types of the total area is small.The result of the study showed that the largest change in the runoff coefficient occurredin residential areas where the increase in the percentage of impervious surfaces causedby new roofs in the form of porches and garages and from paved or tiled driveways.